最大電流 的英文怎麼說

中文拼音 [zuìdàdiànliú]
最大電流 英文
max current/current draw/maximum current
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Ih = hold current - maximum current at which the device will not trip at 23 still air

    維持電流，指在23度靜止的空氣環境中不會導致該設備『跳閘』的最大電流。
  2. The directly application of superconductor is great electric current with nonresistant transmition and the uniquely application is the superconducting electronics which is based on josephson effect

    超導體最直接的應用是無電阻傳輸大電流，最神奇的部分則是以約瑟夫森效應為基礎的超導電子學技術。
  3. The results show that : nano - nickel powder is not useful for mh electrode during the high rate discharge phase as a conductor or additive ; superfine nickel powder is applicable for the conductor of the negative because of the good performance especially the cyclic stability at 1c rate by using 5 % ( mass percentage ) nickel powder ; the utilization of alloy, specific mass and volume capacity are increased with the decreased particle size of nickel powder in negative, however, the capacity fading rate at 1c discharge rate is also increased, so the capacity and the cyclic stability should be taken into account to make a choice of the particle size

    結果表明： mh電極中加入納米鎳粉對負極的大電流放電性能不利。 mh電極中加入超細鎳粉后電極綜合性能好，尤其是1c循環穩定性，其最佳添加量為5wt 。減小鎳粉粒度提高了電極合金利用率、質量比容量、體積比容量，但增大了負極1c容量衰減率，因此鎳粉粒度的選擇應綜合考慮mh電極容量和循環穩定性。
  4. Railway rolling stock. magneto - thermic microcircuit - breakers for maximum current for controls and auxiliaries circuits. dimension

    鐵路機車車輛.控制裝置和輔助線路用最大電流熱磁電機微電路斷電器.尺寸
  5. Railway rolling stock. magneto - thermic microcircuit - breakers for maximum current for controls and auxiliaries circuits. generalities and tests

    鐵路車輛.控制和輔助線路用最大電流熱磁電機微型電路斷路器.一般原則和試驗
  6. This paper discusses the ability of avoiding maximal power flow of quadrilateral impedance relay and round impedance relay in detail and puts forward the setting principle and setting method of load limiting resistor of backup distance protection

    本文對四邊形和方向圓特性阻抗繼電器躲線路最大潮流的能力進行了詳細分析，提出了距離保護負荷限制電阻的整定原則和整定方法。
  7. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究，內容包括： （ 1 ）本文採用有限長行波面電流作用於有限長鐵芯上的模型，引用了氣隙磁場一維解，研究了單層繞組磁場，奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較，簡單介紹了二維解； （ 2 ）用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析，並分析了結果； （ 3 ）用軟體進行了額定電壓下的瞬態分析，得到了轉矩，位移，轉速隨時間變化曲線圖，利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較，採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證，由實驗測得了三相電流波形，並與計算結果進行了比較，對其不對稱性進行了定性分析。
  8. Electromechanical switches for use in electronic equipment - part 4 : sectional specification for lever toggle switches - section 2 : detail specification for one pole, two pole, four pole, sealed lever toggle switches, 277 v a. c. maximum, 30 v d. c. maximum, 20 a maximum electrical rating

    電子設備用機電式開關.第4部分:杠桿操縱撥動開關的分規范.第2節:最大交流電壓為227伏最大直流電壓為30伏最大電流為20安培的額定電功率，一極二極四極密封杠桿操作撥動開關詳細規范
  9. This is the maximum output source or sink current that can flow safely into an output terminal of the device at voltages within the normal operating range

    持續輸出電流是指器件的輸出端可以安全地注入或泵出的最大電流。
  10. Railway rolling stock. magneto - thermic microcircuit - breakers for maximum current for controls and auxiliairies circuits. collection of particulfar leaves

    鐵路機車車輛.控制裝置和輔助線路用最大電流熱磁電機微型電路斷電器.特殊簧片總成
  11. P. s. ： the power supply shall be tested at max. ac voltage ( 264vac ) and min

    應該在最大交流輸入電壓264伏和輕載、空載下測試。
  12. Requirements for maximum voltage, current, and power levels in network - powered transport system

    網路電力傳輸系統的最大電壓電流和功率級的要求
  13. According to the energy conservation, the maximum electron efficiency is evaluated either with or without the relativistic effect. the result shows that the efficiency to translate the energy from dc field to rf field will increase with the increase of input voltage to some degree

    最後，我們從能量的觀點出發推導出milo的最大電子效率及相對論效應對電子效率的影響，得到的結果表明在一定程度上提高輸入電壓可以提高電子將直流場能轉換為交流場能的效率。
  14. This is the maximum current that can flow safely into an input terminal of the device at voltages above or below the normal operating range

    在器件電壓高於或低於正常工作電壓原范圍內，可以安全地流入器件輸入端的最大電流。
  15. It = trip current - minimum current at which the device will always trip at 23 still air

    維持電流，指在23度靜止的空氣環境中不會導致該設備『跳閘』的最大電流。
  16. Experimental sample dct375 with collector - combed structure has better parameter such as icm, pq, pd and / r etc. than traditional - structure devices and overseas devices of the same kind. collector - combed structure technology opens up a new way for the further research of new high - frequency, microwave power devices

    研製出的梳狀集電結（基區）結構試驗管dct375 ，其最大電流容量、最大輸出功率、最大耗散功率以及頻率特性等電參數明顯比傳統結構器件和國外同類產品有大的提高。
  17. Electromechanical switches for use in electronic equipment - part 6 : sectional specification for sensitive switches - section 2 : detail specification for one pole, unsealed subminiature sensitive switches, 250 v maximum, 5 a maximum electrical rating

    電子設備用的機電開關.第6部分:敏感開關分規范.第2節:額定最大電壓250v ，最大電流5a的單級不密封超小型開關的詳細規范
  18. The iik absolute maximum rating specifies the maximum current that may be put through the ground - clamp diode

    輸入箝位電流iik規定了流過接地箝位二極體的最大電流的絕對最大額定值。
  19. The maximum current allowed to flow through each tube is set by the drive - control settings, and is a service / factory level setting

    流過每隻管子的最大電流是由驅動控制電路的參數設定的，只有工廠或維修人員才可調整。
  20. On the same winding, at most three taps can be made to form four transformer ratios, but the difference between maximum current and minimum current should not exceed one time ( for example : 150 - 200 - 250 - 300 / 5a )

    在同一個繞組上最多可三次抽頭，組成四變比，但最大電流與最小電流相差不能超過一倍（如： 150 - 200 - 250 - 300 / 5a ） 。
分享友人
分享到 Line

分享到臉書