最終使用溫度 的英文怎麼說

中文拼音 [zuìzhōngshǐyòngwēndù]
最終使用溫度 英文
ultimate-use temperature
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 終 : Ⅰ名詞1 （最後; 末了） end; ending; finish 2 （指人死） death; end 3 （姓氏） a surname Ⅱ形容詞（...
  • 使 : Ⅰ動詞1 （派遣; 支使） send; tell sb to do sth : 使人去打聽消息 send sb to make inquiries2 （用; ...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 最終 : final; ultimate最終裁定 absolute decree; 最終裁決 final ruling; 最終產品 [工業] final products; e...
  • 溫度 : [物理學] temperature
  1. The moderate supersonic carbon added to the mold flux for ultra - low carbon steel is used to stay the melting speed as skeleton. then the mold flux coils have the good adiabatic, insulation and even flow property. at the same time it cause the carbon increase in the steel slabs and the operation of the ultra - low carbon is affected at last

    超低碳鋼連鑄結晶器用保護渣中，外加中超碳黑作為骨架降低熔化速度，使保護渣具有良好的絕熱保溫性、均勻流動的潤滑性，但同時卻會引起鋼鑄坯的碳增量，最終影響超低碳鋼的成功操作。
  2. These results show that since the existent defects of combustion device structure and its hypothetical circle of contact, these make a poor primary and secondary wind rigidity in operation and a too big actual circle of contact. in addition, the coal used is extreme prone to burn and reside in boiler. under such a condition, the coal powder ignites earlier in a short time and short distance when it leave the jet - combustioning device, and splashes the water cooler, eventually this results in a burned coal residue in boiler

    針對宏偉熱電廠410t / h燃煤鍋爐嚴重結渣問題，對燃煤的結渣性、爐內溫度工況及空氣動力工況等進行實驗研究，由於燃燒器結構和假想切圓選擇的缺陷，使得鍋爐在正常運行時，一、二次風剛性較差，實際切圓過大，加上目前燃用煤質屬于極易燃、易結渣煤質，致使煤粉在離開噴燃器很短的時間、較短的距離內開始著火，並沖刷水冷壁，最終造成爐膛結渣。
  3. Beginning with the analysis of the effects, which are brought by the application of only one kind of pore - former and some other operating factors ( such as sintering temperature, warmth retaining time and so on ), on the properties of the beads, e. g., porosity, strength, size distribution of the beads and pores size, etc., these effects are discussed in detail and the relationship between the factors is studied thoroughly. the use of mpf ( multi - pore - former ) is introduced for the first time, which is of the most importance and significance in this paper

    研究從造孔劑選用和燒結過程對顆粒的孔隙率、機械強度、孔徑分佈及粒度分佈的影響入手，找出了造孔劑的種類及含量、燒結溫度以及保溫時間等因素對最終所得產品顆粒的性能影響及它們之間的相互關系，並首次提出將造孔劑復配使用來對填充法加以改進，無需擴孔處理，即能直接制備宏孔徑、高強度、小粒度、比表面大的多孔玻璃載體顆粒。
  4. In the section of non - pressing sintered, the influence of different raw material system and sintered temperature on the phase composition of the material were studied. and two conclusions were achieved. the one is that it is good for phase composition design and control because the final phase composition of the material fabricated by ti, sic and c raw material system is comparatively stable

    在無壓燒結階段，研究了原料體系與工藝制度對材料物相組成的影響，結果表明使用ti 、 sic 、 c的原料體系得到的材料最終物相組成比較穩定，有利於進行材料組成設計與控制； 1500得到的材料中的雜質相含量較少，是比較合適的反應溫度。
  5. The architecture is simple, with high respond speed, high stability and adopts very advanced charging termination methods such as - v, max voltage, max temptature and temptature change rate so its reliability and safety are very high

    該電路結構簡單，響應速度快，有很高的穩定性，採用了非常完善的充電中止方法，如- v終止，最高電壓，最高溫度和溫度變化率等，使得該電路具有相當高的可靠性和安全性。
  6. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
  7. Above 450, the formation of low density u ( al, si ) 3 phase, together with the release of the impurity gas and fragmentation of u3si2 particles, will cause fuel meat to swell, al matrix to crack and u3si2 particles to invade to clad. as a result, the thickness of the meat increased, the thickness of clad decreased and the deformation of fuel plates increased, and the leakage probability of the radioactive mass increased reasonably

    同時，由於芯體膨脹及鈾硅顆粒碎裂的綜合作用，使u _ 3si _ 2顆粒向包殼侵入，最終使燃料板芯體厚度增加較大，芯體及燃料的體積也顯著增加，包殼厚度減薄；高溫將加速芯體u _ 3si _ 2顆粒碎裂、芯體開裂、包殼以及燃料板變形，從而使燃料芯體與包殼脫開，最終可能導致放射性物質泄漏。
分享友人
分享到 Line

分享到臉書