標準燃燒熱 的英文怎麼說

中文拼音 [biāozhǔnránshāo]
標準燃燒熱 英文
standard heat of combustion
  • : Ⅰ名詞1 [書面語] (樹梢) treetop; the tip of a tree2 (枝節或表面) symptom; outside appearance; ...
  • : Ⅰ名詞1 (標準) standard; guideline; criterion; norm 2 (目標) aim; target Ⅱ動詞1 (依據; 依照)...
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • 標準 : (衡量事物的準則; 榜樣; 規范) standard; criterion; benchmark; pip; rule; ètalon (衡器); merits
  1. Standard for safety for waste oil - burning air - heating appliances

    廢油空氣加設施安全
  2. Standard test method for heat of combustion of liquid hydrocarbon fuels by bomb calorimeter

    彈式量器測定液烴試驗方法
  3. Standard test method for heat of combustion of liquid hydrocarbon fuels by bomb calorimeter precision method

    用彈式量器對液態烴類量的試驗方法
  4. Test method for determination of fire - test - response characteristics of components or composites of mattresses or furniture for use in correctional facilities after exposure to vandalism, by employing a bench scale oxygen consumption calori

    用實驗室耗氧量計測定遭破壞后修復設施中床墊或傢具用部件或合成材料試驗響應特性的試驗方法
  5. With the coal gas producer furnace as heat resource, in low temperature burning, the sulfur dioxide and dust withdrawal is lower than the national standard. therefore under normal work condition, regardless of the boiler size all may achieve the smokeless running

    採用煤氣發生爐做源,由於低溫,二氧化硫及煙塵的排放量低於國家,因此在正常工作狀態下,無論鍋爐大小都可以達到無煙化運行。
  6. Standard for safety for heat reclaimers for gas -, oil -, or solid fuel - fired appliances

    油或固體料設施用回收設備的安全
  7. Room fire test standard for garage doors using foam plastic insulation

    使用泡沫塑料隔的車庫門室內試驗
  8. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案:主風機為器提供所需的一次、二次進風量及冷卻風量;利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量,用步進電機調節回油閥開度來調節供油量,從而實現對模擬實驗臺出口煙氣流量的調節;實驗臺的流量測量採用風機動力性能測試中測流量方法等。
  9. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案:主風機為器提供所需的一次、二次進風量及冷卻風量;模擬實驗臺出口煙氣流量是通過調節風機的轉速、風門開度及油量來改變;實驗臺的流量測量採用風機動力性能測試中流量方法等。
  10. Standard test method for heat release, flame spread, smoke obscuration, and mass loss testing of insulating materials contained in electrical or optical fiber cables when burning in a vertical cable tray configuration

    電纜或光纜絕緣材料在立式電纜槽裝置中發散火焰傳播煙的昏暗度和質量損失測試的試驗方法
  11. A new method is put forward on thermodynamics combustion model to make imitating research on egr - a software is made to calculate the amount of no from the gasoline by connecting with the practical condition in our country, starting with thermodynamics and experiment at the same time make a system research to influence by the exhaust gas returning system on the gasoline, such as exhaust gas, fuel economy, and power, finally a new thought is afforded for optimizing all the egr parameter in chapter 6

    第五章採用上述診斷和預測模型對bj492q發動機進行了模擬計算和實驗研究,並探討了點火提前角、殘余廢氣系數、空比、壓縮比和火花塞位置對發動機性能的影響。第六章提出了基於力學模型對egr進行數值模擬的方法,系統地研究了車用汽油機加裝egr系統后對排放、油耗、功率的影響,並結合排放。提出了egr參數的全局優化的新思路。
  12. Standard test method for flame height, time of burning, and loss of mass of rigid thermoset cellular plastics in a vertical position

    垂直向硬質固性泡沫塑料的火焰高度時間和質量損失的試驗方法
  13. Standard test method for determination of nitrogen oxides, carbon monoxide, and oxygen concentrations in emissions from natural gas - fired reciprocating engines, combustion turbines, boilers, and process heaters using portable analyzers

    用便攜式分析儀測定天然氣的往復式發動機氣輪機爐和工藝加器排放的氧化氮一氧化碳和氧濃度的試驗方法
  14. Part of content about fluidized bed thermodynamic calculation in the 《 layer and fluidized combustion thermodynamic calculation standard for industrial boiler 》 ( jb / dq1060 - 83 ) are discussed the computing equation of fly ash carbon content and the thermal equilibrium equation in the dense phase considering evaporation of water of unburned coal are given. the revise necessary is provided through calculating examples

    對jb / dq1060 - 83 《層狀及沸騰工業鍋爐力計算》中沸騰爐力計算的部分內容進行了探討,導出了沸騰層飛灰含碳量計算式和考慮未煤水分蒸發的沸騰層平衡方程,通過算例說明了修正的必要性。
  15. A part of content about fluidized bed thermodynamic calculation in the 《 layer and fluidized combustion thermodynamic calculation standard for industrial boiler 》 ( jb / dq1060 - 83 ) are discussed the computing equation of fly ash carbon content and the thermal equilibrium equation in the dense phase considering evaporation of water of unburned coal are given. the revise necessary is provided through calculating examples

    對jb / dq1060 - 83 《層狀及沸騰工業鍋爐力計算》中沸騰爐力計算的部分內容進行了探討,導出了沸騰層飛灰含碳量計算式和考慮未煤水分蒸發的沸騰層平衡方程,通過算例說明了修正的必要性。
  16. ( 1 ) the cfd model for the pulse combustion spray drying process. the computational fluid dynamics ( cfd ) based on the two - phase flow theory was employed in this paper, which used the standard k - e model and the particle trajectory model to simulate the gas - particle flow in the drying chamber. the momentum, heat and mass transfer regarding both gaseous and particulate phases during the spray drying inside the drying chamber was also revealed

    為解決這一難題,本文利用氣體一顆粒兩相流理論和計算流體力學( cfd )技術,建立了更符合實際噴霧乾燥過程的數學模型即噴霧乾燥的cfd模型,並進行了脈動噴霧乾燥過程模擬,其主要內容如下: ( 1 )建立了脈動噴霧乾燥的cfd模型該數學模型建立在氣體一顆粒兩相流基礎之上,用k -模型預測乾燥室內的氣體湍流運動過程,顆粒軌道模型追蹤乾燥室內顆粒群的運動軌跡,質傳遞模型描述空氣和液滴的質傳遞過程。
  17. Ensure all combustion equipment installed and components used are safe and complies with standards

    確保設備的安裝和部件的使用符合安全
  18. Standard test method for hot - surface ignition temperature of dust layers

    塵埃層表面溫度的試驗方法
  19. Standard guide for construction of solid fuel burning masonry heaters

    固體料的磚石結構加器建造的指南
  20. Standard test method for estimation of net heat of combustion of aviation fuels

    平定航空料凈試驗方法
分享友人