極限通過電流 的英文怎麼說

中文拼音 [jíxiàntōngguòdiànliú]
極限通過電流 英文
passing current limit
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 通 : 通量詞（用於動作）
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 極限 : 1 （最高的限度） the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  • 通過 : 1 （從一端到另一端） pass through; get past; traverse 2 （同意議案） adopt; pass; carry 3 （以人...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The factors limiting the frequency band of the wide - band amplifier are introduced. through analyzing the effects of the intrinsic parameters and parasitical on the frequency characteristics, a method of improving fr of mosfet by using short channel device and making mosfet work at the saturation region through raising vgs is put forward ; the effects of different kinds of circuit configurations on the frequency characteristics and the junction voltage on the voltage pattern circuit, current pattern circuit and frequency characteristics are analyzed. according to the linear theory of transconductance which is applied in the bit circuit, the current pattern amplifier circuit, current transfer circuit and output circuit which consist of mosfet and the wide - band amplifier composed of them are put forward

    介紹了限制寬帶放大器頻帶寬度的因素，通過分析mosfet的本徵參數、寄生參數對頻率特性的影響，提出了採用短溝器件、使mosfet工作在飽和區、抬高柵源電壓等提高mosfet特徵頻率的方法；分析了不同電路組態對放大器頻率特性的影響、節點電壓對電壓模電路、電流模電路頻率特性的不同影響，根據應用於雙極晶體管電路的跨導線性原理，提出了採用mosfet構成的電流模放大電路、電流傳輸電路、輸出電路以及由它們所組成的寬帶放大器，獲得了良好的頻率響應。
  2. Because of the limitation of experimental conditions we failed to form foam lead grid in the experiment. copper draw net is used as anode grid and it can improve to some extent the utilization of pam. due to human errors in the experiment we have not used the same discharge current density

    在實驗中我們試圖通過鑄造法、電鍍法和還原法等一系列的實驗辦法製作泡沫鉛板柵，由於實驗條件的限制，沒能夠成功制得泡沫鉛，而在使用銅拉網作為正極板柵的時候，能夠使電池的正極活性物質利用率有提高，但由於實驗時候的失誤，沒能夠使用相同的放電電流密度進行放電，我們無法利用實驗數據比較出具體能提高的數字。
  3. According the key factors we find, we bring forward a new conception : multilevel suppressor and design a new high performance suppressor whose ion - exchange membrane has bigger areas and using three electrodes including one cathode ( anode ) and two anodes ( cathode ), at the same time we fill the suppression compartment with one kind of ion exchange resin which has moderate exchange capacity. according to our experiment ' s results, we find the new type suppressor has quite high working current efficiency and suppressing capacity. in most cases, the suppressor ' s current efficiency is over 90 % ; the suppressor can transform the naoh ( concentration : 200mmol / l, flow rate : i. oml / min, conductance : over 10000 i - i s cm " ) to pure water ( conductance : 8. 9 it s cm in chapter 3, the high performance suppressor is applied in determination some trace - amounts ions in plating solution, sewage. in this chapter, we also have a research on the gradient ion chromatography

    第二章首先以xyz - 1型電化學抑制柱為例，分析了電化學抑制柱的抑制過程得出影響抑制容量的主要因素主要是抑制柱的電流效率和離子交換膜的極限電流密度，因此採用中等交換能力的離子交換樹脂作為抑制室的填料以提高電流效率，在通常情況下電流效率可達到90以上；在選用同種離子交換膜的前提下，可通過增加離子交換膜的有效面積達到提高極限電流的目的從而提高抑制柱的抑制容量，因此提出了多級抑制的概念並據此研製了共電極式高容量電化學抑制柱，該抑制柱最高可將流速為1 . 0ml / min ，濃度為200mmol / l電導率超過10000 s ? cm ~ （ - 1 ）氫氧化鈉溶液抑制為電導率低至8 . 9 s ? cm ~ （ - 1 ）的純水，並且具有穩定性高、分析結果準確等優點。
  4. We have made three - dimension electric conduct grid by hand and we have successfully used it as anode grid in lead - acid battery. this kind of three - dimension electric conduct grid can improve the utilization of pam by 7 - 9 % in different discharge current density and can reduce the plate electrochemical impedance to one tenth of the normal plate. also this kind of grid can improve the marginal reaction current density in a certain degree

    我們通過手工製作了三維導電體板柵，並成功的應用於電池的正極作為正極的板柵，這種三維導電體板柵能夠在各種不同的放電電流密度下提高正極活性物質利用率7 9 ，能夠使電池正極板的電化學阻抗降低到普通板柵的1 10左右，使正極板的極哈爾濱j _程大學碩十學位論文限反應電流密度略有所提高，但是這種板柵的耐腐蝕性能很不理想，使得所製作電池的壽命很短。
  5. At last, an experiential power supply was made, and a series of experiments is done. a lot of high - frequency pulse current was superposed on dcen current, modulated the welding current waveform we required and optimized the energy distribution, which satisfied the basic requirement of cathode cleaning

    最後製作了一臺實驗電源，並進行了一系列的電弧實驗，通過在變極性電源電流dcen基礎上疊加一系列脈沖電流，調制出所需電流波形，實現輸出能量的最優分配，在滿足陰極清理的前提下，最大限度地提高焊接效率。
  6. The power angle characteristics are acquired and compared with the unsaturated curves. it is concluded that the stability limit of the power angle is less than 90 degree. reactive power regulating curves are calculated and compared with those curves when saturation effect is not considered, the result is that u type curves are deviated to the right

    通過對同步發電機各種運行曲線的計算，在已有文獻的基礎上更進一步分析了鐵磁材料飽和以及磁場畸變對同步發電機運行特性和參數的影響；求出了空載特性曲線和零功率負載特性曲線，在不同的電樞電流下計算得到的波梯電抗不同；求出了功角特性曲線，與不計飽和時的功角特性曲線相比較，功角穩定極限小於90 ；求出無功調節曲線，與不計飽和時相比較， u型曲線向右偏移。
  7. In chapter two, using the hydrodynamical equations for electrons and maxwell equation and through complicated calculation, we finally obtain a set of equations which describe the non - steady and nonlinear interactions between plasma and field in the wake region of a moving body in space

    第二章是從描述電子的磁流體方程和麥克斯韋方程出發，通過計算，最後得到了一組在考慮非靜態極限下描述空間飛行器遠尾區內等離子體與場之間的非穩態非線性相互作用耦合方程。
分享友人
分享到 Line

分享到臉書