校準試驗 的英文怎麼說

中文拼音 [jiàozhǔnshìyàn]
校準試驗 英文
calibration test
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 準 : Ⅰ名詞1 （標準） standard; guideline; criterion; norm 2 （目標） aim; target Ⅱ動詞1 （依據; 依照）...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Calibration tests are standard procedures applied to sensors not eliminated by screening tests.

    校準試驗是對篩選試驗中未被淘汰的傳感器進行試驗的標準測試程序。
  2. Standard test method for trace impurities in monocyclic aromatic hydrocarbons by gas chromatography and external calibration

    用氣相色譜法和外部校準法對單環芳香烴中微量雜質的標準試驗方法
  3. Standard test method for calibration of a pyranometer using a pyrheliometer

    用直接日射強度表校正日射強度計的標準試驗方法
  4. Test method for calibration verification of laser diffraction particle sizing instruments using photomask reticles

    用光掩模原版校準檢驗激光繞射粒子定尺寸儀器的試驗方法
  5. Standard test method for calibrating linear displacement transducers for geotechnical purposes

    土工技術用途的校正襯墊代替換能器的標準試驗方法
  6. Standard test methods for calibration of laboratory mechanical - rammer soil compactors

    實驗室機械搗實土壤壓實器校準的標準試驗方法
  7. Standard test method for calibration of pyrheliometers by comparison to reference pyrheliometers

    日射強度計與基準日射強度計進行比較校準的標準試驗方法
  8. Standard test method for elapsed time calibration thermal analyzers

    作用時間校正熱分析儀的標準試驗方法
  9. Standard test method for calibration and operation of the falex block - on - ring friction and wear testing machine

    法列克司環塊磨擦試驗機和磨損試驗機的校準和操作標準試驗方法
  10. Standard test method for calibration of atmospheric corrosion test chambers by change in mass of copper coupons

    通過銅試棒質量變化對大氣腐蝕試驗室進行校準的標準試驗方法
  11. The two experiments on the shp calibration and the flow field measure of parachute are be finished with the use of the two kinds of shp measure system separately in wind tunnel. the analysis of the experimental process and data help a lot to both of the improvement of shp measure system and the shp experimental techniques

    七孔探針校準實驗和降落傘流場測量實驗分別使用了上述兩套測試系統，通過對實驗結果進行分析，本文提出了在七孔探針校準和七孔探針測量時需要注意的若干問題，對這些問題的深入分析有利於七孔探針測試系統和七孔探針實驗技術的完善。
  12. Standard test methods for standardization and calibration of in - line dry lumber moisture meters

    直列式干木濕度計的標準化和校準的標準試驗方法
  13. Standard test method for calibration of surface stress measuring devices

    表面應力測量裝置的校準的標準試驗方法
  14. Standard test method for calibration of narrow - and broad - band ultraviolet radiometers using a spectroradiometer

    使用光譜輻射計校準窄帶和寬帶紫外輻射計的標準試驗方法
  15. Comparison analysis and experiments show that the calibration instrument can meet the need of laser speedometer calibration because of its wide calibration range, high repeatability and universal performance

    經各種校準方法的比較分析和校準試驗驗證，說明裝置校準范圍寬、重復性好、通用性好，可以滿足激光測速儀的校準需求。
  16. Standard test method for temperature calibration of thermomechanical analyzers

    熱機械分析儀溫度校準的標準試驗方法
  17. Test method for calibration of non - concentrator photovoltaic secondary reference cells

    非濃縮光伏副基準比對電池校準試驗方法
  18. Specification for radio disturbance and immunity measuring apparatus and methods - radio disturbance and immunity measuring apparatus - antenna calibration test sites for 30 mhz to 1 000 mhz

    無線電干擾和抗擾測量儀器和方法規范.無線電干擾和抗擾測量儀器. 30mhz至1000mhz的天線校準試驗裝置
  19. 5. the methods of temperature - correcting on copper cylinders and copper spheres are discussed. the method of unitive temperature - correcting on plastic pressue - measuring elements is put forward for the first time. large quantities of quasi - dynamic calibration tests in different temperatures are carried out on the dropper - hammer hydraulic dynamic pressure calibration device and the unitive temperature - correcting formula which accords with the traditional correcting method is got

    在落錘液壓動標裝置上組織了多批次的銅柱、銅球高低溫準動態校準試驗，探討了建立溫度誤差統一修正公式的可行性，建立了測壓銅球，測壓銅柱符合我國傳統修正方法的溫度統一誤差修正公式。
  20. 3. a series of quasi - dynamic calibration tests by varying the pressure pulse width for the < t > 3. 5 x 8. 75mm pillar copper cylinders and o 4. 763mm copper spheres are done on the dropper - hammer hydraulic dynamic pressure calibration device. by means of data analysis, the regulations of pulse width ' s effect on the two types of plastic pressure - measuring elements are obtained

    3利用落錘液壓動標裝置組織了3 . 5 8 . 75mm柱形銅柱、 4 . 763mm銅球的變脈寬準動態校準試驗，通過試驗數據處理，獲得了兩種型號塑性測壓器件的脈寬影響規律。
分享友人
分享到 Line

分享到臉書