析出氧氣量 的英文怎麼說

中文拼音 [xīchūyǎngqìliáng]
析出氧氣量 英文
amount of oxygen precipitation
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 氣量 : 1 （容忍謙讓的限度; 度量） tolerance 2 （舊指才識和品德的高低） ability and insight; 氣量表 gas m...
  1. Elastic collision and inelastic collision are considered in oxygen molecule, nitrogen molecule by electron impart. the mail simulation results were as follow : ( 1 ) the variations of drift velocity and the average energy of electron with the e / n in o2 and n2 are obtained. the number of electrons for excitation, ionization, dissociation and dissociative ionization collision with the e / n and the energy of electron are analyzed emphatically

    考慮了各種彈性和非彈性碰撞過程，在純氧氣、純氮氣中，給出了不同簡化場e n條件下的電子漂移速度和平均電子能量的變化；著重分析了激發、電離、分解及分解電離碰撞的粒子數隨e n 、電子能量的變化，同時計算了激發發射光譜的波長。
  2. Liberation of hydrogen gas would be increased rapidly and sic particles on the surface might be dispersed if the current density exceed the upper limit. furthermore, nickelous hydroxide would be deposited because the ph of plating solution nearby the surface rapidly increased. all of above might result in coating deterioration

    若電流密度過大，超過所允許的上限值，會析出大量的氫氣，可能沖散表面覆蓋的sic微粒，而且易使磨頭表面鍍液ph值急劇上升而形成氫氧化鎳沉澱，導致鍍層質量惡化。
  3. The primary theory of absorption and desorption was also explained. the effects of primary process parameters, such as hydrogen pressure, time and temperature on the magnetic properties of ndfeb have been researched. the structure and magnetic properties have been analyzed by means of optical metallographic microscopy, scanning electronic microscopy, x - ray diffraction analysis, infrared oxygen detector and magnetic properties measurement

    本文設計了燒結ndfeb的氫爆制粉設備，對設備調試以及使用過程中出現的主要問題進行了簡要的說明，提出了一系列解決方法；闡述了吸氫、脫氫的基本原理；研究了氫氣壓力、通氫時間、氫爆溫度等基本工藝參數對磁性能的影響；利用金相顯微鏡和掃描電子顯微鏡， x射線衍射分析，紅外線測氧分析及綜合磁性測量儀等手段分析了材料的組織結構和磁性能。
  4. In contrast with the measurement of backscattered ultraviolet solar radiation onboard satellites, ir radiance measurements in 9. 6m spectral channel at various instruments onboard meteorological / environmental satellites allow ozone estimates during both day and night. in this paper, we use ir radiance measurements within 9. 6 im spectral channels from moderate resolution spectral radiometer ( modis ) and advanced tiros operational vertical sounder ( atovs ) to retrieve total column ozone based on the operational retrieval system of national satellite meteorological center. for validating retrieval results, both ground based observation and total ozone mapping spectrometers ( toms ) ozone measurements are used and atovs retrieval results are corrected after the validation

    本文利用美國noaa衛星上的先進的大氣垂直探測器業務系統（ atovs ）儀器和地球觀測系統衛星（ eos ）上的中解析度成像光譜儀（ modis ）上的9 . 6 m臭氧探測通道的輻射測值，在國家衛星氣象中心業務反演軟體系統基礎上，反演出了兩種儀器探測的大氣臭氧總量，並且利用中國五個常規臭氧觀測站的資料和美國研製的臭氧總量測繪光譜儀（ toms ）反演的臭氧資料對兩種反演結果進行驗證分析，對atovs反演結果進行了訂正。
  5. Sige simox : oxygen ions with high dose were implanted into sige grown directly on silicon substrate for the first time, and sige - oi novel structure was formed successfully with additional high temperature annealing ; it has been confirmed that oxygen implantation with 45kev, 3 1017cm - 2 and annealing at 12500c in ar + 5 % o2 for 5 hours, are fit for the formation of sige - oi structure ; ge loss during the high temperature annealing has been observed, which is originated from ge volatility and ge diffusion ; it has been proposed to use nanoporous layer induced by h + / he + implantation to surppress ge diffusion and to use surface oxidation to overcome the upper limit of sige simox. sige smart - cut : hydrogen ions were implanted into sige material and followed by high temperature process ( 4000c to 7000c ) ; blistering study was done and suggested the possibility of sige layer transfer by smart - cut technology ; it is concluded that the bubble formation is easier in sige than in si, and the strain in sige / si and the difference of binding energy in sige and in si could possibly contribute to this effect. behavior of sige / si implanted with hydrogen : gave a detailed study on sige implanted by beamline or phi hydrogen implantation ; it has been found that great strain is introduced into sige by hydrogen implantation and this strain could be alleviated by high temperature annealing ; both for conditional beamline implantation and piii hydrogen implantation, 600 is appropriate for the post - implantation treatment

    Sige - simox工藝方面：首次採用硅（ 100 ）襯底上直接外延的100nm厚sige的樣品中注入高劑量的o離子，通過退火處理成功制備了sige - oi新結構，即sige - simox工藝，證實了以45kev注入3 10 ~ （ 17 ） 7cm ~ （ - 2 ）劑量的氧離子，隨后在氧化層的保護下經1250 ， ar + 5 o _ 2氣氛的高溫退火（ 5小時）過程，可以制備出sige - oi新型材料；實驗中觀察到退火過程中的ge損失現象，分析了其原因是ge揮發（ ge通過表面氧化層以geo揮發性物質的形式進入退火氣氛）和ge擴散（ ge穿過離子注入形成的氧化埋層而進入si襯底中） ，其中ge擴散是主要原因；根據實驗結果及實驗中出現的問題，對下一步工作提出兩個改進的方案：一是通過在si襯底中注入適量h ~ + / he ~ +形成納米孔層來阻斷ge擴散通路，二是可以通過控製表面氧化來調節安止額士淤丈撈要表面sige層中的ge組分，從而部分解決sige
  6. The n type carrier was provided by interstitial zn atom, and zn / o ratio and crystalline quality of zno thin film effeted its hall mobility. when zno thin film was annealed in the ar ambience, p conduction type was founded in the zno thin film which grew in oxygen enrichment condition. this might be excess oxygen in zno thin film entered interstitial position of crystal lattice ( oi ), and p type carrier was from oi

    在ar氣保護下，對富氧條件下生長的zno薄膜的退火后的霍爾測量中發現， zno薄膜呈現p型導電狀態，分析認為，這可能是由於富氧狀態下生長的zno薄膜中過量的o在ar氣保護下退火沒有逸出薄膜，反而進入了zno薄膜的間隙位置，成為正電中心，使zno薄膜呈現p型導電。
  7. Secondly, through the survey of expert and the methodology of key success factor ( ksf ), it concludes the concrete ksfs of air product and water processing facility product. the ksfs of air product : brand name, service assurance, marketing network, large scale economic production, r & d ; the ksfs of water processing facility product : quality management, r & d, service assurance and marketing network - thirdly, through the methodology of value chain and core competence embodied with defined key success factor and main success factor, this paper analyses and evaluates the internal environment. it points out that air product has these advantages such as quality management competence, r & d competence, service assurance competence, large scale production competence, and has these disadvantages such as marketing network, brand name, cost control

    本文首先運用pest分析法和波特的五種競爭力量模型，對奧神公司的臭氧空氣系列產品和臭氧水處理工程產品所處的宏觀環境、競爭狀況進行了分析和評價，認為奧神公司產品面臨著國家產業政策扶持、不斷增長的環保需求、人們對清潔空氣和潔凈水的需求增長等發展機會，也面臨著行業市場不規范、市場競爭激烈、用戶討價還價能力強等威脅；其次，通過專家調查，運用關鍵成功因素理論，分析得出臭氧空氣凈化系列產品市場的關鍵成功因素是品牌建設、服務保障能力、營銷網路建設、規模經濟水平、產品研發能力：臭氧水處理設備市場的關鍵成功因素是質量管理能力、研發創新能力、服務保障能力、營銷網路建設；再次，運用價值鏈理論、核心競爭力理論並結合所確定的關鍵成功因素和主要成功因素對奧神公司產品所處內部環境進行了分析，認為臭氧空氣凈化系列產品擁有質量管理能力、產品研發能力、售後服務保障力、規模生產能力的優勢，同時面臨著營銷網路建設、品牌建設、成本控制能力方面的劣勢。
  8. But because of the characteristic of the open absorption refrigeration cycle, problems of continuous abstraction of uncondensable gas automatically and corrosion to pipe columns in the absorber when oxygen is separated from libr - h2o will appear. to solve them, more experiments and design efforts must be done in the future

    但由於開式循環的特點，產生的不凝氣體的連續自動抽除問題、溴化鋰溶液在析出的微量氧氣條件下對吸收器管束的腐蝕問題等，均需要通過實驗和系統完善設計的方法來加以解決。
  9. In this paper, the solar and land - atmosphere radiation rates are calculated by modtran3 model and satellite observation as well as surface data, solar direct irradiance infrared irradiance solar heating rate and infrared cooling rate were calculated from 43 samples of sunshine day and 5 samples of cloudy day 3 samples of rainy day of different latitudes in 12 stations. the paper analyzed solar heating rate and infrared cooling rate in sunshine day, the factors such as zenith angle, water vapor and latitude were found out correlating with solar heating rate and infrared cooling rate. solar heating rate and infrared cooling rate change on the same day and at the same station

    在對晴空大氣的計算中，本文對太陽的直接輻射與地氣系統的紅外輻射狀況進行了分析，並討論在不同的大氣狀況下太陽加熱率和紅外冷卻率的情況，找出與太陽加熱率和紅外冷卻率變化相關較大的因子?太陽天頂角和水汽條件、緯度；本文還進一步分析了不同緯度樣本的太陽加熱率與紅外冷卻率日變化及有雲、有雨情況下太陽加熱率和紅外冷卻率的變化情況：另外，文中通過改變二氧化碳在大氣中含量的方法，討論了它對太陽加熱率與紅外冷卻率的影響。
  10. It is shown that when the exit area of secondary nozzle and the fuel / oxidizer ratio is fixed, the increase of mass flow rate of secondary flow lead to the decrease of velocity of mixed flow, and increase of total mass flow rate. the synthetical result of these two phenomenon cause the increase of thrust of rocket ejector, but the increasing magnitude is relatively small, indicating that these is no necessary to claim large bypass ratio in rocket ejector design. in the comparison between two configurations, the typical one has better performance, indicating the importance of pressure ratio

    結果表明：在固定二次噴管出口面積和氧燃比的條件下，二次流（引射空氣流）流量的增加引起混合氣體出口速度的下降和總流量的增加，二者綜合作用使發動機推力增加，但增幅不大，表明在設計發動機結構和工作參數時，不必過分追求大的引射系數；兩種結構的性能對比分析表明了增壓比對引射火箭性能的提高具有重要意義；對引射火箭的熱力循環分析同樣表明，增壓比對于提高發動機性能非常關鍵。
分享友人
分享到 Line

分享到臉書