最大燃燒壓力 的英文怎麼說

中文拼音 [zuìdàránshāoyālì]
最大燃燒壓力 英文
maximum combustion pressure
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  2. In this paper, firstly the macro parameter of the series connection app was comprehensively analyzed, among which the trajectory location of the bullet emission and the terminal velocity of the bullet were mainly analyzed, and the feasibility of the series connection app to cope with explosive reactive armor was demonstrated. and then the macro design about the head of the series connection app was made, among which a particular analyse about the bullet " s launching process was made, from which we concluded the relation between the thickness of the airproof loop and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the burning rate of the powder and the relation between the length of the bullet and the maximum pressure of the emission hole and the relation between the length of the bullet and the emitting time of the bullet, and the reasonable str ucture of the head of the carrier and bullet were designed, then the intensity of the head of the carrier was checked out using of the software of ansys

    本文首先對子母式穿甲彈總體參量作了全面的計算分析，其中主要分析了子彈射出的彈道位置和必要的子彈著靶速度，論證了子母式穿甲彈對付爆炸式反應裝甲的可行性，然後對子母式穿甲彈彈頭部進行了總體設計，其中主要對子彈的發射過程進行了詳細的分析，得出了母彈彈頭部發射孔內閉鎖環厚度與子彈飛離母彈速度的關系、子彈長度與子彈飛離母彈速度的關系、子彈長度與火藥燃燒率的關系、子彈長度與母彈彈頭部發射孔內最大壓力的關系以及子彈的長度與子彈發射所需時間的關系，設計出了合理的母彈彈頭部結構和子彈的結構，並利用ansys有限元分析軟體對母彈彈頭部的強度進行了校核。
  3. And the experimental results indicated that the pressure fluctuant of cng engine was less than gasoline engine

    通過比較各缸最大壓力的變動系數，表明燃燒天然氣的循環間波動小於燃燒汽油。
  4. The comparisons of combustion and fluctuant among each cylinder were made using the averaged value of the max pressure and the fluctuant coefficient of the max pressure

    使用各缸最大燃燒壓力的平均值和變動系數比較了各缸的工作情況和循環間變動。
  5. It ' s the first time to explore the combustion characteristics of lpg / diesel mixing fuel engine, and find that, with the change of load and rotation, the changing trend of the ignition delay period of e10 mixing fuel is almost as identical as that of the diesel, but that of e30 mixing fuel is very different. comparing with diesel, the combustion of e10 is improved slightly, but that of e30 greatly changes ; the maximum eruptive pressure decreases ; the maximum pressure increase rate decreases ; the highest releasing heat rate increases ; the highest combustion temperature falls ; the ignition delay period extends

    結果表明: e10混合燃料與柴油的著火滯燃期隨負荷和轉速的變化趨勢基本一致; e30混合燃料與柴油則有所不同; eio混合燃料發動機的燃燒與純柴油相比，略有改善; e30混合燃料的燃燒特性發生明顯的變化，最高爆發壓力下降，最大壓力升高率減小，最大燃燒放熱率增大，最高燃燒溫度下降，滯燃期延長。
  6. A new calculation method for optimizing diesel engine performance, called nonlinear regression - mess method, is put forward. in this paper, 25 groups of simulated values are calculated from the diesel engine working model, specific fuel consumption, peak pressure, rate of pressure rise, nox and peak temperature are fitted into explicit function about compression ratio and fuel injection advance angle

    本文利用柴油機工作過程模型，得出25組模擬計算數據，利用非線性回歸將油耗、最大爆發壓力、壓力升高率、 no _ x濃度及最高燃燒溫度擬合成壓縮比和噴油提前角的顯函數，並用網格法進行優化，用c語言編制了優化計算程序，得出最佳的壓縮比和噴油提前角，使其優化匹配。
  7. Heating boilers - heating boilers with forced draught burners - heating boilers with forced draught burners - special requirements for boilers with forced draught oil burners with outputs up to 70 kw and a maximum operating pressure of 3 bar - terminology, special requirements, testing and marking

    供暖鍋爐.帶強制通風燃燒器的供暖鍋爐.最大操作壓力3巴最高輸出達70kw的帶強制通風燃油器的鍋爐的特殊要求.術語特殊要求試驗和標記
  8. Giving some suggestions to develop the fuel according to the experiment result. the final experiment result is very good. after using alcohol - blended diesel oil in diesel engine, the power can be achieved, the let of contamination is reduced, thermal efficiency enhanced, the exhaust degree and the max combustion pressure is steady

    對理論和實驗結論進行總結，對課題的發展提出建議實驗的最終數據證明：在柴油機上燃用乙醇柴油后，能夠達到原機的功率，並且柴油機的排放狀況有很大的改善，熱效率有一定的提高，排氣溫度和最高燃燒壓力基本不變，實驗結果是比較理想的，可以考慮在實際中應用和推廣乙醇柴油。
  9. The disposal of the valves and intake manifold structure not only affect fresh air charge but airflow in the cylinder, which immediately affect combustion efficiency and the performance of dynamic, economic and emission. the structure of the air distributing institution has influence on charging efficiency and the noise of engine. the combustion chamber affects compression scale which has great influence on dynamical performance ; f / v which affects the exhaust of hc ; squash area and clearance which have great influence on the intensity of squash

    氣缸蓋的氣門排列方式與氣道結構形式影響進氣充量和氣流在氣缸內的運動，從而影響了燃燒效率，對整機的動力性、經濟性以及排放都有直接的影響；配氣機構的形式影響充氣系數和整機噪聲等；缸蓋燃燒室決定了影響整機動力性能的壓縮比，影響hc排放的f / v和對擠流起決定性作用的擠氣面積以及擠氣間隙，所以燃燒室對整機動力性、經濟性、排放等都有重要的影響；氣缸蓋是整機熱負荷與熱應力最大的部件之一，熱負荷過高將不利於發動機壽命以及可靠性的提高。
  10. The experimental results indicates that the secondary mass flow increases with increasing of primary mass flow rate, but the bypass decrease because the primary mass flow rate increase more rapidly than secondary mass flow. the expansion configuration shows low thrust property due to low pressure in flow path. the secondary nozzle changes the pressure distribution in ejector combustor, and decreases bypass ratio, but obtain more completely mixing

    結果表明：二次流流量隨著一次流流量的增加而增加，由於二次流流量的增加速度低於一次流，引射系數減小；在純擴張式結構實驗中，引射燃燒室壓強很低，難以實驗推力增強；二次噴管改變了引射燃燒室的壓強分佈，降低了引射系數，改善了混合狀況能；對于本文的實驗結構，存在一個最優的二次噴管出口面積，使引射火箭推力最大，同數值模擬結果相吻合。
  11. Maximum combustion pressure

    最大燃燒壓力
  12. A parametric study of the effect of variation in injection timing is then carried out. both the simulation results and experimental data show that deferred injection timing leads to decreases in combustion pressure and nox concentration

    模擬結果和實驗結果都表明，推遲噴油，可以減少預混燃燒所佔的比例，降低最大燃燒壓力，從而減少直噴式柴油機的no _ x排放。
  13. The results indicate that with decrease of exit area of secondary nozzle, the bypass ratio is decreasing, and the static pressure in integrated ejector combustor is increasing, and mixing condition becomes better. there exists an optimal exit area of secondary nozzle to get maximum thrust of rocket ejector

    結果表明：引射能力隨著二次噴管出口面積的減小而減小；整體式引射燃燒室壓強隨著二次噴管出口面積的減小而上升，混合隨之更為充分；存在一個最優的二次噴管出口面積，使發動機推力最大。
  14. Under this background, we successfully developed an engine fuelled with coal - bed gas and ignited by spark plug. the measurements for the prototype engine were thoroughly made, including the cylinder pressure, the rate of heat release, combustion duration, ignition delays, spark ignition angle, and the fluctuation of the cylinder maximum pressure

    在此背景下，本文對經由s195柴油機改裝得到的燃用變組分煤層氣發動機進行了全面的測試和分析，包括缸內示功圖、燃燒放熱率、主燃期、點火提前角、火焰發展期以及最大壓力循環波動等。
  15. Heating boilers. part 4 : heating boilers with forced draught burners. special requirements for boilers with forced draught oil burners with outputs up to 70 kw and a maximum operating pressure of 3 bar. terminology, special requirements, testing and marking

    供暖鍋爐.第4部分:有強制送風燃燒器的供暖鍋爐.輸出功率在70kw以下最大工作壓力為3巴的帶強制通風燃燒器的供暖鍋爐的特定要求.術語特定要求試驗和標記
分享友人
分享到 Line

分享到臉書