模型試驗池 的英文怎麼說

中文拼音 [móxíngshìyànchí]
模型試驗池 英文
model basin
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 池 : 名詞1 （池塘） pool; pond 2 （旁邊高中間窪的地方） an enclosed space with raised sides 3 （舊指劇...
  • 模型 : 1 （仿製實物） model; pattern 2 （制砂型的工具） mould; pattern3 （模子） model set; mould patter...
  • 試驗 : trial; experiment; test
  1. The advantage and disadvantage of measurement of propeller - induced pressure by using different equipment is discussed. the method to obtain self - propulsion point for full scale in depressurized towing tank is studied. the measurements of pressure of two propeller models are carried out, the results of the measurement agree with those obtained by cavitation tunnel very well, which proves this measurement is successful, and the theoretical prediction is verified too

    比較了不同測試設備用於螺旋槳脈動壓力測試的優缺點，探討了在減壓拖曳水池中實現實船自航點的方法，並進行了兩只螺旋槳模型的脈動壓力測試，經與空泡水洞中脈動壓力的測試結果進行比較，說明該項測試是成功的，同時也對脈動壓力的理論預報結果做了驗證。
  2. The additional flow is formed by the device of dentoid baffle, and the application of the device of dentoid baffle cooperated with a stilling basin has been investigated by systematic model tests. based on the research results, the hydraulic problems such as the characteristics of hydrodynamic pressure and cavitation on the head of the denotid baffle, the properties of flow under the condition that the device of denotid baffle is used with a stilling basin, the hydraulic computation about a stilling basin, the estimation of energy dissipation and its various affection factors, the mechanism and effect of energy dissipation, and distributions of velocity and pressure and aerating concentration, etc, have been analyzed ; the method and step of hydraulic design of device of denotid baffle by which the additional flow is produced has also been proposed

    文中利用齒墩設施實現附加射流，對齒墩設施與消力池聯合應用進行了大量的和系統的模型試驗，分析研究了中低佛勞德數條件下，齒墩墩頭的動水壓強及空化特性，齒墩設施與消力池聯合應用時的流態特性，消力池的水力計算，消能量的估算及其各種影響因素，消能機理和效果，消力池內的流速、壓強特性，摻氣濃度分佈等水力學問題，並提出了實現附加射流齒墩設施的水力設計方法和步驟。
  3. This study collected and discussed the results of three hydraulic model tests of long period oscillations in hwa - lien harbor, conducted by center of harbor and marine technology in 1996, 1997 and 2000

    摘要本文綜合港灣技術研究中心於1996 、 1997及2000年所執行有關花蓮港港池振蕩的研究計畫水工模型試驗成果部份，進行匯整及討論。
  4. Thus a new - type continuously scouring basin was proposed

    提出了一種新型沖洗式沉沙池，並進行了模型試驗。
  5. This essay is devoted to the research of arch netfloor stilling pond ' s hydraulic property and characteristic of energy dissipation through a series of hydraulic model experiments. the parameters of arch net floor gap rate, aperture, pore shape and thickness of net floor that have influences on the hydraulic property are discussed also, and advances hydraulic design method of arch net floor stilling pond

    本文通過水力學系列模型試驗，研究了拱網消力池的水力特性和消能特性，探討了拱網開孔率、孔形、孔徑、網板厚度等各項參數對水力特性的影響，並且提出了拱網消力池的水力設計方法。
  6. Experimental data from the towing tank tests show that the hydrofoils give more water - drags on the raft ' s hull, and that the hydrodynamic performance of a ferrying raft will be improved by rational designs of the hydrofoils ' profile, angles of attack as well as the position of hydrofoil on the hull

    船模水池中的模型拖曳試驗表明，盡管水翼會增加門橋的水阻力，但只要合理地設計水翼的翼型、攻角和安裝位置，可以改善和提高門橋水動力性能。
  7. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在蓄電池試驗的基礎上，分析和研究ni - mh蓄電池充放電特性及其影響因素，建立了電池內阻、電動勢模型，提出了安時?能量守恆?開路電壓演算法（ ah ? coe ? ocu法）預測蓄電池的剩餘能量和荷電狀態計算方法，並進行溫度、循環使用壽命、自放電等補償，從而建立了蓄電池的充放電模型。
  8. In order to accomplish the global performance of the forklift truck, the author founds the mathematical model of the stability calculation, driving capability calculation, lifting capability calculation through the trials, design experience and national criterions. and then, the author carries out the mathematical model with the delphi language and makes it a release software

    為了實現平衡重式蓄電池叉車的總體性能參數確定，首先通過試驗、設計經驗以及國家標準，建立蓄電池叉車性能參數設計計算? ?穩定性計算、行駛性能計算、起升性能計算的數學模型，然後將數學模型用delphi語言編成具有人機對話功能的設計軟體。
  9. Based on the hydraulic model test of zhaojiabang pumping station in shanghai, a much more thorough study was made on the hydraulic and sediment deposition characteristics in this paper

    本文結合上海市肇嘉浜雨污水合建式泵站水力模型試驗研究課題，對大型多機組泵站圓形集水池的水力特性和泥沙淤積特性進行了較全面的研究。
  10. With the fund item sponsored by the national laboratory of hydrodynamics, the study on measurement method of propeller - induced pressure with using self - propulsion model has been carried out in depressurized towing tank

    在脈動壓力的模型測試研究方面，本文在水動力學國家重點實驗室基金項目的資助下，對在減壓拖曳水池中利用自航模進行空泡螺旋槳誘導的脈動壓力的測試方法進行了研究。
  11. The prediction of propeller - induced hull pressure fluctuation in non - uniform flow is studied by using theoretical calculation and model experiment systematically. an intact method and computer program for the prediction of unsteady cavitating propeller - induced hull pressure fluctuation in non - uniform flow is set up in this paper. the measurement of propeller induced hull pressure fluctuation in depressurized towing tank carried out in this paper is the first time inland

    本文從理論計算和模型試驗兩個方面系統地研究了不均勻流場中螺旋槳空泡誘導的船體表面脈動壓力的預報問題，建立了一套完整的預報非定常空泡螺旋槳誘導的船體表面脈動壓力的方法和程序，並在國內首次完成了在減壓拖曳水池中進行空泡螺旋槳誘導的船體表面脈動壓力測試。
  12. As an inlet structure, the forbay is an important part of the pumping station. the pressurized forbay, close in top structure, is a kind of particular forbay in which water is pressurized. based on the integral hydraulic model test of shanghai changqiao waterwork ' s water - transport pumping station, some research on the hydraulic characteristics of the pressurized forbay has been done in the paper. the main content is listed as follows : l. the hydraulic characteristics of the pressurized forbay in different water supply combination and different pump unit combination without divertion measure, and the reason of the poor flow state. 2. the hydraulic characteristics of the pressurized forbay with diversion pier, and the reason why the flow state can be improved. 3. the experimental research on the critical air suction condition of the pressurized forbay

    本文基於上海長橋自來水廠改造工程送水泵站整體水力模型試驗，對有壓前池的水力特性進行了研究，研究的主要內容如下： 1 、無導流措施的有壓前池在不同供水組合及不同機組開機組合條件下的水力特性，並分析了流態較差的原因； 2 、加設導流墩後有壓前池的水力特性，以及加設導流墩流態改善的原因; 3 、有壓前池進氣臨界條件的試驗研究； 4 、水泵進氣以後水泵性能的討論。
  13. The results of calculation simulation has good consistency with the experiment one and some useful conclusions are obtained

    計算結果與已進行的模型罩消聲水池的試驗結果吻合良好。
  14. For each approach, a much more thorough study was made on the hydraulic characteristics of the side - inlet sump by the hydraulic model test and the numerical simulation

    對每一種技術方案，應用數值模擬試驗與水力物理模型試驗相結合的研究方法，全面細致地研究了側向進水集水池的水力特性。
  15. This paper describes the law of main physical configuration parameters affecting on hydraulic characteristic of bifurcated pipe by means of hydraulic calculation and model test, suggestion is given on the selection of the configuration parameters

    摘要通過水力數值計算、水力模型試驗對西龍池抽水蓄能電站內加強月牙肋岔管水力特性進行了較系統的研究，總結了內加強月牙肋岔管主要體形參數對其水力特性的影響規律，並對內加強月牙肋岔管體形參數選擇提出建議。
  16. Based on the prototype observation and model test made for the periodic - flushing de - silting basin, the process and the division of the three - stage hydraulic flushing are put forward on the basis of the feature of water - sediment movement, and then the calculation formulas and the related parameters for the stages of emptying flushing ; retrogressive flushing and the flushing along the basin are given as well

    摘要依據定期沖洗式沉沙池水力沖洗的原型觀測和模型試驗，根據水沙運動特徵，提出定期沖洗式沉沙池水力沖洗三階段沖洗過程及劃分，分別給出泄空沖洗、溯源沖洗和沿程沖洗各階段的計算式和有關參數。
  17. On the basis of former experience, further study about upflow filtration and have air - water backwashing have been conducted through pilot - plant test. in this article

    本課題在總結前人經驗的基礎上，經過模型試驗，對該種濾池的過濾及反沖洗進行了深入的研究。
  18. Seed growth characteristics and process of maize with different genotypes at flowering stage under normal irrigation and drought stress condition were studied with pit growing experiment to modeling the hilly area of southwest china

    摘要採用池栽模擬試驗，研究了西南山地不同基因型玉米品種在花期乾旱和正常澆水條件下的籽粒發育特性及過程。
  19. On the basis of the experiment of nimh battery, theoretic analysis and parameters determined, simulation of nimh battery discharging has been carried, and simulation results are identical with the practice. then, the impulse phases quick charging has been applied to process the simulation of quick charging of nimh battery based on mechanism analysis and theoretic comparison about quick charging of nimh battery. simulation results are satisfactory

    在蓄電池充放電試驗研究、理論分析和參數選擇的基礎上，進行放電模型的驗證，得到了與實際相符的結果；同時，對蓄電池快速充電方法進行比較，應用脈沖分階段恆流快速充電方法進行蓄電池快速充電控制模擬計算，得到了滿意的結果。
  20. Based on the hydraulics series model experiments of the t type barrier stilling basin, the paper gives a full exposition to changing process of the current ' s flow regime of the t type barrier stilling basin and discloses the flow regime characteristics, the theory of energy dissipation, the shape optimization choice, the method on hydraulic design parameter and programme. what ' s more, it provides the expression of mathematics and key of the t type barrier stilling basin

    本文通過t形墩消力池的水力學系列模型試驗，完整地闡述了t形墩消力池水流流態的演變過程，揭示了t形墩消力池的流態特性、消能機理、體型優化選擇以及水力設計參數方法及程序，並給出了t形墩池界限水深的數學表達式及解。
分享友人
分享到 Line

分享到臉書