板極電 的英文怎麼說

中文拼音 [bǎnjídiàn]
板極電 英文
plate voltage
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  1. When formed for 8h, because most of paste on the negative plate has converted into lead, the polarization increases and the potential changes greatly, these distributions on the two kinds of negative plates become non - uniform again

    當化成8h時，由於負極板上的鉛膏大部分轉化為鉛，極化上升，電位變化很大，所以兩種負極板上電流密度和電位分佈又變得不均勻。
  2. These surface charges partially nullify the effect of the charges on the metal plates.

    這些表面電荷部分地抵消金屬極板上電荷的作用。
  3. Gas metal arc welding of galvanized steel, 10 through 18 gage, in the as - welded condition, with or without backing

    在焊接條件下有或沒有墊板10到18規格的鍍鋅鋼的氣體保護金屬極電弧焊
  4. When the plate was connected to the negative terminal there was no current.

    如板極接到電池的負極，電流即不存在。
  5. Lead - acid traction batteries 6 v and 12 v ; monobloc batteries with tubular positive plates ; nominal capacities, main dimensions, weights

    6v和12v牽引用蓄電池.帶有管狀板極的單殼蓄電池.額稱
  6. As is known to all, the former pcb system uses an out - chip oscillator, which is called out - chip clock generator, to provide system with clocks

    比如以前的板極系統多數使用電路板上的外部振蕩電路作為系統的時鐘發生器。
  7. With the development of semiconductor process technology, nowadays a system on a pcb ( printed circuit board ) which is composed of several ics can be integrated into a chip

    隨著集成電路製造工藝的飛速發展，人們已經可以將原先用各種電路搭建的板極系統集成在一塊晶元上。
  8. Integrated circuit design has entered into the era of system on chip ( soc ), the bus interconnect architecture of system on board have also developed into a kind of hierarchy architecture - on chip bus ( ocb )

    隨著集成電路設計進入到系統晶元（ soc ）時代，板極系統的總線互連結構也發展成為系統晶元的層次化總線體系一片上總線。
  9. During the formation, the positive plates with red lead and bapbo3 additives are easier formed than that without additive, so the current and potential distributions on the plates with additives are more uniform than that without additives in the early stage of the formation. these distributions on the plate with red lead are the most uniform, and the polarization is the smallest

    在正極板化成過程中，含紅丹和鉛酸鋇鉛膏的正極板比不含添加劑的正極板更容易化成，所以在化成初期含添加劑正極板的電流密度和電位分佈比不含添加劑正極板上的電流密度和電位分佈更均勻。
  10. We have made three - dimension electric conduct grid by hand and we have successfully used it as anode grid in lead - acid battery. this kind of three - dimension electric conduct grid can improve the utilization of pam by 7 - 9 % in different discharge current density and can reduce the plate electrochemical impedance to one tenth of the normal plate. also this kind of grid can improve the marginal reaction current density in a certain degree

    我們通過手工製作了三維導電體板柵，並成功的應用於電池的正極作為正極的板柵，這種三維導電體板柵能夠在各種不同的放電電流密度下提高正極活性物質利用率7 9 ，能夠使電池正極板的電化學阻抗降低到普通板柵的1 10左右，使正極板的極哈爾濱j _程大學碩十學位論文限反應電流密度略有所提高，但是這種板柵的耐腐蝕性能很不理想，使得所製作電池的壽命很短。
  11. From the experiment we have found out that the carbon fibre can improve the anode performance when it was used as pam additive and meanwhile it can have some benefits to the anode life. when its content at 0. 2 - 0. 3 % in pam can achieve its best result and under this situation it can improve the utilization of pam by 5 % at different discharge current. carbon fibre and sulfate sodium is used as complex pam additive and its effect is better than that of carbon fibre which alone is used as additive

    通過實驗我們發現，碳纖維作為鉛酸電池的正極活性物質添加劑能提高鉛酸電池正極的性能，並且對電池正極板的壽命有一定的好處，當碳纖維在正極活性物質中的含量為0 . 2 0 . 3能得到最理想的效果，這個時候能在各種不同的放電電流下提高正極活性物質的利用率5左右，並且能夠使極板的電化學阻抗降低。
  12. In order to improve the circuit ' s input impedance, which is affected by insulating resistance of electrode leading wire, terminals and printed circuit board, electrode is connected to the meter through insulating wire of high impedance which is directly welded in the printed circuit board with insulating ring. the deviation of electrode is corrected by software and the algorithm is given

    使用高阻絕緣線連接電極，並將高阻絕緣線直接焊在加有絕緣環的印刷線路板上，從而消除電極引線、接線端子和印刷線路板漏電對放大電路輸入阻抗的影響；軟體校正電極偏差，並給出校準演算法。
  13. The composition and mechanism of cdse thin films were explored by x - ray energy dispersion analysis ( eds ) and x - ray penetration spectrum ( xps ). the effect of electro - deposition conditions such as potential ( vs. sce ) of cathode, concentration of electrolyte on composition and mechanism of as - fabricated cdse thin films were gained, which provided experimental foundation and ideal basis for template - electro - deposition preparation of cdse nano - wire arrays

    採用eds和xps兩種分析方法對cdse薄膜的組成進行了表徵，得到了陰極電位值（ vs . see ）和電解液濃度對edse薄膜組成的影響關系，為以hzseo3和seso32 -為硒源，用模板一電沉積法制備cdse納米線陣列提供了實驗依據和理論基礎。
  14. A corrugated or perforated conducting plate in a storage battery

    極板網柵，蓄電池電極板蓄電池中呈波紋狀或有孔的導電板
  15. They are as follows : powder types, electrode voltage and board space etc. and the optimized parameters obtained in the normal temperature spray experiments were applied in the thermal spray

    通過冷噴實驗，找到了影響收集西安理工大學碩士學位論文效率的因素有:粉末類型、電極電壓以及極板間距等。並將冷噴時的最佳參數應用於熱噴塗制粉末的收集中。
  16. The error of the capacitance, electrostatic force and sensitivity between the computed values got from these models and the simulated values got from ansys for different angle of decline are researched

    用有限元工具ansys中的電場模塊，分析了傾斜電容極板的電場邊緣效應。分析了文中所用的電容和靜電力模型的計算值和模擬值間的誤差。
  17. Electron emission characteristics have been investigated for amorphous diamond films with low or even negative electron affinity

    摘要利用陰極電弧法分別在矽基板及鍍有一層釤金屬的矽基板上沉積非晶鉆石。
  18. Lead - acid stationary cells and batteries - specification for the flat positive plate type

    鉛-酸固定式電池和蓄電池.平陽極板式電池規范
  19. The contribution of anodic electric field to cathodic protection potential distribution of a tank bottom for different depths of anode and different horizontal distances between anode and tank is studied through calculating examples

    摘要通過計算實例研究了在不同的陽極埋深和距罐體水平距離下陽極電場對罐底板外側陰極保護電位分佈的貢獻。
  20. This subject is a research about manufacturing silicon magnetic - transistor with rectangle - plank cubic construction on silicon surface by mems technology, meanwhile it also makes a experiment - research on characteristic of silicon magnetic - transistor manufactured experiment expresses that silicon magnetic - transistor with rectangle plank cubic construction which is made by mems technology owns many virtues, which are as follows : first, stronger v - i characteristic curves and higher magnetic sensitivity ( collector current magnetic sensitivity of sample can achieve to 227 % / t ), second, lower negative - temperature coefficient that is small

    本課題主要研究採用mems技術在矽片上製作矩形板狀立體結構硅磁敏三極體，並對製作的硅磁敏三極體樣品基本特性進行實驗研究。實驗結果表明本課題採用mems技術設計、製作的矩形板狀立體結構的硅磁敏三極體樣品具有較理想的伏安特性曲線、具有較高的磁靈敏度（樣品集電極電流磁靈敏度可達227 / t ） 、具有負溫度系數且溫度系數較小、在磁場一定時i _ c i _ b線性關系較好等優點。
分享友人
分享到 Line

分享到臉書