最短距離 的英文怎麼說

中文拼音 [zuìduǎnjùlí]
最短距離 英文
bee line
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 短 : Ⅰ形容詞（空間、時間兩端之間的距離小） short; brief Ⅱ動詞（缺少; 欠） lack; owe Ⅲ名詞1 （缺點） we...
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 短距離 : short distance短距離放射治療 [醫學] brachytherapy; 短距離賽跑 short distance run; dash; sprint; ...
  • 短距 : short pitch
  1. Total indicator reading ( tir ) - the smallest distance between planes on the surface of the wafer

    總計指示劑數（ tir ） -晶圓片表面位面間的最短距離。
  2. Gimli : i am wasted on cross - county. we dwarves are natural sprinters. very dangerous over short distances

    長途跋涉我最不在行了。我們矮人族是天生的短跑健將。短距離內爆發力十足。
  3. All the results can be utilized by engineers, during the designing and construction. the main conclusions are listed as follows : ( 1 ) based on the shortest line between weak interbed and limit of excavation and the location of point of intersection between limit of excavation, classification of weak interbed distribution is set up, and the distance of distribution is defined ; ( 2 ) according to the strength and deformation equivalent principle, influence zone of weak interbed is introduced, and a new method to simulating the weak interbed with thickness is built ; ( 3 ) some quantificational results on influence of weak interbed respectively at crown, right shoulder and right wall are summarized ; ( 4 ) some quantificational results on influence of weak interbed with the distance between weak interbed and limit of excavation 0. 2d, 0. 5d, l. od are gained ; ( 5 ) some quantificational results on influence of weak interbed in the rock mass with confining coefficient 0. 38, 1. 0, 1. 5, 2. 0, 3. 0 are summed up ; ( 6 ) some quantificational results are summarized on influence of the underground surrounding rock mass stability with weak interbed, in the representational surrounding rock mass graded ii, iii, iv ; ( 7 ) according to the studying results some advices are suggested on designing of underground engineering

    主要結論如下： （ 1 ）以軟弱夾層到開挖輪廓線最短距離和最短距離線與開挖輪廓線的交點位置為指標對軟弱夾層的分佈部進行了分類，並確定了軟弱夾層分佈距離； （ 2 ）根據強度等效和變形等效的原則，引入了軟弱夾層影響帶的概念，建立了模擬軟弱夾層厚度的一種新方法； （ 3 ）總結出了軟弱夾層分佈在拱頂、右拱肩、右邊墻時對地下洞室穩定性影響的量化指標； （ 4 ）分析出了軟弱夾層距開挖輪廓線0 . 2d 、 0 . 5d 、 1 . 0d三種情況對地下洞室穩定性影響的量化指標； （ 5 ）總結出了在不同的側壓力系數（ 0 . 38 、 1 . 0 、 1 . 5 、 2 . 0 、 3 . 0 ）地應力場中軟弱夾層對穩定性影響的量化指標； （ 6 ）得出了在、 、代表性圍巖中軟弱夾層對穩定性影響量化結果； （ 7 ）根據數值試驗成果提出了在有軟弱夾層圍巖中地下洞室設計原則的幾點新內容。
  4. An algorithm for maze by marking shortest path with recursive backtracking

    迷宮問題的最短距離標記法遞歸求解
  5. Laughter is the shortest distance between two people

    笑是兩個人之間的最短距離。
  6. The shortest distance between two points is a straight line

    兩點之間的最短距離是直線。
  7. Through a performance analysis and simulation on generated methods, maximum minimum distance, undetected error probabilities, code weight distribution, good extended shortened codes are determined and general rule is concluded. furtherly, the paper generates nonlinear extended shortened codes

    通過對擴展縮短crc碼的構造方法、最小距離、不可檢錯誤概率、碼重分佈等進行理論分析和模擬，得到了擴展縮短crc碼的好碼，並綜合出普遍規律。
  8. On the background of selecting an optimal combination of elastic pads " height between the two adjacent cylinders, which carry out the design requirement of combinative cylinders assembled structure, in this dissertation, the optimal design model is established ground on geometrical and mechanical model of the combinative cylinders assembled structure. the algorithm that integrates multi - objective ' s decision - making method with minimal distance between two points in euclid ' s space into the modified genetic algorithm to solute the optimal model is presented

    本文以選取層間彈性墊層厚度實現組合圓筒裱糊裝配結構的設計要求為研究背景，依據組合圓筒裱糊裝配結構的幾何模型與力學模型，建立組合圓筒裱糊裝配結構的優化模型，提出改進遺傳演算法與歐幾里德空間最短距離準則的多目標決策方法相結合的優化演算法。
  9. Bluetooth is a technology developed for short - range wireless communication by bluetooth special interest group ( sig ). the purpose of bluetooth technology is to replace the cable and connect various devices such as cell phone, pc and pda together by electromagnetic wave

    藍牙是由藍牙特別興趣小組（ sig ）制定的短距離無線通信技術，其最初的主要目的是取代電纜，用電磁波來實現手機、 pc和手持終端等各種設備間的連接。
  10. “ we need 15 points, we are ready for the final sprint, ” claimed deschamps on monday

    「我們還需15分，我們正在為最後的短距離沖刺做好了準備， 」德尚在星期一聲稱。
  11. I have found it more reliable to follow the surface for short to medium distance projection of up to a few hundred miles

    我發現在地表進行最多數百英里的中短距離的投射更為可靠。
  12. Secondly, the genetic algorithm is employed to calculate the minimum distance between two general nurbs surfaces

    然後，運用遺傳演算法給出了任意兩張nurbs曲面之間最短距離的求解。
  13. As these underwater acoustic communication systems is intended for comparatively short distances, up to 10 - 30 km, problems arise when the submarine operate outside the normal areas, far from the save waters covered by national defence and communication systems

    但是這些水聲通信系統僅僅適用於短距離通信，最遠只能到10 ~ 30千米，如果潛艇在常規水域之外工作，遠離了國家防衛和通信系統所覆蓋的區域，就會出現問題。
  14. The main contents of this course include linear programming, simplex arithmetic

    線性規劃、單純形法、西北角法、最大優化法，最短距離法。
  15. This thesis, from different analytical points of view, proposes three algorithms for the minimum distances between convex nurbs surfaces and general nurbs surfaces respectively

    本文從不同的分析角度，分別就凸曲面和一般曲面展開研究，給出了nurbs曲面間距離求解的幾種演算法，解決了最為復雜的兩參數曲面間的最短距離求解問題。
  16. Minimum distance code

    最短距離碼
  17. Determines the minimum distance, in pixels, that the splitter can be moved by the user

    確定用戶可以移動拆分器的最短距離（以像素為單位） 。
  18. The distance to something is always the shortest distance to it ; if your opponent finds a shorter distance, you must use that as the distance

    在某種情況下這里所說的距離是指最短距離；如果對手發現了較短的距離，就必須使用那個距離。
  19. In addition, clove communication rapidly structured customer services centers in every province and 300 maintainance maintain stations all over the nation

    與此同時，深愛通信在全國建成40餘家省級客戶服務中心， 150家地市級客戶服務分中心，讓消費者在最短距離和時間內享受深愛手機的售後服務。
  20. And a method of node optimization according to beeline is also put forward to decrease large amounts of short straight lines and ensure sameness of image profile to object prototype. it improves the precision of engraving and suffices the request of engrave machining

    為減少邊緣線上的大量結點和鋸齒，保證優化后的圖形輪廓與原圖像逼近，提出了基於最短距離優化節點的解決方法，從而提高了精度，滿足了雕刻加工的要求。
分享友人
分享到 Line

分享到臉書