板極電流 的英文怎麼說

中文拼音 [bǎnjídiànliú]
板極電流 英文
anode current
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Mems ( micro electromechanical system ) has become one of the most rapidly development technologies. along with the rapid development of mems techniques, capacitive sensor is used widely whose capacitance changes small, which has put forward the new request to the measurement technique. the common measure for capacitance measurement is that convert capacitance to voltage, electric current or frequency. the area of polar plate of the capacitor becomes smaller and smaller, and the total capacitance of micro capacitive sensor is usually several pico farad only. as a result, its change amount is smaller

    Mems （ microelectromechanicalsystem ）近年來發展最快的技術之一，隨著mems技術的快速發展，電容式加速度計的電容變化變化量越來越小，對檢測技術提出了新的要求。在電容式傳感器中，常用電容檢測電路是將其轉換為電壓、電流或者頻率信號。目前的微型電容傳感器的極板面積變得越來越小，電容總量只有幾個pf ，變化量就更小。
  2. Hf - current in monopolar electrosurgery flows from an active electrode ( i. e. the instrument ) through the patient ' s body to a neutral electrode, patient plate, applied o his / her body

    在單極高頻外科手術中，高頻電流從活動電極（例如儀器本身）流經病人身體到達中性電極（附著在病人身體的病人板）
  3. The distributions of current density and potential on the negative plates with the radiational or expanded grid designs are more uniform than those on the positive plate

    輻射式和拉網式負極板在化成開始時電流密度和電位的分佈都比正極板上分佈均勻得多。
  4. At the end of the formation, both current and potential distributions are uniform. however, their distributions on the negative plate with the expanded grid design are a little more uniform

    化成結束時電流密度和電位分佈都比較均勻，且拉網式負極板比輻射式負極板更均勻。
  5. When formed for 8h, because most of paste on the negative plate has converted into lead, the polarization increases and the potential changes greatly, these distributions on the two kinds of negative plates become non - uniform again

    當化成8h時，由於負極板上的鉛膏大部分轉化為鉛，極化上升，電位變化很大，所以兩種負極板上電流密度和電位分佈又變得不均勻。
  6. This paper researches on the practical current and potential distributions on the positive and negative plates of automotive batteries in the course of their formation processes by the means of an in situ electrochemical scan, and then studies the influences of the formation and also the additives on the performance of the automotive plates

    本文利用電化學掃描方法研究鉛酸蓄電池正負極板在化成過程中電流密度和電位分佈及化成對極板電性能的影響。同時分析了正負極添加劑的性質及其對極板性能的影響。
  7. We have done a serial of experiments to study the pam and anode grid with the aids of the measurement such as constant current charge / recharge, cyclic voltammetric measure ments, electric impedance spectrum and so on

    我們通過恆電流充放電、交流阻抗和循環伏安等實驗方法和測試手段對鉛酸電池的正極活性物質和板柵進行了一系列的研究。
  8. Clutch rotor and brake are fixed on the output shaft, and the input armature plate can be set onto the input flywheel so that when the clutch is energized the fly wheel will drive the output shaft. when the clutch is disengaged and the brake is energized the output shaft will stop

    離合器之轉子與剎車器被固定在出力軸上，入力的電極板可固定在入力的飛輪上，當電流通過離合器時飛輪帶動出力軸，當離合器分離時，剎車有電流通過出力軸就停止。
  9. When the plate was connected to the negative terminal there was no current.

    如板極接到電池的負極，電流即不存在。
  10. And it is well known that the non - uniform current and potential distributions on the plate can obviously affect the active mass utilization, especially for the positive plate

    而且極板上不均勻的電流和電位分佈會明顯影響活性物質的利用率，尤其是正極板。
  11. When it is discharged at high - rate, the distributions are also the most uniform at the end of the discharge. this indicates that the positive plate with the red lead has the better discharge performance than the other two kinds of positive plates

    含紅丹的正極板在化成初期電流密度和電位的分佈最均勻，極化最小，在高倍率放電結束時，其電流密度和電位分佈也最均勻，表明含紅丹的正極板的放電性能比其它兩種正極板好。
  12. Combined with development of the products, the research emphasis in this paper is focus on the studies of the high - rate discharging performance at different temperature. 1. in the research of the discharge performance with high rate, the results of different effects including thickness of positive electrode, materials of hydrogen storage alloy, concentration of the electrolyte and separators

    論文在實現研究目標的過程中，結合產品的研製，重點對電池的高倍率放電性能和溫度性能進行了研究：一、在提高電池大電流放電性能的研究中，比較了不同正極板厚度、不同貯氫合金材料、不同濃度電解液及不同材料隔膜等對電池大電流放電平臺的影響，並從電極反應動力學和多孔電極的角度分析了極板厚度對電池高倍率放電的影響。
  13. It has important significance to study the welding technology of variable polarity pulsed mig for high efficiency weding and good quality of welding products. we should control the welding current, output voltage and the process of melting drop more effectively

    研究薄板鋁合金變極性脈沖mig焊接技術，更有效地控制焊接電流、電壓輸出和熔滴過渡過程，提高焊接過程的穩定性、提高焊接速度，對于提高焊接效率和焊接產品質量具有重要的意義。
  14. Because of the limitation of experimental conditions we failed to form foam lead grid in the experiment. copper draw net is used as anode grid and it can improve to some extent the utilization of pam. due to human errors in the experiment we have not used the same discharge current density

    在實驗中我們試圖通過鑄造法、電鍍法和還原法等一系列的實驗辦法製作泡沫鉛板柵，由於實驗條件的限制，沒能夠成功制得泡沫鉛，而在使用銅拉網作為正極板柵的時候，能夠使電池的正極活性物質利用率有提高，但由於實驗時候的失誤，沒能夠使用相同的放電電流密度進行放電，我們無法利用實驗數據比較出具體能提高的數字。
  15. During the formation, the positive plates with red lead and bapbo3 additives are easier formed than that without additive, so the current and potential distributions on the plates with additives are more uniform than that without additives in the early stage of the formation. these distributions on the plate with red lead are the most uniform, and the polarization is the smallest

    在正極板化成過程中，含紅丹和鉛酸鋇鉛膏的正極板比不含添加劑的正極板更容易化成，所以在化成初期含添加劑正極板的電流密度和電位分佈比不含添加劑正極板上的電流密度和電位分佈更均勻。
  16. We have made three - dimension electric conduct grid by hand and we have successfully used it as anode grid in lead - acid battery. this kind of three - dimension electric conduct grid can improve the utilization of pam by 7 - 9 % in different discharge current density and can reduce the plate electrochemical impedance to one tenth of the normal plate. also this kind of grid can improve the marginal reaction current density in a certain degree

    我們通過手工製作了三維導電體板柵，並成功的應用於電池的正極作為正極的板柵，這種三維導電體板柵能夠在各種不同的放電電流密度下提高正極活性物質利用率7 9 ，能夠使電池正極板的電化學阻抗降低到普通板柵的1 10左右，使正極板的極哈爾濱j _程大學碩十學位論文限反應電流密度略有所提高，但是這種板柵的耐腐蝕性能很不理想，使得所製作電池的壽命很短。
  17. From the experiment we have found out that the carbon fibre can improve the anode performance when it was used as pam additive and meanwhile it can have some benefits to the anode life. when its content at 0. 2 - 0. 3 % in pam can achieve its best result and under this situation it can improve the utilization of pam by 5 % at different discharge current. carbon fibre and sulfate sodium is used as complex pam additive and its effect is better than that of carbon fibre which alone is used as additive

    通過實驗我們發現，碳纖維作為鉛酸電池的正極活性物質添加劑能提高鉛酸電池正極的性能，並且對電池正極板的壽命有一定的好處，當碳纖維在正極活性物質中的含量為0 . 2 0 . 3能得到最理想的效果，這個時候能在各種不同的放電電流下提高正極活性物質的利用率5左右，並且能夠使極板的電化學阻抗降低。
  18. Sub - c mh - ni power batteries were prepared with excellent electrochemical performance based on the research of the high rate performance at different temperature. the change of temperature, impedance and weight loss was investigated in the process of recycle at high rate. it showed that the discharge time is 5. 9min at 10c and the middle voltage is 1. 05v

    三、根據對電池大電流和溫度性能的研究，研製了具有較好電化學性能的動力型鎳氫電池，並分別測試了電池在大電流循環過程中的溫度、內阻、重量和正負極板等的變化情況，以此分析引起電池性能衰減的原因。
  19. Based on some discussions on the mathematic model set up for the cathodic protection potential field, a two - dimensional boundary element method ( bem ) is developed, and by using which, a study on the shielding effect resulted from some typical inner structures such as the reinforcing elements and the partition walls with man holes on distribution of potential and current density in the cathodic protection is performed. the investigated parameters which affect the shielding effect in the calculating model include : the height and thickness of the reinforcing elements, the distance between the anode and the reinforcing elements, and the diameter of man hole on the partition walls, and so on

    本文在討論了陰極保護電位場問題的數學模型的基礎上，以二維邊界元法對陰極保護問題中的電位及電流密度分佈進行了模擬計算，重點對船舶壓載艙中的典型結構如加強筋、人孔等在陰極保護中所產生的屏蔽效應進行了分析和研究，通過對不同高度、厚度的擋板及不同孔徑的帶孔板所產生的屏蔽效應進行模擬計算，首次得到了一些對實際工程設計具有重要參考意義的見解。
  20. This subject is a research about manufacturing silicon magnetic - transistor with rectangle - plank cubic construction on silicon surface by mems technology, meanwhile it also makes a experiment - research on characteristic of silicon magnetic - transistor manufactured experiment expresses that silicon magnetic - transistor with rectangle plank cubic construction which is made by mems technology owns many virtues, which are as follows : first, stronger v - i characteristic curves and higher magnetic sensitivity ( collector current magnetic sensitivity of sample can achieve to 227 % / t ), second, lower negative - temperature coefficient that is small

    本課題主要研究採用mems技術在矽片上製作矩形板狀立體結構硅磁敏三極體，並對製作的硅磁敏三極體樣品基本特性進行實驗研究。實驗結果表明本課題採用mems技術設計、製作的矩形板狀立體結構的硅磁敏三極體樣品具有較理想的伏安特性曲線、具有較高的磁靈敏度（樣品集電極電流磁靈敏度可達227 / t ） 、具有負溫度系數且溫度系數較小、在磁場一定時i _ c i _ b線性關系較好等優點。
分享友人
分享到 Line

分享到臉書