材料特性 的英文怎麼說

中文拼音 [cáiliàotèxìng]
材料特性 英文
material behavior
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. The development and application prospect of environmental friendly buffering cushions were compared and analyzed, on the base of discussing the buffering properties of corrugated cardboard, honeycomb cardboard, paper mould, dissoluble foam, foaming plant fiber, and expanded perlite buffering cushion

    摘要在論述瓦楞紙板、蜂窩紙板、紙漿模塑、可降解泡沫塑料、發泡植物纖維、膨脹珍珠巖等緩沖材料特性基礎上，分析比較了各種環保型緩沖襯墊的開發研究及應用現狀。
  2. Mnzn high permeability ferrite material characteristics

    Mnzn功率鐵氧體材料特性
  3. Road wheel in this paper is created according to gb / t 3487 - 1996 and application of load is simulated the actual situation. msc. patran finished is used to build model of road wheel, divide finite element graticule, apply boundary load, and define material properties, which are submitted to msc. nastran to analyze strength

    本文所使用的車輪是按照輪輞的國家標準而構建的，而載荷的加入是模擬實際情況而添加的，在此基礎上，運用msc . patran ，完成車輪幾何建模，有限元網格劃分，邊界載荷的加入，材料特性的定義，再提交到msc . nastran中進行強度分析。
  4. Road wheel in this paper is created according to gb / t 3487 - 1996 and application of load is simulated the actual situation. ansys finished is used to build model of road wheel, divide finite element graticule, apply boundary load, and define material properties, which are submitted to ansys to analyze strength

    在車輪的構建上，本文採用了三維繪圖軟體ug ，在ug中首先完成車輪幾何建模，然後導入到ansys裏面進行修改並進行有限元網格的劃分，邊界載荷的加入，材料特性的定義，對車輪進行強度分析。
  5. With regard to the protection system of inorganic zinc - rich primer + epoxy micaceous iron oxide intermediate + polysiloxane finish having been used for major bridges for the first time and the anti - rust and anti - slip inorganic zinc - rich coating used for the bolted and welded surfaces of the bridges, the paper describes the protection system and coating workmanship in considerable details from aspects of the material properties, construction methods and coating inspection

    針對在大型橋樑上首次應用的「無機富鋅底漆環氧雲鐵中間漆聚硅氧烷面漆」的防腐體系和栓接面採用的無機富鋅防銹防滑塗料，從材料特性、施工方法及塗層檢驗等幾方面做了較詳細的論述。
  6. Through studies of material characteristics suitable for making semiconductor laser heat sinks, we have manufactured panel heat sinks, large - channel heat sinks and micro - channel heat sinks

    通過對適于製作半導體激光器熱沉的材料特性進行研究，製作出平板熱沉、大通道熱沉及微通道熱沉。
  7. The effect of cutting speed, cutting thickness, cutting knife and materials on the working power capacity is discussed. finally tractive property of road plane milling machine is also studied. through the comparison of the results of theory calculation and experimental results the equation of working power capacity of milling machine is modified

    本文對冷式瀝青路面銑刨機的動力學工作過程進行了理論分析與試驗研究，並利用金屬材料切削的基本原理，研究了主切削力，並從能量轉化守恆的角度推導了銑刨機銑刨作業阻力和功率計算公式，討論了機器切削速度、銑刨厚度以及刀具與材料特性對銑刨作業阻力和功率的影響規律，最後討論了銑刨機牽引性能，且通過試驗研究驗證了銑刨作業阻力和功率公式。
  8. Electric cables - accessories - material characterization - resinous compounds before cure and in the cured state

    電纜.附件.材料特性.在加工處理狀態和處理前的樹脂化合物
  9. The paper introduced their architectural investigation and practice on the aspects of architectural tectonic, relation between tradition and creativity, the molding of place and construction of architectural space etc. such as david chipperfield ' s value of architecture ' s initial meaning and physicality, his emphasize on the architectural experience quality and ethics duty of the architect, and his view on the continuation of tradition and creativity ; waro kishi ' s value of tectonic noumenon, his concept of " industrial vernacular ", his application of the " architectural promenade " principle, and application of courtyard ; tod williams & billie tsien ' s principle of " architecture is combination of work and life ", their value of place, their observation of material characteristic, and their " slow " principle on design, me thod, and sense perception. the paper also introduces the three architect ' s representative works and their design method

    介紹了他們在建築的建構、傳統與創新的關系、場所感的塑造以及建築空間的創造等方面所進行的理論探索與建築創作實踐，如大衛?謝潑菲爾德對建築內在意義及建築實體（ physical ）的重視、對建築的體驗品質和建築師的倫理責任的強調、對傳統和創新的可持續性的認識；岸和郎的對建構本體的重視、關于「工業鄉土性」的概念、對「建築的漫步」理念的運用、以及對庭院空間的運用；托德?威廉姆斯和比麗?錢的「建築是工作和生活的結合」的基本設計理念、對場地的重視，對材料特性的探索、以及關于設計、方法、感知方面的「緩慢」的理論。
  10. Material characterisation - part 1 : compounds for use in cable accessories : resinous compounds before cure and in the cured state ; german version hd 631. 1. s1 : 1998

    材料特性.第1部分;電纜附件中用的混合料.固化前和固
  11. To develop product / material characterization techniques to evaluate and predict product / material performance

    發展研究產品/材料特性技術以評估和預測產品/材料的性能。
  12. The characteristic of chemical grouting material should combind with construstion method directed by the theories, it is necessity guarantee for the good result in some special cases. by cw series material, various complicated engineerings have been successfully handled, such as the treatment of concrete fine cracks in three gorges project ( tgp ), foundation reinforcement to the fault in in three gorges project ( tgp ), and the seepage control and reinforcement for the dam base of jiangya hydropower - station. these illustrations are provided to proof the advantages of modified epoxy resin and its technique

    化灌材料特性與理論指導下的灌漿工藝的全面結合是化灌處理，特別是特殊條件下灌漿效果的必要保證， cw系改性環氧化灌漿材及技術對多種復雜工況工程處理對象成功處理，解決了三峽混凝土微細滲水裂縫防滲補強、三峽工程地質斷層泥化夾層加固以及江埡電站壩基溶蝕帶防滲等一系列工程技術難題，印證了該材料及技術的先進性。
  13. This course presents materials properties, functions, and usage, life cycle assessment of materials, and developments of various eco - materials

    本課程介紹各類材料特性、功能與利用，探討材料生命周期與環境、資源之關系，與各類材料之生態化實例。
  14. The processing characteristics and some material properties of silicon wafers depend on the orientation.

    矽片的工藝性質與某些材料特性均與晶向有關。
  15. Charateristics and load carrying capacity of csg dam construction materials

    壩築壩材料特性與抗荷載能力研究
  16. The arrangement of the monomers-controllable during the polymerization process-gives the material the characteristics we need.

    在聚合過程中進行人為控制，使單體的排列方式能給出人們所需要的材料特性。
  17. Cohesive models furnish a complete theory of fracture that is not limited by any consideration of material behavior, finite kinematics, non - proportional loading, dynamics, or the geometry of the specimen

    內聚模型作為一個完全的斷裂理論，不被任何材料特性、有限運動、非比例載荷、動力學或是試件的幾何尺寸所限制。
  18. Effects ofconfiguration, material properties and geometrical parameters were considered in thenumerical study

    分析時考慮了構造形式、材料特性和幾何參數三個方面的影響。
  19. So how to transfer scientifically self - balanced test data into top load curve according to its actual working behavior, become the obstacle of its practical application. in accordance with actual forcing behavior and reaction mechanism between pile and soil, the article analyzes the relation between top part and bottom part, load transferring mechanism and difference with other loading way by ansys program. so the reliability of determine bearing capacity by self - balance method has been proved

    本文根據自平衡加載方式下樁身的實際受力狀況、樁土間的相互作用機理以及單樁破壞機理，建立了單樁的離散元模型，採用ansys通用分析軟體，選取合理的單元類型、材料特性等，數值分析了基樁在自平衡加載方式下上下樁段的相互關聯、荷載傳遞機理以及與其它加載方式的區別，論證了採用自平衡試樁法測定單樁極限承載力的可行性。
  20. Based on several actual cases, the temperature control measures for roller compacted concrete ( rcc ) gravity dam and arch dam such as structural jointing for construction ; lowering of concrete placing temperature ; water pipe cooling ; surface insulation ; inclined - layer placing etc., the measures to improve the material properties i. e. the application of micro - expanding concrete ; enhancement of material crack - resistance property and the requirement for the simulative analysis on both the temperature field and stress field as well as some problems concerned are summarized herein on the basis of the analysis on the material properties ; construction characteristics and the changing characteristics of the thermal stress of roller compacted concrete

    摘要從碾壓混凝土的材料特性、施工特點、溫度場溫度應力的變化特點入手，結合幾個工程總結了碾壓混凝土重力壩、拱壩的分縫方式，降低澆築溫度、水管冷卻、表面保溫、施斜層碾壓等溫控措施，採用微膨脹混凝土、提高材料抗裂性能等改善材料性能措施及碾壓混凝土溫度場、應力場模擬分析的要求和應注意的問題。
分享友人
分享到 Line

分享到臉書