本機振蕩器 的英文怎麼說

中文拼音 [běnzhèndàng]
本機振蕩器 英文
lo local oscillator
  • : i 名詞1 (草木的莖或根)stem or root of plants 2 (事物的根源)foundation; origin; basis 3 (本錢...
  • : machineengine
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : Ⅰ動詞1 (搖動; 擺動) swing; sway; wave 2 (無事走來走去; 閑逛) loaf; wander; roam; loiter; go a...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit

    延遲線由寬帶放大、可調衰減和聲表面波質量傳感件構成。延遲線輸出信號經濾波后與109mhz的晶體輸出信號相混頻,通過低通濾波取其差頻,並經整形後由數字信號處理電路處理。
  2. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中,作者介紹了直流電的工作原理和數學模型、脈寬調制( pwm )控制原理、 h橋電路基原理和h橋功率驅動電路的兩種控制模式,設計了驅動電路的總體結構,給出了電路的功能模塊,確定了設計的可行性,然後在子電路模塊中,重點分析設計了基準源電路、電路、高端功率管柵驅動電路(電荷泵及自舉電路) 、低端功率管柵驅動電路和死區時間產生電路。
  3. Gps is a planet wireless conductance system which is global and all - weather, gps can offer high precision time orientation information to infinite user, clock precision reachs 10 ? 6 magnitude 。 not only changes traditional time method of quartz crystal clock, but also replaces wireless shortwave and even more lowfrequency signal and tv signal whose overlay range is limited and low precision, offers advantage to geology field task, achieve automatization and high precision of seismic flow observation

    利用gps授時信號全方位、全天候、連續性、實時性和高精度的特點,以gps信號為基準來校準地時鐘(晶體時鐘或原子鐘) ,將gps接收輸出信號的長期穩定度和恆溫晶的短期穩定度相結合,應用大規模可編程邏輯件,設計和實現了由pc104控制的實時在線授時系統。
  4. The pole - placement method is used in the design of controllers. the 4 - machine system example validates the effectiveness of this prony ' s method based damping controller design. 4

    並用4系統對pss的設計以及tcsc的控制信號選取作為例子表明了文基於prony方法設計低頻阻尼控制的有效性。
  5. In the section of experiment, we focused on the research of optical system of optical parameter oscillation, computer controlling data sampling closed - circuit system and technology of computer controlling feed - back. in the section of optics, we used present condition to do the experiments about optical parameter effect and got a series of characteristic curve on power transition efficiency and output power

    文的實驗部分主要側重於智能化光參量系統的光學部分、計算控制數據採集閉環系統以及計算控制反饋技術的研究。在光學部分,論文利用現有實驗條件進行了參量頻率調諧的研究,得到了調諧曲線,並做了輸出參量光的能量轉換效率以及輸出功率的實驗,得到一系列特性曲線。
  6. Lo - local oscillator

    本機振蕩器
  7. Single frequency source is usually used as local oscillator in communication system and radar system, also as a reference clock in digital circuits, so it is a extensive - applied technique

    固定頻率源可以在在通訊系統和雷達系統中作為本機振蕩器,也可以作為數字電路的基準時鐘信號,因此得到了廣泛的應用。
  8. Research on cmos implementation of wlan transceiver rf front - end is done in this thesis. the transceiver uses the most used super - heterodyne architecture, its rf front - end consists of low noise amplifier, down - converter, up - converter, preamplifier, lo buffer and pll frequency synthesizer

    論文研究無線局域網收發射頻前端的cmos實現,該收發採用超外差式的拓撲結構,其射頻前端主要由低噪聲放大、下變頻、上變頻、末前級、信號緩沖和鎖相環型頻率合成等模塊組成。
  9. This paper presents a new type of microcomputer compensated crystal oscillator ( mcxo ) which bases on at - cut crystal and uses microcomputer as its core

    文主要敘述了一種以微處理為核心的基於at切晶體諧的微補償晶體( mcxo ) 。
  10. Traditional inertial mechanized - platform uses velocities to damp the system attitude to improve the precision of attitude, when the system acceleration is small. referring to the idea, this paper designeda damp kalman filter in strap - down attitude heading reference system ( ahrs ). the new method makes use of 3 - d accelerometer ' s measurements to estimate the system attitude, which is measured to compensate attitude errors. because the acceleration affected the precision of fiher directly, the fuzzy adaptive system was presented. the fuzzy logic inputs are three accelerations and the output is to control the measurement noise covariance matrix. simulations and experimental results prove that the damp algorithm can damp most of schuler oscillation and foucauh oscillation, so that to assure the filter convergence and efficiently improve the precision of strap - down ahrs

    在系統動性不強的情況下,傳統的平臺內阻尼演算法將系統身的速度信息通過阻尼網路加到系統中,達到提高姿態角精度的目的.將這種平臺內阻尼的思想引入到捷聯慣性航姿系統中,在系統加速度較小的情況下,利用加速度計的輸出估計系統姿態角,通過卡爾曼濾波的形式補償系統姿態誤差.由於加速度的大小直接影響濾波精度,文設計了模糊自適應卡爾曼濾波演算法,根據三軸加速度計的輸出調整內阻尼量測誤差方差陣,從而避免了濾波的發散.模擬和實驗驗證,內阻尼演算法可明顯抑制舒勒周期和傅科周期,避免了系統姿態漂移,有效提高了捷聯慣性航姿系統的精度
  11. In the section of theory, we mainly studied optical parameter effect, discussed physical mechanism of optical parameter laser and normalized coupled wave equation and got the solution. we also carried out the analysis of gain mode of optical parameter oscillation, studied the threshold condition, analyzed output characteristics and then achieved characteristic curve

    文理論部分主要作了有關光參量效應方面的研究,探討了光參量的物理制、參量的歸一化耦合波方程,求解得到了參量的耦合波函數,同時對光參量的增益模式進行了分析,研究了使參量的閾值條件,並對光參量的輸出特性進行了分析,得到了特性曲線。
  12. In this dissertation, the method to design and realize the digital receiver in the field programmable gate array ( fpga ) has been discussed ; combining coordinate rotation digital compute ( cordic ) to design nco, we get a efficient structure without multiplications

    論文正是運用現場可編成邏輯件( fpga )設計與實現數字接收問題開展研究,結合坐標旋轉數值計算( cordic )演算法實現數控( nco ) ,得到一種免乘法高效可移植性好的數字接收fpga實現結構,並在現有的硬體平臺上進行了接收系統的調試,測試結果表明該接收能夠達到系統指標要求。
  13. Comparing with digital temperature compensated crystal oscillator ( dtcxo ), the mcxo introduced in this paper has many advantages as follows, simple in structure, small in size, low in power, low in price and short in startup time

    與數字溫度補償晶體( dtcxo )相比,文所敘述的微補償晶體具有體積小,造價低,功耗小等優勢。加上有開發系統用於開發生產,使其更具有市場競爭力。
  14. With the rapid advancement of process and technology, especially the realization of on - chip passive elements such as inductors and varactors, the on - chip implementation of voltage - controlled oscillators ( vcos ) which are necessary in wireless transceivers has become easy

    在工藝技術的飛速進步下,尤其是電感和變容管等無源件片上實現問題的解決,壓控已經可以實現單片集成,這對降低收發的成十分關鍵。
  15. At present, there are various methods of moving vehicle detector and identification. the system we designed for traffic information makes use of the principle of electromagnetic induction and radio frequency identification the moving vehicle detector, which is based on inductive circular loop, detects the information of vehicle according to the inductive signal. the basic information including speed and go through time can be detected to analyze oscillator frequency

    目前現行的車輛檢測與識別系統的種類繁多,系統基於電磁感應理論和射頻識別技術,採用環形線圈作為數據採集傳感,通過對的頻率計數測量到車輛的通過、速度等基信息,同時啟動射頻識別系統,使讀寫與安裝在車輛上的非接觸ic卡進行無線通訊獲取通過車輛的類型和所屬用戶等數據,並將有關數據通過rs232串口送至上位
  16. A full - digital demodulation technique is introduced in this paper, which can make it easy and quick to design and achieve binary phase shift keying ( bpsk ) demodulator, and also can reduce the requirement of the oscillator frequency precision and the degree of stability of the receiver

    文介紹了一種適合於用數字信號處理( dsp )實現的全數字解調技術。該技術能方便、靈活地設計實現二進制相移鍵控( bpsk )解調,而且使用該技術可以大大降低對接收身的頻率精度和穩定度的要求。
  17. This machine consists of bin, vibration chamber, coupling and motor. the vibration chamber is made up of eccentric wheel. rubber soft piece, main shaft and bearing. the adjustable eccentric hammering is transmitted to the centerline of main shaft by motor drive, and produce centrifugal force at unsteady state so as to change the strength of material and form vortex in the sieve. weghted regulator and amplitude can be adjusted as per different material and sieve mesh

    由料斗、室、聯軸、電組成,電腦內由偏心輪、橡膠軟體、主軸、軸承組成,可調節的偏心重錘經馬達驅動傳到主軸中心線,在不平衡狀態下,產生離心力,使物料強度改變在篩內形成漩渦,重錘調節幅大小可根據不同物料和篩網進行調節。
分享友人