校準流量 的英文怎麼說
中文拼音 [jiàozhǔnliúliáng]
校準流量
英文
calibrated fluxes- 校 : 校名詞1. (學校) school 2. (校官) field officer3. (姓氏) a surname
- 準 : Ⅰ名詞1 (標準) standard; guideline; criterion; norm 2 (目標) aim; target Ⅱ動詞1 (依據; 依照)...
- 流 : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
- 量 : 量動1. (度量) measure 2. (估量) estimate; size up
- 流量 : rate of flow; flow; runoff; discharge; throughput; (flow) rate; quantity (of flow); flux
-
So it is used instead to calibrate more practical current-measuring instrument, called ammeters.
因此,它只用於校準更實用的測量電流的儀表安培計。Hydrometry - the application of propeller - type current meters and their calibration ; german version env 14028 : 2001
流速測量.螺旋式電流計的使用及校準Industrial - process control valves - flow capacity - sizing equations for fluid flow through multistage control valves with interstage recovery
工業過程式控制制閥.流通能力.通過有段間恢復功能的多段控制閥的流體流量的校準公式Industrial - process control valves - part 2 - 5 : flow capacity ; sizing equations for fluid flow through multistage control valves with interstage recovery
工業過程式控制制閥.第2 - 5部分:流通能力.通過有段間恢復能力的多段控制閥門的流體流量的校準公式Industrial - process control valves - part 2 - 5 : flow capacity - sizing equations for fluid flow through multistage control valves with interstage recovery
工業過程式控制制閥.第2 - 5部分:流通能力.通過有段間恢復能力的多段控制閥門的流體流量的校準公式Flow measurement calibration facility pipe prover
體積管式流量測量校準裝置Standard practice for rotameter calibration
轉子流量計校準的標準實施規程Using mass flux controller ( mfc ), gas regulation system achieved accurate mix of two kinds of gases, steel bottle gas ( some compressed gas ) and zero air ( pure air ). for the sake of data transmission between dynamic air regulator and other equipments in the monitoring air quality system, normal digital interface ( rs - 232c ) make correlative role of communication interface so that automatic survey could be achieved
本儀器採用國際先進的自動控制配氣原理,採用精密質量流量控制器( mfc )來控制鋼瓶氣(某種壓縮氣體)與零空氣(純凈無污染的空氣)的混合比來得到精確濃度的校準氣體,以便於對各種氣體監測儀進行高精度校準。Paper and board - calibration of variable - area flowmeters
紙和紙板.變積式流量計的校準Flow measurement calibration device
流量測量校準裝置Industrial - process control valves - part 2 - 1 : flow capacity - sizing equations for fluid flow under installed conditions
工業過程式控制制閥.第2 - 1部分:流通能力.安裝條件下流體流量的校準公式Verification method of dynamic liquid discharge and flow velocity facilities
動態流量與流速標準裝置校驗方法The two experiments on the shp calibration and the flow field measure of parachute are be finished with the use of the two kinds of shp measure system separately in wind tunnel. the analysis of the experimental process and data help a lot to both of the improvement of shp measure system and the shp experimental techniques
七孔探針校準實驗和降落傘流場測量實驗分別使用了上述兩套測試系統,通過對實驗結果進行分析,本文提出了在七孔探針校準和七孔探針測量時需要注意的若干問題,對這些問題的深入分析有利於七孔探針測試系統和七孔探針實驗技術的完善。Calibration specification for magnetical coupling measuring
磁耦合直流電流測量變換器校準規范Abstract : clibrating turbine flow meter is traditionally static meter - factor. this thesis introduces the theory and practice method of calibrating the dynamic character of turbine flow meter
文摘:渦輪流量計傳統上只進行穩態校準,即只校準其(穩態)儀表系數。本文闡述了校準渦輪流量計動態響應特性的理論和實施方法。Abstract : a combined formula of the constant speed sampling flow is induced through the calibration of a flow meter, the correction of a calibrated flow and the derivation of a real flow
文摘:通過對流量計的校準、校準流量的修正和真實流量的推導,歸納出等速采樣流量的綜合算式,並運用程序計演算法進行快速、準確地計算,真正實現等速采樣。In order to improve measurement precision and display fidelity of the instrument, three new methods of nonlinear calibration of thermal instruments, which are based on intelligent control theory, are presented in this paper, such as nonlinear compensation of zr02 oxygen measurement instrument using bp nn, nonlinear calibration of temperature measurement sensors using cmac nn and nonlinear identification of throttle flow meter using ga. these methods prove to be not only simple but also effective
火電廠熱工儀表普遍存在非線性特性,為了提高參數測量的準確度和儀表顯示的精確度,基於智能控制理論,文中提出了熱工儀表非線性校正的新方法: bp神經網路補償氧化鋯氧量計非線性特性的方法、 cmac神經網路校正測溫傳感器非線性特性的方法、遺傳演算法辯識節流式流量儀表非線性特性的方法。The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted
本論文根據umbirfpa的原理,建立它的軟體模擬系統,它可以根據給定的結構、環境、電路設置等參數首先模擬光熱、熱電轉換過程,並可根據電路結構,模擬校準、參數調節並讀出信號,給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵量的定量變化過程,預測製成后器件的各種性能參數。So it is used instead to calibrate more practical current - measuring instrument, called ammeters
因此,它只用於校準更實用的測量電流的儀表? ?安培計。The selection, installation, operation and calibration of diagonal path transit time ultrasonic flowmeters for industrial gas applications
工業氣體用對角線路徑通過時間超聲波流量計的選擇裝配操作和校準分享友人