標準補充件 的英文怎麼說

中文拼音 [biāozhǔnchōngjiàn]
標準補充件 英文
addition to standard
  • : Ⅰ名詞1 [書面語] (樹梢) treetop; the tip of a tree2 (枝節或表面) symptom; outside appearance; ...
  • : Ⅰ名詞1 (標準) standard; guideline; criterion; norm 2 (目標) aim; target Ⅱ動詞1 (依據; 依照)...
  • : Ⅰ動詞1 (修理; 修補) repair; mend; patch 2 (補充; 補足;填補) fill up; add supplement; supply; ...
  • : Ⅰ形容詞(滿; 充足) sufficient; full; ample Ⅱ動詞1 (裝滿; 塞住) fill; charge; stuff 2 (擔任; ...
  • : Ⅰ量詞(用於個體事物) piece; article; item Ⅱ名詞1. (指可以一一計算的事物) 2. (文件) letter; correspondence; paper; document
  • 標準 : (衡量事物的準則; 榜樣; 規范) standard; criterion; benchmark; pip; rule; ètalon (衡器); merits
  • 補充 : 1 (原來不足或有損失時增加一部分) replenish; supplement; supply; make up; complement; add 2 (在...
  1. Commercial building telecommunications cabling standard - part 2 : balanced twisted - pair cabling - addendum 3 - additional considerations for insertion loss and return loss pass fail determination

    商用建築電信電纜敷設.第2部分:對稱雙絞合線電纜敷設.3 .插入損耗和回波損耗通過失效確定的附加考慮要素
  2. Commercial building telecommunications cabling standard - part 1 : general requirements - addendum 3 - supportable distances and channel attenuation for optical fiber applications by fiber type

    商用建築電信電纜敷設.第1部分:一般要求.3 .根據纖維類型決定的光纖設備的可支持距離和通道衰減
  3. This paper conbined with the indoor test and the scene test road, through the synthetical analysis of the factors of influencing densification effect for the densification thickness of filling stone roadbed. the maximum grain size of fill material, densification machinery and densification frequency et al. advanced a control norm of the maximum grain size and piy of compression, established ration evaluating the control standard of densification quality of filling stone roadbed under overload. comparing with result of indoor test and the scene test road, studied on theory of densification in different kinds of stone material and perfected the control system of the densification of filling stone roadbed under overload

    結合室內試驗和現場試驗路的實測數據,通過對填石路基的壓實厚度,填料最大粒徑,壓實機械及壓實遍數等影響壓實效果的因素的綜合分析,提出填石路基的最大粒徑和攤鋪厚度的控制指,建立定量評定超重載交通下填石路基壓實質量的控制,並對照室內試驗和現場試驗結果,研究不同石料條下的壓實理論,完善了填石路基壓實控制指體系。
  4. Commercial building telecommunications cabling standard - part 2 : balanced twisted pair components - addendum 1 - transmission performance specifications for 4 - pair 100 ohm category 6 cabling

    商用建築電信電纜敷設.第2部分:對稱雙絞合線部.1 . 4對100歐姆的第6類敷設電纜的傳輸性能規范
  5. Residential telecommunications cabling standard - addendum 2 - control cabling for residences

    住宅用電信電纜敷設.2 :住宅用管理電纜敷設
  6. Residential telecommunications cabling standard - addendum 3 - whole - home audio cabling for residences

    住宅電信電纜布線.3 :居民區家庭音頻布線
  7. Commercial building telecommunicatins cabling standard - part 2 : balanced twisted - pair cabling components - addendum 6 - category 6 related component test procedures

    商用建築物電信電纜敷設.第2部分:對稱雙絞電路敷設元.6 : 6類相關元試驗方法
  8. In addition to the existing markings of csa standard c22. 2 no. 112, clause 7. 1. 2. 36a of the amendments specifies a ground symbol illustrated in figure 7, or a similar marking ; or a marking on the wiring diagram provided on the appliance

    作為該csa中已有示規范的,修訂文中的條款7 . 1 . 236a要求產品上要有指定的接地志或類似的示,或者在接線圖上作相關的示。
  9. Execution of steel structures - part 2 : supplementary rules for cold formed thin gauge components and sheeting ; german version env 1090 - 2 : 1998

    鋼支承結構施工.第2部分:冷制薄形和護板
  10. Addition to standard

    標準補充件
  11. Commercial building telecommunications cabling standard - part 1 : general requirements - addendum 2 - grounding and bonding specifications for screened horizontal cabling

    商用建築電信電纜敷設.第1部分:一般要求.2 .屏蔽電纜水平敷設的接地和連接規范
  12. Commercial building telecommunications cabling standard - part 1 : general requirements - addendum 4 - recognition of category 6 and 850 nm laser - optimized 50 125 micron multi - mode fiber

    商用建築電信電纜敷設.第1部分:一般要求.4 .第6類850nm激光優選的50 125微米多模纖維的鑒別
  13. Commercial building telecommunications cabling standard - part 2 : - balanced twisted - pair cabling components - addendum 9 - additional category 6 balance requirements and mesurement procedures

    商用建築電信電纜敷設.第2部分:平衡雙絞線電纜組.9 .附加分類6平衡要求和測量過程
  14. Commercial building telecommunications cabling standard - addendum 5 - in - floor systems

    商用建築物電信布線.5 .地板內的系統
  15. Commercial building telecommunications cabling standard - part 1 : general requirements - addendum 1 - minimum 4 - pair utp and 4 - pair sctp patch cable bend radius

    商用建築電信電纜敷設.第1部分:一般要求.1 . 4對utp和4對sctp插塞式電纜的最小彎曲半徑
  16. Commercial building telecommunications cabling standard - part2 : balanced twisted - pair cabling components - addendum 11 : specification for increased diameter of 4 - pair utp and sctp cables

    商用建築電信電纜敷設.第2部分:平衡雙絞線電纜組.11 .增加4對utp和sctp電纜直徑的規范
  17. Commercial building telecommunications cabling standard - part 2 : balanced twisted pair cabling components - addendum 4 - solderless connection reliability requirements for copper connecting hardware

    商用建築電信電纜敷設.第2部分:對稱雙絞合線電纜敷設.4 .銅制連接硬體的無釬焊連接的可靠性要求
  18. Commercia building standard for telecommunications pathways and spaces - addendum 6 - multi - tenant pathways and spaces

    電信通路和空間用電信商業建築.6 .多租戶通路和空間
  19. Methods of measurement for radio equipment used in the mobile services - part 1 : general definitions and standard conditions of measurement ; amendment 1

    移動設備中用的無線電設備的測量方法.第1部分:測量的通用定義和狀態.1
  20. Methods of measurement for radio equipment used in the mobile services - part 1 : general definitions and standard conditions of measurement ; amendment 2

    移動設備中用的無線電設備的測量方法.第1部分:測量的通用定義和狀態.2
分享友人