有效熱 的英文怎麼說

中文拼音 [yǒuxiào]
有效熱 英文
available heat
  • : 有副詞[書面語] (表示整數之外再加零數): 30 有 5 thirty-five; 10 有 5年 fifteen years
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • 有效 : effective; valid; efficacious
  1. Using this method to dispose interference of output signal of sensing elements, the interference caused by fixed position heat source of constant and adagio variable temperature can be effectively eliminated in exterior

    用這種方法對敏感元件的輸出信號進行處理可以十分地消除位置固定(或移動速度很慢)的源所產生的干擾。
  2. At the same time, the problem from the concrete cracking is effectively solved through the measures such as enhancing the quality of the excavated surface, adjusting the admixing ratio of fly - ash in the concrete, and lowering the temperature rise of the hydration heat

    同時通過提高開挖表面質量,以及調整粉煤灰摻量以降低水化溫升等措施,地解決了混凝土裂縫問題。
  3. So the effect of eutrophication of dianchi lake of sediment ca n ' t be ignored. based on the research of modern sediemnt of dianchi lake, the thesis is concerned about some physical and chemical characteristics ( including magnetic susceptibility, ammoniac nitrogen and effective phosphprus etc. ) and thermodynamics analysis of spontaneous mineral of iron

    本論文主要以滇池現代沉積物為研究對象,對滇池現代沉積物的主要物理和化學性質(包括氨氮、磷、磁化率等) ,進行基礎性地分析研究並對滇池現代沉積物鐵的自生礦物進行了力學分析。
  4. This antipyretic action is usually rapid and effective in febrile patients.

    對發病人,這種退作用通常迅速
  5. Steamed millets with water content of 45 % ( broomcorn ) and 42 % ( foxtail ) were inoculated with liquid culture of p. delphacis ( containing mycelial mass of ~ 25 mg / ml ) at a ratio of 20 % ( v / w ) and then incubated at 25 ? and l : d 12 : 12

    將菌絲生物量約為25mg / ml的菌絲液按20的比例( v / w )接入經高溫濕滅菌並適度熟化、含水量分別為45和42的黍米及粟米中,在25和12l : 12d條件下直接培養,所獲3 17d黍米和粟米培養物的產孢潛能和產孢時間因培養天數不同而異。
  6. Because, this is of chinese herbal medicine outer the organization is stimulated suddenly by high fever, instantly constrictive, caky even, its protein is formed on cellular wall cannot go against the metamorphic layer that turn, prevent moisture development, organize interior to composition dissolves hard and be released, such, the decoct of medicaments active ingredient goes out rate reduce greatly, affect curative effect badly

    這是因為中草藥的外層組織忽然受到高刺激,立即緊縮,甚至凝固,其蛋白質便在細胞壁上形成不可逆轉的變性層,防止水分深入,組織內部成分難以溶解並釋放出來,這樣,藥物成分的煎出率大大降低,嚴重影響療
  7. Then the finite element equations are derived with the effective heat capacity method. common time - stepping method and precise time integration ( pti ) method are used to solve the equation

    然後基於等容法推導了伴相變過程的傳控制方程的限元列式,並且分別研究了用常規的時間差分法和精細積分法求解上述限元方程。
  8. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採用機硅單體延遲滴加及添加水解抑制劑等技術,防止了-甲基丙烯酰氧基丙基三甲氧基硅烷在乳液聚合過程中的過渡水解及縮合反應,提高了聚合物大分子鏈中機硅鏈節的含量;利用紅外光譜與差示掃描量儀對產物分子結構進行了表徵,並通過對共聚產物力學和吸水率的測試,證實了本研究所制備的機硅改性丙烯酸酯共聚物具比純丙烯酸酯聚合物更優良的力學及耐水性能;從分子設計角度出發,利用醇解反應合成出水解、縮合反應速率較慢的兩種新型不飽和機硅單體: ?甲基丙烯酰氧基丙基三乙氧基硅烷和?甲基丙烯酰氧基丙基三異丙氧基硅烷;利用核磁共振對新型硅烷單體結構進行了證實;研究表明利用新型硅烷單體可以制備出高硅烷含量的機硅改性丙烯酸酯乳液,且其聚合產物具較高的力學及耐水性能。
  9. A novel method to reduce crucible erosion is by suppressing thermal convection currents, which can be done by applying a magnetic field to the melt.

    減少坩堝侵蝕的方法是對熔體施加磁場以抑制對流的流動。
  10. The average thermal intensity inside the particle is obtained based on the solution of the temperature field inside the particle. the effective thermal conductivities for composites with different particulate geometry are calculated by using the prediction formula

    在求解顆粒復合材料不同形狀夾雜內溫度場的基礎上,進而求解其夾雜相的平均溫度梯度,利用有效熱導率的預測公式,對含不同形狀夾雜的復合材料進行數值計算從而得到其有效熱導率。
  11. By extending the pyroelectric theory of a ferroelectric bilayer, we have presented the effective pyroelectric coefficient of a ferroelectric sandwich structure by use of the electrostatic theory. when the pyroelectric coefficient of the interface has a large deviation from that of the two - sided slabs and the dielectric constant of the interface is low, the effective pyroelectric coefficient of the sandwich structure may be one or two order higher than the largest pyroelectric coefficient of the components

    我們應用靜多層結構鐵電系統的物理性質研究摘要電場理論,推廣了鐵電雙層膜的電理論,給出了鐵電三明治結構的有效熱電系數,發現在界面層的電系數與上下兩層的電系數差異較大,且界面層的介電常數較小的情況下,三明治這種復合結構材料的有效熱電系數比單一組份材料的電系數可以提高一到兩個數量級。
  12. The fractal model of the effective thermal conductivity in granular flow with non - uniform particles

    混合顆粒流分形模型及相關有效熱傳導的分析
  13. Analysis of heat transfer and effective thermal conductivity of high temperature fibrous insulation for thermal protection system

    防護系統高溫纖維隔氈傳有效熱導率分析
  14. It can make sprinkler of water feeding install on strap or on sand inlet of double disk and adjust spraying angle of sprinkler according to real condition ; the water will spray on falling sand that makes it form sand curtain ; it sprays water on hot sand equably and extends exchanging time of water and hot sand. 4

    根據現場情況,加水噴頭可設在進砂皮帶上,或設在雙盤的進砂口處,調整噴頭的噴灑角度,使水噴向由下落的砂子組成的砂簾,將水盡可能預先均勻得噴灑在砂上,增加水與砂的有效熱交換時間。
  15. In this paper, finite element software ansys is used to simulate the thermal conductivity and pressureless infiltration technique is used to produce aluminum infiltrated silicon carbide composite with high volume fraction of sic. the influence of interfacial thickness and temperature on thermal conductivity and cte have been investigated and analysed

    本文採用限元軟體ansys對鋁滲碳化硅復合材料的有效熱導率進行了數值模擬,用無壓浸滲法制備了高體積分數的鋁滲碳化硅復合材料,研究了界面層厚度和溫度等對鋁滲碳化硅復合材料的導率和膨脹系數的影響,並進行了分析。
  16. In the wrscs, the self - consistent model is used to describe the complex configurations of the particulate composite and the temperature field is solved by weighted residual collocation method with some proper simplifications. this method provides a more efficient way of setting up the algebraic equations corresponding to the governing differential equations. the prediction formula for the effective thermal conductivity of the composite is obtained

    權殘自洽方法可以用於描述不同形狀夾雜的復合材料的微觀結構,通過對不同幾何形狀角點做適當的圓弧化處理,採用加權殘值數值計算方法的配點法將求解微分控制方程變為求解線性方程組,進而得到任意形狀夾雜內部的溫度場,建立含不規則形狀夾雜的復合材料有效熱導率的預測公式。
  17. Abstract : based on rural economic and household energy consumption in china, the general nature of household energy consumption and the features on comparatively well - off rural household energy consumption were discussed. effective energy demand, electricity consumption and the percentage of commercial energy consumption per capita in total effective energy demand were proposed as the indexes of rural household energy consumption and the values of the indexes in different economic area were given

    文摘:根據我國農村經濟及農村家庭能源消費的基本狀況及相互關系,闡明了農村家庭能源消費的一般特性,分析了小康地區農村家庭能源消費的基本特徵,提出了將人均有效熱消費、商品能所佔比重及人均電力消費作為家庭能源消費特徵評價指標,進而給出了不同經濟類型區家庭能源消費評價指標值。
  18. 2. the thermal conductivity of composite will increase with the increase of interfacial thermal conductivity, and increase more quickly when interfacial thermal conductivity is lower. 3

    復合材料的有效熱導率隨著界面層導率的增加而增加,且界面層的導率較小時增加的較快,而界面層的導率較大時較慢。
  19. A new micromechanical method, the weighted residual self - consistent scheme ( wrscs ) is developed to study the thermal conduction of two - phase composite with arbitrary geometry of particulates

    本文介紹一種新的微觀力學方法? ?加權殘值自洽方法(簡稱權殘自洽方法) ,用於研究含任意夾雜形狀的顆粒增強復合材料的有效熱導率。
  20. Examining results corresponding to different particulate geometry, it shows that the effective thermal conductivity not only depends upon the volume fractions and the properties of components, but also depends on the particulate geometry

    對含其它形狀夾雜的復合材料的計算結果表明,復合材料的有效熱導率不僅僅依賴于夾雜相的體積含量及組分性質,還與顆粒的幾何形狀關。
分享友人