材料吸收 的英文怎麼說

中文拼音 [cáiliàoxīshōu]
材料吸收 英文
material absorption
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 吸 : 動詞1 （把液體、氣體等引入體內） inhale; breathe in; draw 2 （吸收） absorb; suck up 3 （吸引） a...
  • 收 : Ⅰ動詞1 （把攤開的或分散的事物聚集、合攏） put away; take in 2 （收取） collect 3 （收割） harvest...
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  1. Absorptivity of an absorbing

    吸引材料的吸收率
  2. The peak of temperature is more high with metal powder, as a result of absorptivity is more high

    添加金屬粉末時，材料表面對激光的吸收率增強，同一測量點的峰值溫度升高。
  3. Test method for solar absorptance, reflectance, and transmittance of materials using integrating spheres

    利用綜合球進行材料的太陽能吸收反射和傳輸的試驗方法
  4. Test method for determining solar or photopic reflectance, transmittance and absorptance of materials using a large diameter integrating sphere

    用大直經積分球測定材料的太陽能或光反射性，透明性和吸收性的試驗方法
  5. The obtained polysilane - polyacrylate gradient films showed no macro - interface with the silicone content reducing gradually from the top surface to the bottom one. dma thermograms indicated that polysilane - polyacrylate gradient films contained two glass temperatures with their bands drifting from and their range extending much from each component. the good properties of waterproof, calorifics, and ultraviolet - absorption were also determined by dsc, uv and water contact angle measurements

    結果表明：有機硅聚合物-聚丙烯酸酯梯度膜有一個較寬的玻璃化轉變溫區，玻璃化轉變范圍相對組分材料的玻璃化轉變范圍發生了擴展：有機硅聚合物-聚甲基丙烯酸酯梯度膜具有較好的熱學性能；硅含量的提高有利於改善膜層的憎水性能和紫外吸收性能。
  6. We can see from the photos of the sem that the diameters of the powers of this tree land of materials obtained by the system of trion x - 100 / caprylic alcohol / cyclohexane / water are about 20 nm. by means of uv - vis, atomic absorption spectrometry and so on, nanoparticles of this three kind of anode materials are synthesized

    利用trionx - 100 /正辛醇/環己烷/水反膠束體系制備出三種物質的粉體，掃描電子顯微鏡照片顯示粒子的粒徑在20nm左右，分佈均勻；此外還利用uv - vis 、原子吸收光譜等測試手段，都表明合成出了三種正極材料的納米粒子。
  7. No doubt much important cognitive material must be assimilated by the manager-to-be.

    毫無疑問，未來的管理者必須吸收許多重要的認識性材料。
  8. Treatment of comminuted patella fracture with absorbable material

    可吸收材料固定粉碎性髕骨骨折
  9. Ceo22 is used as optical materials, polishing agents, ultraviolet absorption materials, the cleaning catalyst of car ' s waste gases, chemical decolorant of glass, radiation - resisting glass permanent magnet, electronic ceramics etc. if it is processed into nanoparticles, it will exhibit some novel properties led to varied applications. for example, ceo22 nanocrystal is a better promoter of cytochrome c and the stabilizer of zro22 ceramics. because of its high index of refraction and good stability, it is used to produce reduced reflection film

    Ceo _ 2是一種廉價而用途極廣的材料，如用於發光材料、拋光劑、紫外吸收材料、汽車尾氣凈化催化劑、玻璃的化學退色劑、耐輻射玻璃、永磁體、電子陶瓷等，其納米化后將出現一些新的性質及應用，如ceoz納米晶是細胞色素c的良好的催進劑，還用作zro :陶瓷的穩定劑，由於ceo :折射率高，穩定性好，常用於制備減反射膜等。
  10. Sepiolite has low shrinking rate, plasticity is good, alkali - resisting and easy to dissolve, absorb the peculiar industry performance such as being strong of performance, in addition, also absorb, decolouring, hot stability is anticorrosive, resist radiation and insulate against heat, the characteristic such as being insulating, is used in the non - asbestos jointing sheet, various of brake shoes, paint, sound insulation of the building mainly, thermal insulator

    海泡石具有收縮率低，可塑性好，耐堿易溶解，吸附性能強等特有的工業性能，除此之外，還具有吸附，脫色，熱穩定，抗腐蝕，抗輻射及隔熱，絕緣等特性，主要用於密封產品如非石棉橡膠板，摩擦產品如各式剎車片，油漆、塗料，建築隔音、隔熱材料。
  11. By analysising the thin film system, polarization and absorption of material, the relation ship between these parameters and the chroma of the light engine system is built. then a programm is writen in c + + language to realize the method

    通過分析該系統從光源到分色合色和投影鏡頭的膜系結構，偏振特性，材料吸收等對系統能量分佈的影響，建立了各個參數與系統色度之間的關系。
  12. Effect of doping k element on properties of lithium zirconate as coco

    K元素的摻雜對鋯酸鋰材料吸收co
  13. Effect of doping k element on properties of lithium zirconate as coco2 - absorbent

    K元素的摻雜對鋯酸鋰材料吸收co2性能的影響
  14. Based on experiment the materials with different content will obtain different absorbing performance. by the experiment, the paper obtained the laws for good absorbing performance. at the same time, the experiment optimized the preparation technology for the better performance

    為了應用目的，本文對不同產地原材料、不同含量對材料吸波性能的影響進行了研究，發現蘭州產地原材料性能較好；高含量的吸收層和變換層組合才有優異的吸波性能。
  15. Moreover, the medium film affected the coupling effect, weakening its leading effect on the microwave - absorbing properties of materials, increasing the absorption quantity and decreasing the matching thickness, the density of area and the lodb bandwidth

    介質膜的加入則會影響層間耦合作用，減弱層間耦合作用對材料吸波性能的主導作用，提高吸收量，降低匹配厚度、面密度與10db帶寬。
  16. Conversion method of absorbed doses in different materials irradiated by x, rays and electron beams

    X射線和電子束輻照不同材料吸收劑量的換算方法
  17. Absorption abilities were measured with a thermogravimetric analyzer. the experimental results show that doping potassium can significantly improve the co

    實驗結果表明，通過適量k元素的摻雜，能明顯改善材料吸收co
  18. Because the limited concentration that macromolecular materials absorb liquid antistatic reagent is very low, it is better if add appropriate solid powder material when preparing high - concentration antistatic master batch

    由於高分子材料吸收液體抗靜電劑的極限濃度較低，製作高濃度抗靜電母料時，可加入合適的固體粉末材料。
  19. Because the limited concentration that macromolecular materials absorb liquid antistatic reagent is very low, it is better if add appropriate solid powder material when preparing high - concentration antistatic master batch. there are a little precipitation in product, but no effect on use effect

    由於高分子材料吸收液體抗靜電劑的極限濃度較低，製作高濃度抗靜電母料時，可加入合適的固體粉末材料。本品有少許沉澱物，不影響使用效果；使用時最好先用乾燥、潔凈的棍棒適當攪拌，以提高本品的均勻性。
  20. Moreover, when the filaments are treated for 12 minutes, the interfacial shear stress will be lower than that treated for 6 minutes. izod pendulum is used to test the influence of the fiber / matrix bond strength on the low velocity impact responses of the composites. the curves of energy - time, force - time and velocity - time are obtained by a data acquisition system

    用擺錘低速沖擊儀對界面粘結強度不同的材料進行沖擊試驗，藉助數據採集系統得到沖擊過程中材料吸收的總能量、承受載荷、擺錘速度等參數與時間的關系曲線，並通過pc機處理，將載荷?時間曲線轉化為載荷?位移曲線。
分享友人
分享到 Line

分享到臉書