構造偏移 的英文怎麼說

中文拼音 [gòuzàopiān]
構造偏移 英文
structural offset
  • : Ⅰ動詞1 (構造; 組合) construct; form; compose 2 (結成) fabricate; make up 3 (建造; 架屋) bui...
  • : Ⅰ動詞1 (做; 製作) make; build; create; produce 2 (假編) cook up; fabricate; concoct 3 [書面語...
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • : Ⅰ動詞1. (移動) move; remove; shift 2. (改變; 變動) change; alter Ⅱ名詞(姓氏) a surname
  • 構造 : structure; construction; constructional detail; tectonic; structural; makeup; anatomy; constituti...
  1. This paper introduces one novel protected clutch, which is simple in construction, good in usability, low for cost and movement expenditure, long for working life, rapid for jont or separation, compensable for all kinds of offset, and protected for overload

    摘要介紹一種結簡單、工藝性好,價、運行費用低廉,壽命長,可在運動中迅速接合分離,可補償兩軸之間的任何,能過載安全保護的新型安全離合器的結設計。
  2. The frontal structure of longmenshan in the west of sichuan is very complex, showing intense structure deformation in overthrust belt, high structure amplitude, steep stratigraphic dip, developed fault blocks, complex seismic wave field, frequent change of lateral velocity, and poor image of post - stack time migration processing

    摘要川西龍門山前緣非常復雜,逆掩推覆形變強烈,幅度大,地層傾角陡,斷塊發育,地震波場復雜,速度橫向變化大,常規疊后時間處理成像效果較差。
  3. Through the research on the technology of static correction in mountainous region and disturbing wave denoising, it is proposed that the method integrating static correction, migrated imaging with denoising is used to improve the quality of seismic profile in complicated structure area to reflect the underground geologic feature of complicated arcs, the primary effect has been obtained through application of this method in no. 7 lenghu and shizigou areas

    通過重點研究山地靜校正、干擾波去噪技術,提出了利用靜校正、成像、去噪技術相結合的方法,以提高復雜地區地震剖面的品質,合理反映復雜地區的地下地質特徵,該方法在冷湖七號、獅子溝等地區的應用,取得了初步效果。
  4. The questions the researcher concerned are which system will be chosen and how to obtain the good lithium ionic conductor materials, which is the basic departure of the paper. the addition of second phase in composite can change the interface structure and the conduction mechanism, improve the matrix conductivity and other function such as the sintering, crisping and so on, so the research of composites are an interesting field of the ionic conductors. the synthesis of lithium ionic conductor is often by solid state reaction, but this method needs high temperature and leads to the volatility of lithium which not only causes the drift of the compounds but gets the no well - distributed materials

    研究者所關注的問題是選擇新的體系進行研究,以期得到性能更好的鋰離子導體材料,這也正是本論文的基本出發點;復合離子導體中第二相的加入改善了基質的界面結和導電機制,不僅可以提高基質材料的電導率,還可以在一定程度上改善材料的其它性能,如燒結性能、脆性和機械強度等。因此復合材料的研究是離子導體一個有廣闊前景的發展方向;合成鋰離子導體,特別是成分復雜的體系以傳統的固相合成法為主,但這種方法需要較高的溫度,容易引起鋰的揮發,從而成產物組成的,而且不易得到顯微結均勻的材料。
  5. Based on the review of petroleum exploration in the south margin of junggar basin in the past half century, the difficulties of piedmont exploration in different phases are summarized as follows : complex structures : large variability in reservoir quality and difficulty in predicating its scale ; inaccurate image of seismic data ' s migration processing in complete trough structural belts ; requirement for high technology of drilling, etc

    摘要通過對準噶爾盆地南緣半個多世紀的油氣勘探歷史回顧,確定了山前勘探各個階段所面臨的主要難點:存在多解性、儲層質量變化大與規模難以預測、高陡地震處理準確成像難度大、鉆井技術要求高。
  6. Based on the analysis of the lateral acceleration data of vehicles measured in shanghai metro lin, this paper suggests that the lateral oscillation force of the vehicles shall choose 10 % of the vertical load on a single wheel

    摘要根據鐵路車輛及上海軌道交通3號線上實測車輛橫向加速度值,建議橫向搖擺力取軸重的10 % ,按目前承軌合,車輛偶然脫軌后可能橫向左右各1 . 75m 。
  7. The algorithm of dichotomy was applied to find the optimum declination value when the construction of inner and outer envelopment was designed

    該演算法使用點對合併的聚合方法來減少點元的數量;內外包絡時,使用二分法尋找最佳值。
  8. In this part, the author has confirmed the achievements constructing the emm in ishs from five aspects like the foundation of the theoretic system of moral education in ishs, the standardization of morality course, etc. also analyzed the problems appeared during the construction of the emm in ishs from four aspects like the weakness of levels about moral objectives, the gaps between morality education contents and students " realities, etc. the author has found that the problems are mainly about the incorrect orientation of morality objectives, the lack of practice in moral education, the particularity of moral educational objects and weakness of researching strength

    主要從綜高德育理論體系的建立、德育課程的規范化等五個方面對綜高德育模式建取得的成績予以肯定,又從德育目標層次性不強、德育內容與學生實際脫節等四個方面對綜高德育模式建存在的問題深入剖析,發現其原因主要是德育定位、德育實踐經驗缺乏、德育對象特殊性研究力度不夠等所成,從而為綜高德育模式的優化建找到了現實依據。
  9. In efgm, in order to get a numerical solution for a partial differential equation, the shape function is constructed by moving least squares ( mls ), the control equation is derived from the weak form of variational equation and essential boundary conditions are imposed by penalty function method

    它採用動最小二乘法形函數,從能量泛函的弱變分形式中得到控制方程,並用罰函數法施加本質邊界條件,從而得到微分方程的數值解。
  10. Moreover, a series of solution to these difficulties are brought forward : applying the theory of fold related to fault to interpret complex structural belts in piedmont : analyzing the features of the surface and underground seismic reservoir prediction and porosity model construction to predicate effectively the texture and quality of sandbodies ; using structural model to direct the construction of velocity model and process prestack migration imaging of seismic data ; utilizing interval velocity to forecast reservoir pressure : improving the drilling technology for pressure detection and prompt protection of vertical well against incline well

    並針對主要難點提出了解決對策:正確應用斷層相關褶皺理論解釋山前復雜改、開展地表井下地震儲層與孔隙建模有效預測砂體結與質量,利用有效建模指導速度建模與疊前成像、開展層速度預測地層壓力與鉆井壓力檢測及快速防斜打直配套鉆井技術攻關等。
  11. Geological model is set up by using seismic data interpretation result to perform ray - trace forward modeling analysis, and to guide the establishment of initial velocity model of pre - stack depth migration, thus reaching the purpose of precise image of complex structure under complex surface

    利用已有地震資料解釋成果,建立地質模型進行射線追蹤正演模擬分析,從而指導疊前深度初始速度模型的建立,達到了復雜地表下復雜精確成像的目的。
  12. A synthetic example shows that the proposed migration velocity analysis method can determine accurately the distribution of permittivity and that stack migration profile fits the true model

    合成雷達記錄的速度分析和疊加結果表明,全局最優化速度分析有較高的精度,疊加剖面與實際一致。
  13. Constructor runs, the length and offset are then set to their desired values

    器運行時,字元串長度和量被設置成所需要的值。
  14. We raised a new model that we disassemble the character into several parts, which could be recognized by computer topologically based on the high - frequency wavelet coefficients vector, disregarding the traditional extraction method that used the statistical or structural feature based on the individual pixel in the 2 - dim plane of character. moreover, the concept of multi - dim cognizing feature model was put forward by encoding the character, according to its " location and run - length information. the information confusion and redundancy could be largely eliminated, as leaded to the improving of the preciseness when recognizing the character

    克服以往結、統計方法在字元特徵提取中無法剔除噪聲、等冗餘信息的不足,以認知的新思路分析圖像,給出基於小波子圖的筆劃定義,給出一種注重反映字元部分最為重要的筆劃的類型、數量、遊程、位置特徵,改進了基於字元二維圖像的統計與結特徵提取方法因變形,畸變成信息混淆和冗餘;給出了提取多屬性字元認知特徵的方法和識別機制,實驗表明,該方法能有效的識別字元; 3
  15. Thirdly, the paper analyzes the reasons of un - balance of demand and supply from the aspect of quality and construction, and argues that the situation of demand and supply is characterized by total surplus and structural deficiency. t he large scale of population and the high rate of labor participation lead to that the total supply surpass the demand. the capital structure, the improving technology and capital - dominance industrialization way result in the deficient demand, so they become the key reasons of unbalance situation

    再次,從總量和結兩方面分析我國勞動力供求失衡的原因和影響因素,認為我國勞動力供求態勢的特徵是總量過剩與結性短缺並存;從供給角度看,人口規模過大以及勞動參與率高是勞動力供給總量大於需求的主要原因:從需求角度看,資本成、技術進步和資本深化的工業化方式是勞動力需求不足進而成供求失衡的關鍵原因;改革前,我國勞動力就業結嚴重滯后,這與我國經濟發展戰略有密切聯系;改革后,產業結調整使就業結差得到一定的矯正,勞動力供求結失衡的矛盾有所緩和。
  16. When the suspended point is moving on the line in a kind of way, the pendulum will depart from the balance position. in order to minimize the swing movement of pendulum and minimize the consumption of power, a linear regulator is created for the system. finally, a optimum feed back status of speed is made

    當懸掛點以某種規律沿直線運動時,會出現擺錘離原太原理工大學碩士研究生畢業論文平衡位置的情況,為了使擺錘在給定時間內在懸掛點行走一定距離的過程中擺角最小且能耗最少,本文將系統成為線性調節器,最終得到了使懸掛點動速度最優的狀態反饋量
  17. Moreover, the detailed calculation and contrastive analysis are carried out by using the software ansys. theoretical calculation and testing results show that adopting the connection construction with a hole on the web can alleviate the stress state greatly and transform the failure mode of the connection from brittle fracture to local buckling damage on beam, reduces the possibility of brittle fracture by welding and improve the ductility performance of connection to a great extent

    結果表明,採用腹板開孔的節點形式,可以使梁的塑性鉸位置由梁根部向中部,達到了有效控制塑性鉸位置的目的;同時,採用這種節點可以改變節點附近的梁截面應力分佈狀態,降低了節點脆性破壞的可能性,使節點的破壞模式從脆性破壞轉變為梁的局部屈曲破壞,很大程度上改善了結的延性。
  18. Engineering structure research ; project design ; construction supervision ; project management ; technology of construction materials ; the consultation of special technologies as structure testing, identifying, strengthening, story - adding, deviation - correction and transposing

    工程結科學技術;工程設計、工程監理、工程管理及工程材料技術;結檢測鑒定加固增層改、糾位等特種技術咨詢。
分享友人