標定試驗 的英文怎麼說

中文拼音 [biāodìngshìyàn]
標定試驗 英文
rating test
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 標定 : demarcate; calibration; calibrating; standardization; pointing
  • 試驗 : trial; experiment; test
  1. Standard test methods for determining acceptability of ribbon welds in fabric cartridges

    織帶盒色帶接頭合格性測定的標準試驗方法
  2. Standard test method for determination of sulfuric acid mist in the workplace atmosphere ion chromatographic

    工作場所大氣中硫酸酸霧測定的標準試驗方法
  3. Standard test method for evaluating stress - corrosion cracking of stainless alloys with different nickel content in boiling acidified sodium chloride solution

    沸騰酸化氯化鈉溶液中不同鎳合量不銹鋼合金應力腐蝕裂紋評定的標準試驗方法
  4. Standard test methods for determination of dimer in acrylic acid

    測定丙烯酸中二聚物的標準試驗方法
  5. Standard test method for determination of deposition of aerially applied oil spill dispersants

    測定用於空中的溢油分散劑沉積的標準試驗方法
  6. Standard test method for quantitative determination of americium 241 in plutonium by gamma - ray spectrometry

    用射線光譜法定量測定鈈中鎇241的標準試驗方法
  7. Standard test method for total sulfur in aromatic compounds by hydrogenolysis and rateometric colorimetry

    通過氫解分析和比率量熱術測定芳香化合物中硫總含量的標準試驗方法
  8. Standard test method for isoaspartic acid in proteins : method for the determination of asparagine deamidation products

    蛋白質中異天門冬氨酸的標準試驗方法:天門冬酰胺脫酰胺基製品的測定方法
  9. Standard test method for crazing resistance of fired glazed whitewares by autoclave treatment

    用熱壓處理法測定焙燒衛生釉瓷抗破裂性的標準試驗方法
  10. Standard test method for polyurethane raw materials : determination of basicity in polyols, expressed as percent nitrogen

    聚氨脂原材料的標準試驗方法:可以表示為氮的百分量的多元醇中堿度的測定
  11. Standard test method for rate of absorption of water by bibulous papers

    用皺文紙測定吸水率的標準試驗方法
  12. Standard test method for determination of isothermal secant and tangent bulk modulus

    測定等溫正割和正切體積彈性模量的標準試驗方法
  13. Standard test method for determination of calcium fluoride in fluorspar by complexometric titration

    用絡合滴定法測定氟石中氟化鈣含量的標準試驗方法
  14. Experimental research on load calibration based on balanced elbow structure

    基於肘體結構的載荷標定試驗研究
  15. Inquiring into calibration test of standard steel bottle and calculation of total deformation value

    標準鋼瓶標定試驗及全變形值計算探討
  16. The results suggest that both of these instruments ought to be calibrated in barrel ; tdr can be calibrated using the same formula in different depths of even soil profile ; and neutron probe need to be calibrated by dividing the whole even soil profile into three segments

    標定試驗結果表明：時域反射儀和中子儀都應該用桶內標定法；時域反射儀可以不分層標定，而中子儀可以分三段標定。
  17. The scheme of this project is : firstly, completing a automobile obverse impact dummy and preparing a special digital signal analysis system ( including sensors, a signal pretreatment, a signal collection, a digital signal process software ) ; secondly, this dummy will be used in impacting experiments to check its signals response and bio - response characteristic through comparing sensors in difference parts of the dummy that are suffered one impact ; thirdly, the bio - mechanics characteristic of the dummy will be demonstrated by nationality automobile safety testing center

    該課題的設計思路為：研製汽車正面碰撞假人一個；設計專用的數字信號分析系統一套（包括傳感器、信號預處理、信號採集和數字信號處理軟體） ；將假人作簡易碰撞試驗以檢驗是否有響應信號，並對不同部位的傳感器在受到相同沖擊的情況下產生的響應信號進行對比以驗證假人的生物力學響應特性；假人的生物力學特性由國家汽車檢驗中心進行標定試驗來論證。
  18. A new temperature segmentation linear fitting method sieves the problem caused by the nonlinear mapping between the temperature data and the chroma. that is dividing the temperature into some sections from high to low. different temperature section uses different formula

    提出了一種新的溫度分段線性化擬合方法解決溫度數據與色度的非線性映射問題，即將火焰溫度由高向低分成幾個溫度段，不同的溫度段使用不同的運算公式，從而提高了測量的精度，避免了過去方法中試圖用一個標定試驗的公式來求解跨度較大的整個溫度場分佈時所產生的誤差。
  19. By adopting the method of saturated aqueous salt solutions, the paper designs the equipment to produce the humidity source and scale pi sensors. based on the design and long period measurement of demarcated equipment, we get the lots of curve and data that shows the linear relation between capacity and moisture and good linearity and resolving power

    採用飽和鹽溶液法得到相應級別的濕度標準，對傳感器進行標定試驗並採用相應的數據處理方法，建立了感濕特徵量與氣相濕度之間的數學關系，最終給出其數學模型和各種指標。
  20. Consider to simplifying the process of calibrating dynamic error parameters of accelerometer and shortening the time of calibrating test, all dynamic error parameters are calibrated at one - time, based on the mathematic model of dynamic error of accelerometer and integrating the model and the testing theory of the three - axis turntable, meanwhile, the angle - vibration table is avoided

    摘要為了簡化加速度計動態誤差系數的標定過程，縮短標定試驗時間，在建立加速度計動態誤差數學模型的基礎上，結合三軸轉臺模型及測試原理，一次性標定出加速度計動態誤差系數，同時避免了角振動臺的使用。
分享友人
分享到 Line

分享到臉書