最大能力 的英文怎麼說

中文拼音 [zuìdànénglì]
最大能力 英文
maximum capacity
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 能 : 能名詞（姓氏） a surname
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 能力 : ability; capacity; capability
  1. Chapter n analyzes the present urban gas civil use in wisco, and points out that the major problems are miscalculation of fluctuating needs of users, rigid maximum production, excess reserve, and redundant pipe net transport. all these lead to the conclusion that urban gas which transcends the users needs has increased purification and transport cost

    第二章，分析了武鋼民用煤氣輸配系統的現狀，對用戶動態需求估計不準，按照最大能力組織生產，儲備能力過剩，管網輸送能力富餘；指出了現行生產工藝中存在的問題，超出用戶需求的煤氣增加了凈化成本和輸送成本。
  2. The cabbage wue ( 204. 4kg / hm2. mm ) was highest in all the vegetables, instead frijole wue was only 28. 8kg / hm2. mm and less than other vegetables. lastly, this paper estimated the potential of water saving : 1. by reducing the abundant irrigation, about 0. 4 - 0. 5 million m3 water can be saved ; 2

    論文對種植業系統節水潛力做了初步探討認為： 1 ）減少過量灌溉水量，能節約水資源0 . 4 0 . 5億m ~ 3 ； 2 ）非充分灌溉技術能節約灌溉水量10左右； 3 ）改進灌溉工程技術，最大能節約灌溉水量10左右。
  3. The effect of reynolds number on rudder hydrodynamic performance is also analyzed. up to the stall angle the computed lift and drag agree well with measurements and other author ' s calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under - predicted. the solver is used to investigate laminar and turbulent separated flows around a 6 : 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces

    應用所開發的求解器，以naca0015翼型舵為算例計算了船舵在不同雷諾武漢理三;大學博士學位論文數下大舵角范圍內的三維粘性流場及水動力，成功地預報了舵的失速角和最大升力，並初步探討了雷諾數對舵水動力的影響;計算結果與現有試驗和計算數據比較，吻合程度相當好，初步檢驗和驗證了該求解器精確模擬粘性流動和計算水動力的能力。
  4. The main research is below : ( 1 ) the influence to intensity and rigid with corner angle ( 60, 75 and 90 degree ) of crack and the board axes ( 2 ) do a fem stress / strain and crack growth simulation analysis when the corner angle of crack and the board axes is 60 degree ( 3 ) do a intensity resume analysis for the structure which is repaired with a titanium patch in a mechanical way when the corner angle of crack and the board axes is 60 degree through simulation analysis for three failure criterion, we have : ( 1 ) in 60, damage extend quickly with damage analysis in hashin criterion ; it is slower for analysis in maximum stress or hashin - rotem criterion. ( 2 ) in special term ( physical condition incision, shape or maximum load ) the compression strength of the stiffened plate will decline 45 % ~ 50 % under compression loads

    通過採用三個不同損傷判據的數值模擬模擬，得到如下結論： （ 1 ）在60時，用hashin判據進行的損傷分析，損傷擴展較快；最大應力及hashin - rotem判據進行的損傷分析，損傷擴展基本相當，且較慢； （ 2 ）在所給加筋板的物理條件、切口大小及形狀、最大載荷等一定的條件下，該加筋板在壓縮載荷作用下，其壓縮強度下降了45 50 ； （ 3 ）在本文提及到的機械連接修理方法以及載荷條件下，修理后的結構強度恢復能夠滿足戰時要求。
  5. Quality. this determines how much effectiveness the unit loses due to combat, how quickly it regains it afterwards, and its maximum effectiveness

    質量。決定了效力在戰斗中的損失程度以及恢復能力，同時也決定了最大效力值。
  6. In this paper, pro / engineer is used to creat the model of wheel which is according with gb / t3487 - 1996. then the model is submitted to ansys where it is dealed with and loaded according as the prescribe in the fatigue experiment of gb / t3487 - 1996 and is analyzed in intension. the result shows the maximal stress is much less than the breaking point of aluminium alloy, which makes material wasted

    本文使用pro / engineer軟體，按照輪輞的國家標準，建構車輪的實體模型；然後把模型導入ansys ，按1997年中國汽車行業標準中的汽車輕合金車輪的性能要求和實驗方法所規定的疲勞實驗要求施加荷載；然後進行強度分析，分析結果表明，車輪的最大應力遠小於鋁合金的許用應力，存在進一步優化的可能和必要。
  7. When times get tough, there's no choice except to take a deep breath, carry on, and do the best you can.

    在艱難的時勢下，沒有別的法子，你只能憋著一口氣幹下去，盡自己的最大努力。
  8. The results proved that : ( 1 ) because of the material ' s difference of primer - 9 and primer - 5, the maximum stress of primer - 5 is larger than primer - 9 but the maximum displacement is smaller than primer - 9. ( 2 ) because of the unrenewable shape changing of primer - 9 after impacting by the pin, it will cracking under high pressure more easily. so, the paper give the suggestion that the designer should decrease the depth of impacting by pin in the case of the primer be fired successfully

    對底- 9底火、底部被擊針撞擊后的第- 9底火和底- 5底火在膛壓作用下分別進行了有限元數值分析，計算表明： （ 1 ）底- 5底火底部擊針撞擊部位為火帽座，其材料為鋼帶，底- 9底部承受撞擊部位為底火體，其材料為冷拉退火圓鋼，由於材料強度不同，承受壓力能力和變形能力不同：雖然在膛壓作用過程中底- 5底火的最大應力值比底- 9底火的大，但底- 5底火的最大位移量卻比底- 9底火的小得多。
  9. The first part concerned the self - conceptions of competence in the field of children ' s physical exercise. it was made up of three experiments : experiment i used bandura ' s classical pattern of the measurement of self - efficacy for reference. before and after the children ' s three trial jumps respectively, they were asked to assess their abilities to fulfill a series of tasks of standing long jumps from easy to difficult

    第一部分是幼兒身體運動領域能力自我知覺的研究，由三個實驗組成：實驗一借鑒bandura自我效能測量的經典模式，在幼兒三次集中試跳之前、之後，分別讓幼兒就自己在完成從易到難的一系列立定跳遠任務上的能力及把握程度做判斷，並在其後再對自己最大能力分別做一個單項目的總的判斷，比較試前泛化經驗和試后即時直接經驗對幼兒能力知覺的影響作用，並對比單項目判斷和多項目判斷對幼兒能力自我知覺的反映情況。
  10. The conclusion of reappearing analysis is that crane bridge be used as usual because main weld maximum stress of upper cover plate of main beam lower than yield limit though it higher than permissible stress. inner stress of secondary beam was over ultimate strength, and deforming is ultra big. so it was unfit for produce and secondary beam must be changed

    再現分析得出的主要結論為：橋架的主樑上蓋板主焊縫的最大應力超過了許用應力，但小於屈服極限，可以繼續投入使用；副梁內部的應力遠遠超過了強度極限，變形特別嚴重，不能滿足生產要求，因此更換新的副梁；端梁內部的應力超過了屈服極限，小於強度極限，在應力較大的位置焊接補強板；投入使用后，要對整個橋架進行定期檢查。
  11. Although the flux per revolution of the optimized pumps is a little smaller than that of tatsuno combined pumps, other characteristics, such as fluctuation rate, maximum pressure angle and velocity fluctuation rate etc, are much better. the methods to cut gears are proposed in the theory for the practical produce in the future

    雖然，在體積相等的條件下，優化出來的外圓弧包絡線內嚙合齒輪泵的排量略小於tatsuno組合泵的排量，但其它性能（如：流量脈動率、最大壓力角、速度波動量）都更優。
  12. The result and discussion show three conclusions. 1. sternoclavicular joint should berd backward as best as the subject can, 2. the best finish effect can be obtained when both hands lift behind and parallel the ground, 3. the rotation angle of the trunk should be within go degrees under the circumstance of hands lifting behind and paralleling the ground

    經由結果討論得知，受試者在沖線時，一、頸關節應盡最大能力向後彎曲，二、雙手向後擺置成與地面平行時，具有最佳的沖線效益，三、軀干扭轉時，在不影響雙手后擺成與地面平行的情況下，以不超過90度為范圍。
  13. Students should do their utmost to study well

    學生們應盡最大能力去把學習搞好
  14. The article advanced technology schemes on cooperation of heating and power and cooling of natural gas in one residential area of nanjing, schemes choose three different equipment unit, and fix on design index base on the actual demand of cold and heat and most capability of gas turbine of two scheme, the article analysis on technical and economic performance, comparison of technical and economic performance on different equipment unit and different scheme

    摘要針對南京某一居民小區，進行了天然氣熱電冷聯產方案設計，選取了3套熱力設備，並按實際冷熱需求和燃機最大能力兩種設計方法確定了設計指標，進行了技術經濟性能的計算和分析，對比不同熱力設備的技術經濟性能和各方案的優缺點。
  15. He was doing his utmost to please her

    他在盡最大能力去取悅她
  16. For maximum reliability, the glycol should be replaced every few years

    最大能力，乙二醇每幾年要更換。
  17. They followed their own internal truth to the best of their ability

    他們就是以最大能力跟隨自己內在的真相。
  18. I did my best to follow his advice and in a comparatively short time i realized within myself the truth of his teaching

    我盡我最大能力如此去做，並在較短時間內領悟到他的教導。
  19. Jt : i ' d give myself eight or nine out of ten. i think i raced well and qualified very well and always did my maximum out of the car as well

    雅諾：十分中，我給自己打8或9分，我比賽不錯，排位非常好，經常能發揮車子的最大能力。
  20. It is equally critical to give them the practical tools necessary to analyze their situation and ensure that all children are in school and learning to their fullest capacity as well as ensuring equity in the classroom

    同樣重要的是應給予他們一些必需的實用工具，以確保課堂上的平等，分析自己處境與確保所有孩子都到校並盡自己最大能力學習。
分享友人
分享到 Line

分享到臉書