校準電路 的英文怎麼說

中文拼音 [jiàozhǔndiànlù]
校準電路 英文
calibrated circuit
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 準 : Ⅰ名詞1 （標準） standard; guideline; criterion; norm 2 （目標） aim; target Ⅱ動詞1 （依據; 依照）...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. The paper consists of two parts, the first subject is the research on high precision charge calibrator, the other one is the measurement and application of the dynamic testing asics

    本文內容分為兩篇，第一篇題目是高精度電荷校準儀的研究，第二篇題目是動態測試專用集成電路的檢測與應用。
  2. In order to enhance the precision, this design proposes that temperature - measuring circuit of platinum resistors and software should be employed to carry on adjustment of measured precision ; it also proposes that the interference of the grid can be reduced by the voltage front feed ; and meanwhile it calls for the application of the photoelectric insulation, the over heating protection and alarm so as to enhance the security performance of the system

    為了提高精度，本設計還採用了鉑電阻溫度測量電路，並利用軟體對測量精度進行自校準；通過電壓前饋控制減少電網干擾。此外，設計中還加入了光電隔離措施及過熱自動保護和報警功能，以增強系統的安全性能。
  3. The results of experiment verified the simulation of pspice software. in chapter five, the technology requirements of vibration calibration system are introduced, and thus the optical and electric design are realized. the laser - vibration - measuring - system is tested and the results are analyzed

    第五章介紹了振動校準系統對測振儀的技術要求，實現了相關光路和電路的設計；對系統進行測試，並對實測結果進行分析；最後對系統的誤差進行了分析。
  4. The amplitude control relies on the use of an calibration scheme

    鋸齒波的穩定的幅度是通過校準電路來實現的。
  5. Different structures are used to achieve the signal source

    通過不同的實際電路得到相似的校準結果。
  6. Phases straight lines model and not straight lines model based on bp are used to correct the physical parameters and eliminate deflection. the least - square is used to calculate the efficiency of generators

    在物理量校準中利用分段直線回歸和基於神經網路的非線性回歸，對模擬量進行了非線性在線校正來消除誤差；在發電機效率計算中利用最小二乘法實現了發電機效率回歸。
  7. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。
  8. The main research content about this two subcircuits are as follows : 1. the precision and dynamic range of several typical current mirrors are discussed and an active input regulated - cascode output current mirror is adopted as the current duplicate circuits in ccii

    在這兩個子電路中主要進行了如下研究: 1 .研究了幾種常用的電流鏡的電流傳輸精度和動態范圍，並最終選擇有源輸入校準型電流鏡作為電流傳輸器中的電流傳輸電路。
  9. Based on the theory of charge calibration and sample and reconstruction of frequency limited signal, the scheme of adopting direct digital synthesizing technology and technology of computer is put forward in the paper. the design of hardware and software is described in detail, the error of the outputs signals of the high precision charge calibrator has been analyzed in theory

    文中基於電荷校準的原理及帶限信號的抽樣與重構理論，提出了採用直接數字合成技術與計算機技術的整體設計方案，詳細講述了硬體電路與系統軟體的設計過程，並對高精度電荷校準儀輸出信號的誤差進行了理論分析。
  10. Firstly, the system has a good snr and high accuracy, which is owed to wideband operational amplifier being used, accurate adjustment by da, 12 - bit high sampling ad converter being applied. secondly, data transmission becomes less by using forecasting code technology and dictionary compress technology, which are run by dsp on board

    本採集系統採用400mhz增益帶寬積的運算放大器，運用da高精度校準技術，並選用高采樣率低噪聲的12位ad轉換晶元進行模擬電路和ad轉換電路設計，既保證了數據採集系統的信噪比，又提高了系統測量精度。
  11. 6. since the monitor precision of quasi - dynamic calibration system is very important, the model of the four channel electric pressure - measuring system in frequency domain is built up. the cause of variance is analyzed. the error function of the system is defined and the formula of correcting the system error is derived

    6由於落錘液壓動標裝置校準系統的校準壓力監測精度極為重要，本文對四路電測壓力系統進行頻域建模，分析了產生不一致的原因，定義了系統的誤差函數及推導了統一誤差模型的修正公式。
  12. The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted

    本論文根據umbirfpa的原理，建立它的軟體模擬系統，它可以根據給定的結構、環境、電路設置等參數首先模擬光熱、熱電轉換過程，並可根據電路結構，模擬校準、參數調節並讀出信號，給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵量的定量變化過程，預測製成后器件的各種性能參數。
  13. In order to improve the circuit ' s input impedance, which is affected by insulating resistance of electrode leading wire, terminals and printed circuit board, electrode is connected to the meter through insulating wire of high impedance which is directly welded in the printed circuit board with insulating ring. the deviation of electrode is corrected by software and the algorithm is given

    使用高阻絕緣線連接電極，並將高阻絕緣線直接焊在加有絕緣環的印刷線路板上，從而消除電極引線、接線端子和印刷線路板漏電對放大電路輸入阻抗的影響；軟體校正電極偏差，並給出校準演算法。
  14. Hko s network time service allows people especially those engaged in e - business to calibrate their computer clocks. the e - certification system of the hong kong post is also synchronized to the atomic clock of the hko. in 2002, on average 5 computers were connected to the hko s network time service every second

    其他服務方面，天文臺利用網際網路提供香港標準時間，讓市民尤其是電子商貿參與者校正電腦時鐘，郵政署的電子認證系統也是以天文臺的原子鐘定時的，在2002年平均每秒有五部電腦到天文臺校對時鐘。
  15. A temperature compensation algorithm to overcome cross sensitivity according to the behavior of the inductance sensor, and a system self - calibration algorithm to overcome the drift of the analog circuit are designed. on the basis of these two algorithms, a new kind of data fusion algorithm combing both of them is derived out

    提出了利用浙江大學博士學位論文智能位移傳感器系統的研究傳感元件自身特性實現溫度補償的演算法以及對模擬電路特性漂移的系統自校準演算法，並在此基礎上，提出一種將兩者有機地結合在一起的數據融合演算法。
  16. If it turns out that the lens circuitry needs calibration, then the only way it could possibly have an adverse effect on another eos body in terms of focusing accuracy would be if that particular body was not correctly calibrated, in which case we go back to square one and calibrate that body with a tool lens

    如果測試的如果是鏡頭電路需要校準，唯一可能的情況就是按照此鏡頭的對焦精度在其他eos機身（此機身未正確的校準）上使用時會產生相反的效果，這種情況下我們要回過頭來把那個機身和標準鏡頭放在一起重新校準。
  17. So to develop a new type of transformer calibrator which has the high precision and the high degree of automation is significative. for the outdated transformer calibrator is widely used, this paper analyzed the theory of previous calibrators and proposed an idea of designing a new type of intelligent calibrator, based on the theory of measure the difference, adopt the project of dsp and mcu structure, also use high speed a / d electric chip. after the design of hardware circuit diagram, adopt the theory of fft and quasi - synchronous sampling method to reach the demand of precision. this paper discuss the intelligent development of transformer calibrator, achieve some success in the study

    本文針對國內市場目前普遍使用的老式互感器校驗儀的現狀，提出了智能型互感器校驗的研製思想，並詳細講述了其理論依據和實現過程，提出了切實可行的方案：基於測差測量原理，進行基於dsp和mcu雙cpu架構、並採用高速a / d的硬體電路設計，並在此基礎上採用快速傅立葉變換和準同步采樣演算法，並完成相關的軟體演算法框圖設計，對互感器校驗儀的智能化發展進行了有益的探索，取得了具有實用意義的成果。
  18. Also discussed the methods on how to realize the cwt both in time - domain and frequency - domain and how to design the gm - c bandpass filter used in realization of cwt. in order to optimize the performance of gm - c filter, linearization techniques are investigated and proposed. due to process variation and parasitics, an automatic tuning is designed for center frequency / 0 and quality factor q also, in this thesis, 16 - channel analogue cmos cwt circuit has been realized

    論文圍繞連續小波變換的模擬電路實現這一熱點問題，討論了連續小波變換的時域和頻域實現方法；具體分析了并行結構與串列結構的優缺點；研究了頻域法中的跨導-電容帶通濾波器的設計；給出了改善跨導輸入級傳輸特性的線性程度並擴大線性范圍的具體方法；設計了片內自校正（可調諧）環節使濾波器參數自動調整到設計標準值；最後給出了16通道濾波器組實現小波變換的方法。
  19. If an ef lens is not autofocusing correctly with a calibrated camera, the circuitry of the lens itself can be adjusted

    如果ef鏡頭不能在校準過的相機上正確的對焦，那麼就要調整鏡頭上的電路。
  20. Whenever a request for time check is received from the user s computer, the hko internet time server will return a time message based on the hong kong standard time. the user s computer then uses the received time message and the time delay in receiving the return message to adjust its clock

    當天文臺網際網路時間伺服器收到使用者電腦發出要求對時的信息后，伺服器便會傳送香港標準時間的信息至使用者電腦，該電腦會根據收到的時間信息及傳送時間來校準時鐘。
分享友人
分享到 Line

分享到臉書