板理論 的英文怎麼說

中文拼音 [bǎnlǐlún]
板理論 英文
anisotropic plate theory
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 理論 : theory
  1. In the analysis of balsa, kirchhoff ' s thin plate theory is important

    在板的分析中， kirchhoff的薄板理論佔有重要地位。
  2. A review on the research on hindsight bias

    模板理論與限制調節理論的比較研究
  3. In light of the elastic thin plate theory, the author induced equilibrium differential equation of bi - direction cellular slab, which was proved correct through analysis and comparison to result of ansys to with theoretical calculation. through the deflection and bending moment coefficient calculation of bi - direction cellular slab under various boundary conditions, the author brought forward the theory that the deflection of mid - span and bending moment coefficient calculation of mid - span and support of bi - direction cellular slab could be in accordance with solid plates ", which could satisfy the precision of engineering

    本文根據彈性薄板理論，導出了雙向空腹板的平衡微分方程，並通過理論計算和通用有限元程序ansys結果對比，驗證了其正確性；通過對各類邊界條件下雙向空腹板撓度和彎矩系數的計算比較，本文提出：雙向空腹板跨中撓度及跨中、支座彎矩可使用本文空腹板剛度公式查找現有的實心板撓度彎矩系數表進行計算，完全能滿足工程精度要求。
  4. The new technique allows first order shear deformation plate theory ( fsdpt ) or classical plate theory ( cpt ) to be used for modeling built - up wing structures, sandwich wing structures or the wing structures which the volume between upper and lower skin is empty or solid with a ' general planform

    根據翼面的幾何和結構特點，新技術能夠自主選擇經典板理論（ classicalplatetheory ，簡稱cpt ）或第一階剪切變形板理論（ firstordersheardeformationplatetheory ，簡稱fsdpt ） ，具有模擬空心、實心、夾層和組合等形式的翼面結構及三維建模的能力。
  5. The elastic foundation model is considered as two - parameter elastic foundation model and its effect to moderate - thick plates are taken into account by a set of governing differential equations. united with hu hai - chang ’ s function, least squares collocation weighted residual method which uses b - spline function as trial function is put forward for solving the bending problems. compare with the results of finite element method of lines, spline finite strip method, accurate solution of series etc. it is proved that the method in this article has adequate accuracy and practical feasibility

    本文採用瑞斯納中厚板理論求解彈性地基板，建立雙參數地基與中厚板相互作用的控制微分方程，結合胡海昌的解耦函數，運用雙五次b樣條函數作為試函數的離散型最小二乘加權殘值法分析了雙參數地基上的中厚板的彎曲問題，並將結果與有限元線法、有限條法、級數精確解等進行比較，證明本文方法具有足夠的精確性與實際的可行性。
  6. Study on the characteristic of piezoceramic actuator is an important step in the studying of undamaged - inspection process based on piezoceramic actuator technology. this thesis firstly dwells on the sample model of piezoceramic actuator under the restriction of concrete. through theory and experimentation analysis, we arrives at a conclusion that the vibration behavior of piezoceramic actuator belongs to that of the thin plate

    本文著重研究了在混凝土約束條件下壓電陶瓷片的樣本模型，在此基礎上通過理論探討和實驗現象分析，認為埋置於混凝土中的壓電陶瓷片是符合彈性力學中克希霍夫有關薄板理論的假設，是屬于薄板振動問題，並確定了其邊界約束條件。
  7. Generally, the skew bridge ' s calculation theories can be divided into three types : the category 1 is the plank theories method, such as the finite difference method, the finite element method and the finite strip method, etc ; the category 2 is the beam theories, such as the grid beam theories, the general grid theories, the rigid cross - beam method, the elastically - supported continuous beam method and the bar system analytical method, etc ; the category 3 is the practical method, such as the g - m revising method, the grid - beam simple method and ghali form coefficient method, etc

    目前關于斜梁橋的計算理論和方法概括起來，大致可以分為三類：第一類為板理論方法，如有限差分法、變分法、有限單元法、有限條法等；第二類為梁理論法，如格構梁理論、一般格構理論、剛性橫梁法、彈性支承連續法、桿件結構的分析方法；第三類為實用計演算法，荷載橫向分佈的計算方法如g ? m修正法、格構梁的簡易法、 ghali表格系數法等。
  8. Using the complex potential method in the plane theory of elasticity of an anisotropic body, the series solution of finite anisotropic thin plate containing an elliptical inclusion is proposed with the help of faber series. a hybrid element with an elliptical inclusion for anisotropic materials is obtained by using the hybrid variable principle, and the element efficiency is verified by numerical examples. the state of the damage is modeled by an elliptical soft inclusion, and using the point stress criterion based on characteristic curve and yamada - sun etc. criteria, the prediction of the strength of a composite laminate with damage is set up

    首先基於經典層板理論，將復合材料層板的彈性問題化歸為均勻各向異性板來求解；採用各向異性體平面彈性理論中的復勢方法，以faber級數為工具，給出了有限大含橢圓核各向異性板彈性問題的級數解形式；利用雜交變分原理，成功導出含橢圓核各向異性板雜交應力有限元，並用算例驗證了該單元的可行性和有效性；採用含剛度折減橢圓形彈性核的沖擊損傷模型，引入基於特徵曲線和yamada - sun破壞準則的點應力判據，建立了含損傷復合材料層板剩餘強度的分析方法；通過數值計算詳細討論了各種幾何參數對損傷層板應力分佈、剩餘強度的影響，得到了一系列對工程應用具有實用價值的結論。
  9. As regards to the spheric thin shell structure under external hydro static pressure, basing on flat - plate theory and by using basic von karman equations for large deflection, the equilibrium problem of axisymmetric bending of the spheric shell under uniform external pressure is simplified to an equilibrium problem of bending of elastic basic flat - plate and further converted into an equilibrium problem of beam on elastic fundation taking into consideration of the deformation characteristics

    對球形薄殼結構隨靜水外壓的情況，應用平板理論中的vonkarman大撓度基本方程，將球形薄殼在均勻外壓下的軸對稱彎曲平衡問題簡化為彈性基礎平板的彎曲平衡問題，進而再根據變形特點將其轉化為彈性基礎梁的復雜彎曲平衡問題。
  10. The research is presented based on the classical laminate theories for special boundary conditions and few papers have been formulated based on higher - order laminate theories with various cases of boundary conditions. the paper will create the structural - engineering program with mathematica to solve the problem of composite laminated plates based on higher - order laminate theories with various cases of boundary conditions

    目前僅局限於有特殊邊界條件的古典板理論，很少有文章涉到各種邊界條件的高階板理論。本文將利用mathematica的計算環境，編制結構分析程序，在各種邊界條件下，應用多種板理論求解各向異性矩形層合板的振動控制問題。
  11. Bending theories for beams and plates with single generalized displacement

    單廣義位移的深梁理論和中厚板理論
  12. Two different raft analysis theories, namely, plate theory and thick raft theory, are also introduced in the paper

    本文還分別介紹了兩種採用不同假設的筏板計算理論：薄板理論和厚板理論。
  13. The largest coal - fired power set - theoratical calculation and design of extra - large boiler ' s foundation slab of phase - shanghai waigaoqiao power plant

    上海外高橋電廠二期工程特大型鍋爐基礎厚板理論計算的探討和設計
  14. The theory of moderately - thick plate is theorized along with not only the development of science and technology but also the widespread application in the productive practice

    中厚板理論是隨著科學技術的發展和其在生產實踐中的廣泛應用而發展起來的。
  15. Based on the classical nonlinear plate theory, axisymmetric post - buckling behavior of a functionally graded circular plate under radial compression was investigated

    摘要基於經典非線性板理論，研究了功能梯度圓板在均勻的徑向壓力作用下的軸對稱過屈曲問題。
  16. In designing and calculating plate of piled - raft foundation, thick - plate theory has been applied, that is, thick - plate finite element method is mainly used when load and deformation of plate are analyzed

    樁筏基礎筏板的設計、計算採用厚板理論分析，主要用厚板有限元法來分析筏板的受力、變形特點。
  17. A progressive damage method of predicting the static strength and the fatigue life of mechanically fastened joints in fibre - reinforced plastics is established in the paper, which is based on the theory of unidirectional ply

    本文針對以上問題，首先以單層板理論為基礎，建立了層合板接頭靜拉伸及疲勞載荷作用下三維逐漸損傷分析的強度和壽命預測方法。
  18. Based on the method of cell ( moc ), the effective elastic properties of resined fiber bundle with parallel or arbitrary orientation was studied, and a micro - mechanical model of resined plain - woven carbon fabric was established with the classical laminate theory, then, the method of calculation of the elastic moduli of resined plain - weave carbon fabric was presented, and can be extended to the whole carbon / phenolic composite

    基於元胞法（ moc ）計算了預浸樹脂的平直以及任意取向的纖維束的有效彈性常數。基於經典層板理論用替代層法建立了預浸樹脂平紋機織碳布的細觀力學模型，進而給出了預浸氨酚醛樹脂的平紋機織碳布的彈性模量的計算方法，該方法可推廣到碳酚醛復合材料。
  19. In this article, it is systematically introduced the kirchhoff ' s thin plate theory and the reissner ' s moderately - thick plate theory in which the transverse shear force has been taken into account further the different hypotheses of the two theories are analyzed then the difference of the two theories is found out

    本文系統地介紹了kirchhoff薄板和考慮橫向剪切力作用的reissner中厚板的相關理論，分析了薄板、中厚板理論的兩種不同假設，找到了二種理論主要區別。
  20. On the basis, three elastic calculation coefficients of the two - way composite slab on three common boundary conditions are deduced and calculated by applying the classic elastic plane theory. in the thesis, the elastic design methods of pk prestressed composite two - way slab is explored and studied by the example. furthermore, it is also studied how to apply the yield - line design method to design the prestressed two - way composite floor slabs

    本文以此為依據，應用經典彎曲薄板理論，採用李維法推導和計算了這種雙向樓板三種常見邊界下的撓度和內彎矩彈性計算系數，並在此基礎上通過算例探討了pk預應力雙向疊合樓板的彈性設計方法，同時還對其塑性鉸線設計方法進行了研究。
分享友人
分享到 Line

分享到臉書