標準尺寸比率 的英文怎麼說

中文拼音 [biāozhǔnchǐcùnbǐlǜ]
標準尺寸比率 英文
standard dimension ratio
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 準 : Ⅰ名詞1 （標準） standard; guideline; criterion; norm 2 （目標） aim; target Ⅱ動詞1 （依據; 依照）...
  • 尺 : 尺名詞[音樂] （中國民族音樂音階上的一級 樂譜上用做記音符號 參看「工尺」） a note of the scale in ...
  • 寸 : Ⅰ量詞（長度單位） cun a unit of length （=1/3 decimetre）Ⅱ形容詞（極短或極小） very little; very ...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 標準 : （衡量事物的準則; 榜樣; 規范） standard; criterion; benchmark; pip; rule; ètalon （衡器）; merits
  • 比率 : ratio; proportion; rate比率計 ratio meter
  1. According to the no - loading waveform deviation factor, the prototype conforms to the national design standard and practical needs in the engineering. more important, the high voltage is achieved. in the condition of considering core saturation and damping winding influence, the influence to powerformer of the no - loading tooth harmonic emf is smaller than conventional generator, and the waveform deviation factor of the former is smaller, too

    由求得的樣機空載電勢波形畸變率可知，該樣機滿足國家設計標準和工程實用要求，更重要的是，實現了產生高壓的目的；考慮鐵心飽和、考慮阻尼繞組影響情況時，電力發生器與具有相同尺寸（除定子槽形）的傳統發電機相比，空載齒諧波電勢對電力發生器的影響較小，前者的空載波形畸變率較小。
  2. To illustrate the superiority of this type of transition, the author adapted the local normal mode ( lnm ) based on couple - mode theory to explain the coupling between two lowest order modes along the transition. for the two important parameters, propagation constants difference between the two modes apy and mode coupling coefficient cy, which denoting power coupling between lnms, the approximation expressions using structure parameters were worked out. then the author compared three typical different transitions according to the demanding of power coupling, at last concluded that the parabolic - type transition can transport the light in shortest length with lowest loss

    對于表徵局部標準模之間功率耦合的兩個重要的參數_ （ ij ） （模式傳播常數差）和c _ （ ij ） （模式耦合系數） ，推導了用器件結構參數表達的近似公式，然後根據功率耦合的需求，在常見的三種不同輪廓的過渡區之間進行了比較，得出了拋物形輪廓過渡區能夠使光束在最短尺寸內以最低損耗通過波導的結論。
分享友人
分享到 Line

分享到臉書