最大拉力載荷 的英文怎麼說

中文拼音 [zuìdàlālìzǎihé]
最大拉力載荷 英文
maximum tensile load
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 拉 : 拉構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 荷 : 荷名詞（蓮） lotus
  • 拉力 : pulling; pulling force; thrust; traction; tension拉力表 draw bar [pull] dynamometer; 拉力測定儀 [...
  • 載荷 : load; loading載荷變化 load fluctuation; variation in load; 載荷裝置 load device
  1. Many survey data refer to mortal down load and sedimentation be produced due to the negative friction in pile foundation. the inequable sedimentation endanger the pile foundation greatly

    國內外一些實測資料表明樁基礎在使用階段負摩擦力可能產生非常大的下拉荷載和沉降，尤其產生的不均勻沉降對基礎危害最大。
  2. ( 2 ) the lateral deformation is effectively limited by reinforced earth layers and the settlement becomes small. @ the lateral deformation is enlarged on soft foundations, and the settlement becomes large. @ the reinforced earth layers on soft foundations behaves extension. the response behaviors of high sand - gravel embankment are indicated as the following : ? he amplification factor of earthquake acceleration varies with reinforced earth structure. ( 2 ) the basic frequency of the original embankments in different reinforcement conditions is about 0. 76hz. ? the amplitude of dynamic deformation appears small and the dynamic stability is safe

    研究表明：加筋土體能有效地限制路堤的側向位移發展，減小沉降變形量；軟基路堤的側向位移較大，將顯著地增大路堤的沉降變形；軟基上加筋土墊層中產生的拉應力最大；加筋砂礫土路堤在振動荷載作用下動變形反應較小，具有良好地動力穩定性。
  3. Regarding the rc beams subjected to concentrated load or even load and braced by bonding steel, an analysis is made on the relevant factors influencing maximum anchorage shear stress of steel sheet. the analysis is based on elastic theory and makes use of the formula for calculating anchorage shear stress of steel sheet. as indicated by the results, the maximum anchorage shear stress not only realtes to such parameters as height of cross section of rc beam and span but also relates to the thickness of adhesive layer, elastic modulus, thickness of steel sheet, and length of steel sheet. the present method will check maximum an chorage shear stress on the end of shear sheet so as to prevent rc beam from local damage. the present results will offer important reference for our country to further perfect bracing design by bonding steel method

    在彈性理論的基礎上，利用鋼板錨固剪應力計算公式，對在集中荷載或均布荷載作用下採用粘鋼加固的混凝土梁，分析鋼板錨固最大剪應力的有關影響因數.結果表明，最大錨固剪應力不但和混凝土梁的截面高度、跨度等參數有關，還和粘膠層厚度、彈性模量、鋼板厚度及鋼板長度有關.採用文中方法可以對鋼板端部最大錨固剪應力進行驗算，防止混凝土梁出現局部受拉破壞.研究結果為進一步完善我國粘鋼法加固設計提供重要的參考資料
  4. The checking methods of prestressed concrete penstock during construction stage are suggested. the formula is proposed to calculate the maximum distance of two consecutive strands to be result in uniformly distribution of concrete prestressed along the penstock

    提出了相鄰環預應力筋束的最大間距計算公式，確定了以混凝土抗裂為目標進行預應力筋束分步張拉施工與荷載控制的方法。
  5. Concrete filled steel tube ( cfst ) arch bridge is a new type of bridge which is widely applied in china recently, and it is a relatively ideal structural form for long span arch bridge. with the background of the practice of liantuo bridge, in the view of point of feasible in technology and reasonable in economy, the key techniques and difficulties in the construction of cfst arch bridge are analyzed and discussed in the thesis. the disadvantages in the current design and construction and the improvement method are also indicated

    本文以蓮沱特大橋工程實踐為背景，以主拱施工研究為主線，對鋼管混凝土拱橋重難點施工工藝，從技術上可行、經濟上合理的角度出發，詳細的進行了分析闡述，並指出了設計施工中存在的不足和今後需改進的方向；通過對鋼管混凝土拱橋施工過程中內力的計算，確定了拱肋施工最不利荷載工況下加載重量、壓重順序和張拉臨時預應力束等一系列施工措施，並將計算結果與現場監測觀測數據進行了比較分析，為今後進一步研究這類結構提供了參考。
  6. Taking the bending stiffness, cable sag and cable inclination into consideration, the space vibration control of the cables using the visco - elastic dampers in cable - stayed bridges is investigated by joining the center difference method and the state space strategy. both the maximum modal damping ration and the optimal damper size are obtained, then the practical suggestions are proposed for the design of the dampers. the space nonlinear vibration equations of the cable - damper system are derived, and a new hybrid method for solving the cable - damper system is presented by combing the newmark method and pseudo - force technology

    綜合考慮了拉索抗彎剛度、垂度的影響，研究了粘彈性阻尼器對斜拉橋拉索的空間振動控制，聯合中心差分方法及狀態空間法，得出了拉索麵內、外振動各階模態可能達到的最大阻尼比及相應的最優阻尼器系數，並對斜拉橋拉索的阻尼器設計提出了參考建議：考慮拉索抗彎剛度、垂度及幾何非線性，導出了索-阻尼器系統的空間振動非線性方程組，結合newmark方法及偽力（ pseudo - force ）方法，創新地提出了求解非線性方程組的雜交方法，根據拉索-阻尼器系統的阻尼特性，在各種荷載作用下，對索-阻尼器系統的非線性瞬態振動響應進行了研究，從系統響應的角度更加直接地驗證了阻尼器的控制效果。
  7. For three - short - pier shear wall under vertical loads, the results remain the same, and transfer beam at this moment will work with the middle pier, constituting a t - shape beam to sustain the moment and axial tensions together. 4. under the horizontal loads, the inner stress distribution in the frame supported short - pier shear wall shows similarities with that of the short - pier shear wall underneath the fastened supports

    4 、水平荷載作用下，框支短肢剪力墻墻肢內的應力分佈形式接近於下部固支的短肢剪力墻的應力分佈;轉換梁承受上部墻肢傳遞的拉力、剪力和彎矩，當短肢剪力墻墻肢數量較多時，轉換樑上、下邊緣拉、壓應力交替出現，剪應力的最大值處于洞口下方的轉換梁體內。
分享友人
分享到 Line

分享到臉書