有源電路 的英文怎麼說

中文拼音 [yǒuyuándiànlù]
有源電路 英文
active circuit
  • 有 : 有副詞[書面語] （表示整數之外再加零數）: 30 有 5 thirty-five; 10 有 5年 fifteen years
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 有源 : [電學] active有源電路 active circuit; 有源器件 active device; 有源天線 active antenna; 有源衛星 active satellite
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Also, the calculation of the main circuit parameters of the shunt - apf has been developed

    本文同時給出了有源電力慮波器主電路參數選取原則。
  2. The electrical connector of an active circuit component

    有源電路元件的電接頭。
  3. Chapter 5 is about the design of millimeter wave solid circuit included frequency multiplier, low noise amplifier, medium power amplifier, mixer, if amplifier lastly, based on the work above, a millimeter wave t / r module is developed and the analysis of the result is also introduced

    第五章毫米波固態電路，詳細分析了毫米波倍頻器、低噪聲放大器、毫米波放大器、混頻器的理論，製作了毫米波混頻器、毫米波放大器、中頻放大器、倍頻器等有源電路。最後，在上述基礎上製作了毫米波t / r組件。
  4. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現：激勵源電路部分，由分頻電路和頻率合成電路組成，產生頻率穩定的激勵信號以確保檢測任務的正常進行；傳感器變換電路部分，由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成，主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號，易於后續電路處理；由dsp晶元構成的微處理系統，主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  5. These passive circuit elements, as they are often called, are of three main types.

    通常所說的無源電路元件有三種主要類型。
  6. If the network contains no energy sources, such as batteries or electrical generators, it is known as a passive network

    如果在網路中沒有電源，例如電池或者發電機，則稱為無源電路。
  7. In active section, the fundamentals of fet and hemt that are used as multipliers were analyzed

    在有源電路部分，我們分析了fet 、 hemt作為倍頻器的基本原理。
  8. So the passive lc network is used as a prototype for building a corresponding active network by leap - frog method

    因此，以無源lc網路為原型，利用跳耦法設計對應的有源電路。
  9. This is a low impedance discrete level control which sits between the preamp active circuitry and the input to your power amplifier

    這是一個位於前級有源電路和后級放大器輸入端之間的低阻抗的音量控制。
  10. Each technology offers inherent performance characteristics that can be enhanced with compensation networks or additional active circuitry

    各種技術以增強的補償網路或外加的有源電路提供固有的性能特性。
  11. Good agreements have been obtained between the results from these simulation methods and experimental measurements to show the validity and efficiency of these methods. from these examples, some problems of dealing with fdtd simulation of some microwave active circuits are solved

    通過實例的驗證，演示了各種處理微波器件的方法的具體實現，表明了各種方法的有效性，解決了處理微波有源電路的fdtd模擬時遇到的問題。
  12. In the active circuit part, based on the theories of multiplier of srd and fet, we have designed the circuit of x band 6 multiplier and ka band tripler. then they are simulated and optimized using harmonic balance method. furthermore, the results of optimization and experiments are analyzed

    在有源電路部分，我們介紹了階躍管、 fet倍頻器的基本原理，在此基礎上分別設計了兩個倍頻器電路，然後利用諧波平衡法進行了模擬，並對模擬、測試結果作出了比較。
  13. The topic of this paper originates from the national nature science fund " fdtd analysis and design of microwave active integrated circuits ". an analysis of microwave active circuits using fdtd method with the emphasis on the several methods with which to simulate the active devices in the microwave circuits is studied in details in this paper. and some practical electromagnetic problems are analyzed with these methods

    本論文題目來源於自然科學基金「微波有源集成電路的fdtd模擬與設計」 ，研究了時域有限差分法對微波有源電路的分析，主要研究了微波電路中各種微波器件進行fdtd模擬時的幾種處理方法，並採用這幾種方法分析了幾個實際的電磁問題。
  14. Plc, robot and cad / cam are called the three major pillars in the modem factory automation. plc, as the head of the three, has become the leading basic automatic equipment in the field of the industry control in the early 1980s " but as a matter of fact, plc being with the lack of friendly man machine interface, rnakes no close relationship between human and machineometimes it even can not be promoted and applied in some fields aiming at the situation mat those imported products are too expensive while domestic products are of rare famous brands, a plc man - machine interface - plc monitor is developedthis paper systemically introduces the developing procedure for the whole system, including how to design hardware and software system. especially emphasizing plc communication protocol. real time message accessing, lcd controller instruction set, definition of data construction for message & tag screens and how to display thern, assignment of internal resource of cpuealization in software among plc & manitor, file format defining a nd download of user data, etcplc monitor will compensate some weakpoints of plc, and extend the application rangeimultanneously enhance the performance of plc and increase the attached value of mechanical machines, undoubtedly it will see hight market prospect

    針對人機界面進口產品的高昂價格和國產品牌稀少的這一現狀，研製開發了一種plc人機界面? plc監控器。本文系統地介紹了整個系統的開發過程，包括硬體系統、軟體系統的設計及實現，重點介紹了plc通信協議，監控器的基本工作原理以及期望實現的功能，監控器電源電路、 sram存儲器掉電保護電路、 cpu監控器電路、按鍵輸入電路的設計及按鍵狀態的讀入，時鐘信息的設定與讀取， cpu液晶顯示器指令系統，信息畫面及標簽數據結構的定義及顯示方法， cpu內部資源的分配，監控器與plc通信的軟體實現，文件格式的定義以及畫面數據的下載等。 plc監控器彌補了plc一些方面的不足，可以擴大plc的應用范圍，提升機械設備的檔次，增加設備的附加價值，具有一定的市場前景。
  15. Then the paper analyzes control system of hybrid active power filter, the way of harmonic detecting and the principle of control system, digital low pass filter and the generation of pwm, on the base of which the paper designs a new parallel hybrid active power filter which is controlled by tms320lf2407, and detailedly introduces drive circuit of pwm, sampling circuit of current, voltage adjustment and protection circuit, communication circuit, liquid crystal display circuit

    分析了混合型有源濾波器的控制系統、諧波檢測方法及控制原理、數字低通濾波器和pwm信號的產生，在此基礎上設計了一種基於tms320lf2407為控制核心的並聯混合型有源電力濾波器硬體原理圖。並對pwm驅動電路、電流采樣電路、電壓調整、按鍵輸入和保護電路、通信模塊、液晶顯示模塊進行了較詳細的分析說明。
  16. On the base of chaos inherent in the switched - mode power supply the idea is present to uses controlling parameters to change the state of the circuit to reduce emi level

    從開關模式電源電路中固有的混沌現象出發，提出了應用組合參數控制改變電路工作狀態降低電磁干擾水平的思路。
  17. The spice simulation confirms the attractive properties of the proposed circuits. the simulative circuits of active network elements, analog signal operation and inductors based on current conveyors are systematically researched. a new active floating inductor is proposed

    系統地研究了電流傳送器在有源網路元件模擬、模擬信號運算和電感模擬電路中的應用，提出了一種基於電流傳送器的新型模擬浮地電感。
  18. Based the simplest solutions of control equations, one - cycle controller for the three - phase four - wire apf with four - leg is presented

    基於控制方程的最簡解，建立了單周控制四橋臂三相四線制有源電力濾波器的電路模型。
  19. On the basis of this, the control strategies for obtaining its reference voltage, one of pivotal technolog, are discussed. corresponding control circuits are designed, including the control strategies of detecting the source current and load voltage

    在此基礎上探討了串聯型有源電力濾波器的關鍵技術之一? ?獲得參考電壓的控制策略，包括檢測電源電流和檢測負載電壓兩種控制策略，並設計了相應的控制電路。
  20. After introduction of the tranlinear loop principal, the bjt current controlled conveyor has been designed by using mixed tranlinear loop voltage follower. as for modern integrated circuit, the model of mos transistor, the active resistance and the current mirror integrated circuit formed by mos transistor are introduced. the cmos current controlled conveyor has been derived from mixed tranlinear loop cmos voltage follower based on weak inversion operation

    針對現代集成電路的工藝，本文對mos晶體管的工作原理進行了簡要的敘述，討論了有源電阻和電流鏡的實現方法，並利用mos晶體管的亞閾值特性組成混合跨導線性迴路完成對應的電壓跟隨器的設計，推導出了基於cmos技術的電流控制傳送器。
分享友人
分享到 Line

分享到臉書