未醚化的 的英文怎麼說
中文拼音 [wèimíhuàde]
未醚化的
英文
unetherified-
The influence of catalyst on the copolymerization of epoxy and cyanate was investigated, and the mechanism of their copolymerization was discussed. the catalyst can obviously accelerate the curing of the resin to decrease the curing temperature. the three kinds of reactions ( cyclotrimerization, co - reaction and polyetherification ) in their copolymerization are not simultneous and independent to each other. in the lack of cyanate functional group, the main structures are oxazoine and polyether structure in the cured resin, and the triazine ring structure is of miner importance
研究了催化劑對環氧樹脂與氰酸酯樹脂的共聚固化反應行為的影響，並初步探索氰酸酯/環氧固化的反應歷程.研究表明，催化劑能明顯地促進其固化反應，降低固化溫度，縮短固化時間；氰酸酯與環氧共聚反應歷程是首先氰酸酯三聚反應生成三嗪環結構，然後三嗪環開環與環氧共聚反應，最後是未能參與共聚反應的環氧官能團在唑啉結構和三嗪環的催化下發生聚醚化反應；在氰酸酯官能團欠量的條件下，固化樹脂中主要是唑啉和聚醚結構，而三嗪環結構的含量很少When change the component of adhesive its shear strength increased from 39. 3 mpa to 53. 5 mpa at room temperature and it have long - term usage at 180 with 25 mpa and can be served at 230 in short period. the addition of liquid rubber resulted in a 300 % increase in the peeling strength. the addition of polymer ether imide led to a 260 % increase in the peeling strength, a 15 % increase in shear strength and a 10 increase in tg ( tg = 195. 54 )
研究結果表明： bmi dds e ? 51 tde ? 85組成的膠粘劑體系的室溫剪切強度為39 . 3mpa ，當改變環氧樹脂的含量時，剪切強度提高到53 . 5mpa ；用無規羧基液體丁腈橡膠改性環氧樹脂膠粘劑時室溫剝離強度提高3 . 0倍；用聚醚酰亞胺改性環氧樹脂膠粘劑，室溫剪切強度最高可達45 . 2mpa ，剝離強度提高2 . 6倍，玻璃化轉變溫度tg = 195 . 54 ，比未增韌體系提高10以上；碳纖維耐磨材料與同步器圓錐環的粘接實驗結果表明，膠粘劑的使用工藝性能良好，滿足室溫剪切強度30mpa和180剪切強度12 . 5mpa的技術要求。
分享友人