條帶聚合體 的英文怎麼說

中文拼音 [tiáodàijùgětǐ]
條帶聚合體 英文
ribbon polymer
  • 條 : Ⅰ名詞1 （細長的樹枝） twig 2 （條子） slip; strip 3 （分項目的） item; article 4 （層次; 秩序; 條...
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 體 : 體構詞成分。
  • 聚合體 : aggregate
  • 聚合 : 1 （聚集到一起） get together2 [化學] （單體結合成高分子化合物） polymerization; polymerize 3 [生...
  1. Strain bl21, and gene expression was induced by iptg. the target proteins were directed into the periplasmic space by the staphylococcal protein a signal sequence preceding the rgd - hirudin gene. using ion exchange chromatography and gel filtration chromatography, the chimera proteins were purified, and both of them showed a single band in tricine - sds - page. the results of activity analysis suggested that these two chimera proteins not only have antithrombin activities, but gain platelet aggregation inhibitory activities as well

    通過離子交換層析和凝膠過濾層分別對兩種嵌合體蛋白進行純化，純化產物在tricine - sds - page中都顯示為單一條帶。活性分析結果表明兩種嵌合體蛋白在保留水蛭素抗凝血酶活力的同時，還呈現抗血小板聚集活性。
  2. New genetic changes has appeared in the selected shrimp generation, at the same time, no generation - specific bands were found. in addition, genetic variation among g2, g3 w1, hg were estimated by aflp and sampl, as shown in the umpga dendrogram, g2, g3, g4 were clustered into one group, and then g3, g4 were clustered. whether the data from aflp and sampl were calculated together or respectively, the results were similar with only a little difference from aflp

    另外，應用aflp和sampl對g2 、 g3 、 g4 、 w1及一個日照養殖群體hg進行了比較，將aflp 、 sampl條帶統計到一起聚類分析顯示g2 、 g3 、 g4聚為一支與w1與hg的聚合支首先分開， g3 、 g4再聚為一支與g1分開，顯然g2 、 g3 、 g4聚合趨勢與上述sampl分析結果相似；除aflp 、 sampl條帶統計到一起計算外，對上述g2 、 g3 、 g4 、 w1 、 hg相同樣本的aflp 、 sampl條帶分別進行了運算，可以看出兩種方法結果相似，單一技術計算結果與兩者聯合處理結果相似，但aflp條帶經popgene軟體處理所得umpga系統樹卻有所差別。
  3. According to the special shape and operate requirements of the torpedo, the structure and moulding process of the torpedo shell are established, in which the body and overlay block with grooves are moulded by fiber winding, and close moulding respectively with the adhesive by limited stop compression. in the light of the selection of raw material system, composite system with outstanding performance are defined, based on which the mechanical properties are tested., with the overall consideration of structural characters and design demands, the main factors which may have effects on the strength and stability ( including stiffness section dimension, stiffeners space, skin thickness and skin lay angle ) is optimized one by one for the structure design parameters on the base of the fem model of skin, stiffness and layover block by fem. as a result, the prototype with 1 : 1 proportion and its structure and lay optimization design are completed. the moulding technology for polyurethane foam moulding the stiffened shell is obtai ned in terms of the design, manufacture moulding, experimental mould and tooling

    依據在研產品特殊的外型結構和使用要求，確定了該型號水雷復合材料殼體的具體結構形式和復合成型工藝路線，即由纖維纏繞工藝成型主體異形件，閉模成型帶通槽外貼塊，用限位加壓工裝實現粘接的工藝路線；通過對原材料體系的篩選，確定了綜合性能較好的復合材料體系，以此為基礎進行了力學性能測試；運用有限元方法，建立了蒙皮、筋條和外貼塊的分析模型，綜合考慮結構特點和設計要求，對影響結構強度與穩定性的主要因素（包括筋截面尺寸、筋間距、蒙皮厚度、蒙皮鋪層角度）分別進行了結構設計參數的優選，最終完成了復合材料異形耐外壓殼體1 : 1樣件和縮比實驗件結構及鋪層優化設計；完成了聚氨酯泡沫胎成型內置加筋殼體的成型工藝技術研究；對縮比件進行外壓性能測試，並給出了應力、應變測試結果。
  4. The software system provides the switch with the ability to support each user monopolize lombps bandwidth, through which the user can use vod, voip and other digital services, and it also allows the switch to support multicasting, trunk, and traffic isolation. this thesis consists of five parts. the first chapter introduces ethernet access technologies and requirements for the switches

    通過軟體系統的配置，接入交換機能夠使用戶獨享10mbps帶寬，使用視頻點播、 voip等實時業務，支持組播以提高網路帶寬的利用率，支持鏈路聚合，在互連交換機的多條可用的物理鏈路間實現自動的負載均衡。
  5. The distribution and structure of the allelic polymorphism data are analyzed and it is pointed out that the distribution of allelic polymorphism data reveals the characteristic of closed data ( also named as compositional data or data of constant sum ) it is interpreted that the correlation structure of the allelic polymorphism data contains null correlations introduced by " closure " and the statistical distribution of the data is not normal because of its constant row sum, which resulted in great difficulties in analyzing the data with traditional multiple linear statistical methods such as principal component analysis, factor analysis, cluster analysis and canonical correlation analysis

    摘要長期以來，對于多維基因多態性數據的多元統計分析，如計算遺傳距離時所用的聚類分析、分析群體遺傳結構時所用的主成分分析、因子分析和典型相關分析等，一直應用為無約束條件數據而設計的經典多元線性分析方法，並沒有注意基因多態性數據的「閉合效應」所帶來的問題。
分享友人
分享到 Line

分享到臉書