最大增溶濃度 的英文怎麼說

中文拼音 [zuìdàzēngróngnóngdù]
最大增溶濃度 英文
maximum additive concentration mac
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 濃 : 形容詞1. （液體或氣體中所含的某種成分多; 稠密） dense; thick; concentrated 2. （程度深） （of degree or extent） great; strong
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 濃度 : potency; thickness; concentration; consistence; strength; consistency; density
  1. With the increasing salt concentration, milk - clotting activity became higher and higher, then reached its peak, and then decreased gradually ; in the early extraction, the speed was quick, the milk - clotting activity was increased obviously. after it amounted to the maximum, the activity became steadily lower steadily ; the increasing temperature in extracting could improve the extraction activity, but too high temperature could result in the denaturation and inactivation ; the greater the ratio of abomasums and butter and was, the quicker speed was when the enzymes was drawn out, and after extracting for twice, most of the enzymes in the abomasums could be drawn out

    隨著食鹽濃度增大，凝乳活性逐漸提高，當達到一定濃度后，凝乳活性又逐漸降低；在提取初期，提取速度較快，凝乳活性明顯提高，當提取達到最大值后，凝乳活性又逐漸下降；隨著提取溫度的升高，凝乳活性逐漸增大，但溫度過高時，會導致酶變性失活；隨著提取液與皺胃比例的增大，酶溶出速度加快，提取次數越多，皺胃中酶提取越充分，提取2次后，皺胃中絕大部分酶被提出。
  2. The results of the uni - factor experiments and perpendicular experiments show their best mechanic synthesizing craft as followed : nvp ( 10 % wt ), kh570 ( 20 % wt ), hema ( 70 % wt ), initiator ( 0. 2 % wt ), crosslinker ( 20 % wt ), reacting 20 hours under 80 c. the factors which influenced organic silicon modified pvp hydrogel soft contact lens material ' s swelling capabilities were researched, which included temperature, monomer content, ion concentration etc. the experiments showed the equation swelling content ewc improved with the increase of nw, droped with the increase of kh570 and ion concentration, improved then droped with the raise of temperature, and hydrogels got the least ewc at 45 c. experiment carried on todiscuss water dehydration mechanism of organic silicon modified pvp hydrogel soft contact lens materials, which showed dehydration process could be divided into evaporating stage and diffusing stage

    正交實驗結果表明， nvp ? hema ? kh570共聚物的機械性能最佳時，其合成工藝條件為： nvp用量10 （質量百分含量，下同） ， kh570用量20 ， hema用量70 ，引發劑aibn用量0 . 2 ，交聯劑nmba用量0 . 2 ，反應溫度為80 ，反應時間16h 。討論了單體配比、溶脹溫度、離子濃度等因素對有機硅改性pvp水凝膠軟接觸透鏡材料溶脹性能的影響。實驗得出：水凝膠材料的平衡溶脹度ewc隨單體nvp含量的增加而增大， ewc隨kh570用量的增加而減小，隨離子濃度的增大而略微降低，隨溶脹溫度的升高先稍微下降後有所提高， 45時平衡含水量最低。
  3. Also, the author ’ s design strategy and creativity has been given in this paper. specifically, it includes : based on the feasibility analysis of the fit selection of control parameters in the aeration process, the aeration process of wastewater treatment of the joint - constructional complete - mixed activated sludge process has been aimed at in this paper. then, the state equations of the aeration process have been proposed in this paper, which is on the base of dissolved oxygen concentration ( do ) and discharge quantity of sludge ( qw ) as control variables, the concentration of bod and sludge as state variables. based on the present study on optimization control of wastewater treatment, the multivariable optimal control model with restriction factor has been presented in the paper with introducing modern control theory and system analysis into the field of activated sludge wastewater treatment,

    具體包括:以完全混合、表面曝氣合建式活性污泥工藝的污水處理曝氣過程為研究對象，在闡述了曝氣過程式控制制參數選取可行性的基礎上，建立了以溶解氧濃度do和活性污泥排放量qw為控制變量，以曝氣池中有機物濃度s和微生物濃度x為狀態變量的活性污泥曝氣過程的基本狀態方程;運用現代控制理論的觀點和污水處理理論，在現有關于污水處理最優控制問題研究的基礎上，建立了有約束條件多變量能耗最小數學模型，該數學模型是以有機物排放總量和狀態變量的末值條件作為約束條件，曝氣過程的能耗最小作為目標泛函;採用增廣拉格朗日乘子法對最優控制問題進行轉化，並對應用極大值原理求解能耗最小這一最優控制問題進行了詳細的解析;引入約束運算元，應用具有控制約束的共軛梯度演算法對能耗最小這一最優控制問題進行求解，並進行模擬實驗驗證。
  4. It ' s indicated that the zeta potential and total interaction energy of the colloidal particles are both at a maximum when the nitric acid concentration is 0. 22mol / l for the alumina sols with a mol ratio of 1 : 50 between asb and h2o,

    結果表明，膠體顆粒的雙電層厚度隨硝酸的濃度的增加不斷減小，對異丁醇鋁與水的摩爾比為1 ： 50系溶膠，硝酸濃度為0 . 22mol l時膠體顆粒的zeta電位和作用位能最大。
  5. The best compositions and contents of aot reverse microemulsion in the work were studied by measuring the maximum amount of solubilizing water in micelles from the abrupt change of electroconductivity

    本文根據電導率法測定體系的最大增溶水量，從而分別確定了在現有實驗條件下aot微乳液體系各組分的種類和相應的濃度范圍。
  6. The result showed that physiological response were mainly affected by concentration of peg and less affected by time of peg ( 6000 ) treatment. relative water content of leaves root activity, and growth of roots and plants showed a less reduction under 10 - 20 % peg ( 6000 ) treatment, but ratios of root cap, and contains of soluble sugar, contain of pro and potassium showed a less increase. all those just described indexes showed a marked change under 25 % peg treatment

    在10 20的peg濃度脅迫下，葉片相對含水量、根系活力、根系及地上部生長量下降的幅度較小；根冠比、可溶性糖、脯氨酸（ pro ） 、 k ~ +上升的幅度也較小，而在25的peg濃度脅迫下上述指標發生了很顯著的變化，葉片相對含水量、根系活力明顯下降，可溶性糖最大含量出現的時間較20濃度脅迫的提早3d ，且較20時的最大含量小，並在延長處理3d后又開始下降，根系和地上部的生長受到嚴重抑制，且地上部影響大於根系，根冠比顯著增大，脅迫後期趨于恆定狀態，生長幾乎完全停止。
  7. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
分享友人
分享到 Line

分享到臉書