最大最小 的英文怎麼說

中文拼音 [zuìdàzuìxiǎo]
最大最小 英文
maxminimum
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 小 : Ⅰ形容詞1 （體積、面積、數量、強度等不大） small; little; petty; minor 2 （年紀小的; 年幼的） youn...
  1. The basic thought of the csapfba algorithm is : the edge routers perform the state management per flow, and the edge routers differentiate between the marked flows and the non - marked flows, and the edge routers insert the relevant information into the packet header by using dynamic packet state ; the core routers divide the output link bandwidth into two parts in the light of the state information of the packet header by using class - based queueing, and the core routers allocate proportionally the bandwidth to the marked flows according to their service profiles and the current network load, and the core routers allocate the bandwidth to the non - marked flows according to the principle of max - min fairness, and the csapfba algorithm can adaptively dynamically adjust the bandwidth allocation between the marked flows and the non - marked flows

    本文在csfq演算法的基礎上，提出了一種核心無狀態的自適應的成比例公平帶寬分配csapfba （ core - statelessadaptiveproportionalfairbandwidthallocation ）演算法。 csapfba演算法的基本思想是：在邊界路由器完成基於每個流的狀態處理，將所有的流分成標記流和非標記流兩種類型，採用dps技術將有關信息編碼進分組頭；在核心路由器根據分組頭中攜帶的狀態信息採用cbq策略，將輸出鏈路帶寬分成兩部分，對標記流根據當前的網路負荷按照服務規格成比例地分配帶寬，對非標記流按照最大最小公平性原則分配帶寬，並且能自適應地動態調整帶寬分配的比例。
  2. The research fruits in this article can provide the temperature isoline map of crown cantilever section and central longitudinal section of the dam, the stress isoline map of crown cantilever section and upstream and downstream surfaces of the dam, the maximal and minimal stress distribution map in dam abutment along with the height of dam, the maximal and minimal stress table of typical nodes and the maximal and minimal stress table in different elevations, and also provide reference basis for taking relative temperature control measures in the design and construction of rcc arch dam

    本文研究成果可給出壩體的拱冠梁剖面和壩體中心縱剖面的溫度等值線圖、拱冠梁剖面和壩體上下游面應力等值線圖、壩肩最大最小應力沿壩高的分佈曲線、不同高程處典型點的最大最小應力值表以及不同高程處最大最小應力值表等成果，為碾壓混凝土拱壩的設計和施工中採取相應的溫控措施提供了參考依據。
  3. Results the numerical example shows that fuzzy relative entropy method and maximum - minimum closeness method have the same results for fuzzy pattern recognition

    結果數值例子說明模糊相對熵方法和最大最小貼近度方法得出了一致的模糊識別的結果。
  4. Meanwhile, it sets up the definition and calculation of fuzzy time parameter based on it. and it gives the new definition of fuzzy key liner, advances fuzzy sub - key line and the new algorithm about the new fuzzy key line

    在新提出的模糊最大（最小）定義的基礎上，定義了新的模糊關鍵路線，並提出了模糊次關鍵路線，提出了新的模糊關鍵路線計算方法。
  5. It can acquire the voltage on the test appliance and current in the circuit. and it can see these electrical signals as its input and calculates based on the data and gives the parameters and waveform that user needed. the parameters we can get through calculation include power factor, joule ' s integral, available value, maximal value, minimum value, time constant etc. recently, there are many scholar is studying the algorithm that calculate the parameter using test data, but many of them adopt the heuristic method, not using the test data directly

    本課題研製一套電器試驗參數高速採集系統，能夠檢測試驗迴路中試品上的電壓信號和迴路中的電流信號，並根據這些電信號的數值利用計算機進行在線計算，並給出用戶需要的各種電參數值和用戶需要的波形圖，通過計算得到的電器參數有功率因數、焦耳積分、有效值、最大最小值、時間常數等。
  6. Based on the analysis of designed cad graphics and the given parameters, computer can convert the cad graphics to a acdbpolyline which can simulate the routine of the conveyor chain. then by using the method of point - by - point strain calculation, computer could figure out each point ’ s strain of the chains under different load states, and get the results such as strain ’ s maximal and the minimal values and their positions, weight of the strain equipment and power of the drive electric - machinery that the conveyor need

    通過對設計的cad圖形和給定參數的分析，將輸送鏈運行軌跡轉化為一條可模擬輸送鏈軌跡的多義線，然後用逐點張力計演算法動態地計算出各種加載狀態下輸送鏈上各點的受力，得出最大、最小受力點的力的大小和位置，拉緊裝置的重量，驅動電機所需的功率等結果。
  7. The methods of direction finding mainly include maximum ( minimum ) signal method, amplitude - comparison method, phase - comparison method and time difference method

    測向的方法主要有最大（最小）信號法、比幅法、比相法、時差法。
  8. The meters provide a max and min reading memory with programmable capture time

    該計量儀配有最大最小讀數記憶，並且捕獲時間可以編程。
  9. Then an instance of vehicle routing problem ( vrp ) is put forward and solved to confirm their validity

    通過對蟻群演算法的改進和調整，構造出最大最小蟻群演算法，實例驗證該演算法能更快地收斂到全局最優解。
  10. The capture time is used to prevent detection of false max or min readings which may occur during start - up or unusual process events

    捕獲時間用於防止採集錯誤的最大最小讀數，這些讀數會出現在啟動或非正常處理過程中。
  11. The background is in charge of dealing with data, including digital filter, differential, the max, the min, drawing, and so on

    后臺機負責數據處理。包括數字濾波、求導、求最大最小值、畫圖、數據保存、圖形列印、圖形放大等。
  12. And in order to optimize space arrangement, a subjection function for the set of fuzzy objects and the set of fuzzy judgements is constructed and the optimal point is also formed adopting the maximal and minimal method

    並通過構造模糊目標集和模糊判決集的隸屬函數和採用最大最小法確定多目標最優點以實現對客船空間總布置的優化。
  13. By using the invariance of the max - min inequality preperty of jordan domain under quasiconformal mappings and the max - min inequality preperty of a disk, the papar proves that the quasidisk has the max - mm inequality property too

    摘要利用區域的最大最小不等式性質的擬共形不變性和圓的最大最小不等式性質，得到了擬圓的最大最小不等式性質。
  14. Relative to sde, the study for the solution of bsde under non - lipschitz condition is absence, especially when the uniqueness of the solution can not be guaranteed, the existence of minimal and maximal solution of bsde are not be studied

    相對于正向隨機微分方程，非lipschitz條件下倒向隨機微分方程解的性質的研究尚不夠豐富，特別是條件不能保證方程解唯一時，倒向隨機微分方程最大最小解的存在性尚未見有成果。
  15. It is reali zed that the invisible part of the object can be shadowed, using the max imum or minimum enveloping rectangle method and the counter of points of intersection method, etc. ( 3 ) the boolean operation between integrity or unintegrity bodys is supplied

    分析並討論了形體產生隱藏線、隱藏面的原因，利用了最大最小外包矩形法、交點記數法等，實現了任意形體的消隱演算法。 （ 3 ）完成了形體間的正則、非正則布爾運算。
  16. In chapter two, under non - lipschitz condition, the existence and uniqueness of the solution of the second kind of bsde is researched, based on it, the stability of the solution is proved ; in chapter three, under non - lipschitz condition, the comparison theorem of the solution of the second kind of bsde is proved and using the monotone iterative technique, the existence of minimal and maximal solution is constructively proved ; in chapter four, on the base of above results, we get some results of the second kind of bsde which partly decouple with sde ( fbsde ), which include that the solution of the bsde is continuous in the initial value of sde and the application to optimal control and dynamic programming. at the end of this section, the character of the corresponding utility function has been discussed, e. g monotonicity, concavity and risk aversion ; in chapter 5, for the first land of bsde, using the monotone iterative technique, the existence of minimal and maximal solution is proved and other characters and applications to utility function are studied

    首先，第二章在非lipschitz條件下，研究了第二類方程的解的存在唯一性問題，在此基礎上，又證明了解的穩定性；第三章在非lipschitz條件下，證明了第二類bsde解的比較定理，並在此基礎上，利用單調迭代的方法，構造性證明了最大、最小解的存在性；第四章在以上的一些理論基礎之上，得到了相應的與第二類倒向隨機微分方程耦合的正倒向隨機微分方程系統的一些結果，主要包括倒向隨機微分方程的解關于正向隨機微分方程的初值是具有連續性的，得到了最優控制和動態規劃的一些結果，在這一章的最後還討論了相應的效用函數的性質，如，效用函數的單調性、凹性以及風險規避性等;第五章，針對第一類倒向隨機微分方程，運用單調迭代方法，證明了最大和最小解的存在性，並研究了解的其它性質及在效用函數上的應用。
  17. And then chapter makes an analysis of the second substantive criterion of the procedural safeguard purpose which is based on the history of dispute settlement and theory of justice, the maximin rule founded by john rawls. chapter is about the positivist substantive criterion in accordance with the developing of social status

    其次，以羅爾斯的「社會正義理論」和「最大最小原則」為理論基礎，以糾紛解決方式的發展史為事實基礎論證了程序保障目的論的合理性，分析了實質標準之二? ?民事訴訟的目的。
  18. A 4 - digit display is optionally available for directly displaying the min max memory and tare functions, plus other parameters depending on the main display

    可選購的4位半的讀數儀表可以直接顯示最大，最小的記錄值和皮重功能，另外的參數顯示在主顯示屏。
  19. In order to analyse the stability of the slop of this area, the longmen apex was chosen as a typical slope

    為分析長白山天池地區斜坡穩定性，選取龍門峰作為典型斜坡，採用有限元法對其進行應力、位移模擬分析，繪制最大、最小主應力等值線圖。
  20. Verifying the soundness of the uml statecharts model can be translated into the verification of the soundness of the global reachable state transition diagram, and the algorithms verifying the soundness and the properties of semantic - related are given. at the aspect of verifying the consistency of temporal constraints of workflow, the time events are added into the uml statecharts, then the rules translating the extended uml statecharts into timed automata are given. the upper constraints ( the most time interval between two tasks ), lower constraints ( the least time interval between two tasks ) and deadline constraints are defined by tctl. the consistency of these constraints in build time, instantiation time and run - time are defined respectively

    在驗證工作流時序約束一致性方面，在uml狀態圖中加入了時間事件，給出了將擴展后的uml狀態圖轉化為時間自動機的規則，用時間計算樹邏輯定義了兩個任務間的最大、最小時間間隔（上、下界約束）和工作流的最終期限約束，並給出了這三類約束分別在創建階段、實例化階段和運行階段的一致性定義，通過alur的演算法對時序約束一致性進行驗證。
分享友人
分享到 Line

分享到臉書