最短試驗時間 的英文怎麼說

中文拼音 [zuìduǎnshìyànshíjiān]
最短試驗時間 英文
minimum test duration
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 短 : Ⅰ形容詞（空間、時間兩端之間的距離小） short; brief Ⅱ動詞（缺少; 欠） lack; owe Ⅲ名詞1 （缺點） we...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 試驗 : trial; experiment; test
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. Abstract : the paper analyzes the wear resistance and anti - adhesion of 20 and 45 steel formed in austenitic ion - nitrocarburising and comparisons to the general ion - nitrocarburising. the experiment shows that austenitization - nitrocarburising can be carried out at 590 700, its wear resistance and anti - adhesion is the best at 630 ， the worst at 660 and anti - adhesion is the best at 630 ， the worst at 660 and the mediate at 570 600. with the help of raising processing temperature properly and speeding up the process the wear behavior can be improved

    文摘:研究20鋼、 45鋼經奧氏體離子氮碳共滲后的耐磨性和抗咬合性，並與普通離子氮碳共滲后的作了比較，試驗表明:在570 700范圍內進行離子氮碳共滲后，其耐磨性和抗咬合性以630處理時為最佳， 660處理時最差，而570 600處理時則介於兩者之間，通過適當提高共滲溫度，再提高滲速，從而縮短共滲時間的同時，可以提高耐磨損性能。
  2. Revolved round the sun by the test and adjusted to the best working state compared with rotational speed of the autobiography, according to different supplies grain size, different supplies performance, can in short time ( 1 ~ 5 hours ) process the supplies into the ultra thin powder inside ( 1 ~ 5 micron )

    （三）經試驗公轉與自傳轉速比調整到最佳工作狀態，根據不同物料粒度、各異的物料性能，能在較短時間（ 1 ~ 5小時）內把物料加工成超細粉（ 1 ~ 5微米） 。
  3. It is divided into four parts to illustrate the environmental tests management system, including organization structure & labor source management system, tests process management & controlling system, tests information management system and quality guarantee system. firstly, it begins from organization structure of environmental tests, to look into the suitable organization structure, which applies to the environmental tests development, this thesis suggests the changing from original beeline organization structure to combinative organization structure of beeline function & matrix organization structure. it also investigates the labor source management and discusses under this new structure, presenting the system which meets the demand of existent military equipment development ; then, using relative concepts of queuing theory to solving the tests orders reasonably makes the minimum time for products in lab

    首先從環境試驗的組織結構入手，研究適合環境試驗發展的組織結構，提出將原來的直線制組織結構轉變為直線職能制和矩陣制相結合的組織結構，並探討在這種結構下的人力資源管理和績效考評、提出適應目前軍用裝備發展要求的環境試驗組織機構與人力資源管理體系；然後從環境試驗過程管理的角度出發，運用排隊論的有關概念，合理解決試驗排序，使產品在實驗室的停留時間最短，並建立試驗過程管理與控制體系；從試驗信息的重要性角度出發，探討試驗信息收集與反饋的一般方法及建立環境試驗數據信息庫的重要性；最後從質量管理的角度出發，研究環境試驗內部質量保證部門的作用與職能，運用服務質量環的原理構建了環境試驗的質量保證體系。
  4. The results indicate that drying thickness, radiant temperature and pressure of drying chamber are the most three significant factors. there ' s hardly any relationship between freezing rate and drying time, the sublimation drying time of slow freezing material is shorter than quick freezing one, but its desorption drying time is relatively longer, so the total drying time is approximately the same. the initial freezing temperature and freezing manner has little influence on vacuum freeze drying process

    試驗表明：凍干厚度、加熱板溫度、系統的真空度是最重要的三個過程參數；凍結速率對總凍干時間沒有影響，慢凍物料的升華乾燥時間要比快凍物料短，但慢凍的解析時間相對較長，兩者的總凍干時間相差很小；初始凍結溫度對凍干過程的影響可以忽略。
  5. The optimum conditions of preparation were as fellows : the concentration of zinc sulfate solution of 1. 8 - 2. omol / l, the concentration of ammonium bicarbonate solution of 1. 4 ~ 1. 6mol / l, the time of ultrasonic radiation of 25 ~ 30min. iv. preparation of active zinc oxide by means of microwave radiation to calcine precursor of basic zinc carbonate firstly, and a mechanism on preparation of ultra - fine active zinc oxide by means of microwave radiation has been investigated emphatically as well as the effects on quality of ultra - fine active zinc oxide have been analyzed and discussed in detail, the time of microwave radiation was 7 ~ 16 min ; comparing microwave radiation calcining with conventional calcining, the calcining time of microwave radiation was one thirty to one twenty, the calcining time shortened hugely, energy consumption saved hugely, the quality of product improved

    首次引入超聲波輻射制備超細活性氧化鋅前驅體堿式碳酸鋅新技術，研究了超聲波輻射制備前驅體堿式碳酸鋅的機理，並分析和討論了影響前驅體質量的各種因素，確定了最佳的前驅體制備條件為：硫酸鋅濃度為1 . 8 2 . 0mol / l ，碳酸氫銨的濃度為1 . 4 1 . 6mol / l ，超聲波輻射25 30min ； 4 、首次採用微波加熱煅燒前驅體堿式碳酸鋅制備超細活性氧化鋅的新技術，研究了微波輻射加熱煅燒前驅體制備超細活性氧化鋅的機理，並分析和討論了影響活性氧化鋅質量的各種因素，確定了最佳的超細活性氧化鋅制備條件為：微波加熱煅燒時間為7 16min ，與傳統煅燒方法相比，煅燒時間僅為傳統的1 30 1 20 ，大大縮短煅燒時間，節省能耗，提高了煅燒產品的質量； 5 、完成了從鋅浮渣中制備超細活性氧化鋅的小試試驗和擴大試驗。
  6. The experiment ' s results show that the system is stable under the static pressure control and energy saving under the minimum total supply air volume control. although the terminal dampers ' s tuning time is prolonged under the minimum total supply air volume control, it can be reduced by adopting the appropriate sampling time when debugging the system. from all of this we can conclude thart the minimum total supply air volume control has a good application perspective

    實驗結果表明，定靜壓控制方式下系統較為穩定，最小總送風量控制比定靜壓更加節能，但它延長了末端閥位的調節時間，在系統調試時，我們可通過選擇合適的采樣時間來縮短閥門的調節過程，所以最小總送風量控制具有廣闊的應用前景。
  7. Both theoretical study and simulation show that, this p2p based crl distribution sheme can largely reduce the distribution time

    理論分析和模擬試驗均表明，這一方法大大縮短了crl分發的時間，接近理論的最優值。
  8. Testing of glass fibre reinforced plastics pipes ; determination of initial and long - term ring stiffness

    玻璃纖維增強塑料管試驗.管子短時間和長時間最大壓力
分享友人
分享到 Line

分享到臉書