模擬進場 的英文怎麼說

中文拼音 [jìnchǎng]
模擬進場 英文
dummy approach
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 動詞1. (設計; 起草) draw up; draft 2. (打算; 想要) intend; plan 3. (模仿) imitate
  • : 進構詞成分。
  • : 場Ⅰ名詞1 (平坦的空地 多用來翻曬糧食 碾軋穀物) a level open space; threshing ground 2 [方言] (...
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  • 進場 : 1. (進入場地) march into the arena2. [航空] approach
  1. Considering multiplicity of automobile model style, more research about the external flow field of the automobile model by choosing different collocation and changing the detail about the foreside of automobile body was carried out

    2 、考慮到車頭形式的多樣性,選擇汽車車頭的不同布置和相關細節變化。將汽車車頭型在虛行外流的數值一步行分析研究,得到不同車頭形式所具有的各自特點。
  2. Aiming at the conveying - alcohol pipe system of a certin model gas generator in our school rocket engine field laboratory, this paper does a series of simulation studies using amesim, analyses and summarizes the results of simulations, and at the same time implements some waterhammer experiments, and compares the results with the ones of simulations

    本文針對我校火箭發動機試驗外的某型燃發器試驗酒精供應管道系統,使用amesim行了一系列的研究,對的結果行了分析和總結,同時還開展了水擊試驗,並與行了對比。
  3. A rational method of disposal for a the dowel bar is proposed through test - in - place and finite element analysis

    提出了傳力桿的合理布置方式,並通過現試驗和數值行了分析和驗證。
  4. Especially, the characteristic of even - harmonic mixer is analyzed and design technique to control the phase characteristic of the mixer is presented. the mixer circuits are designed ; the results of simulation and experiment test are compared and analyzed

    討論了利用eda工具的電路設計技術,利用hpads 、 ansoft軟體完成了電路設計、和製作了上述器件,並把電路以及測試結果行了比較和分析。
  5. Design and produce the hpvs ’ s electric simulate model, combine with the double close - loop controller, simulate the system ’ s self - excited phenomenon and the badly signal ’ s character, and to find the root reason and the solution method

    然後結合雙閉環控制器和電型,驗證所設計的控制方法和所搭建的控制器的有效性,並一步可能出現的各種情況,得到結論。
  6. In order to solve some technique problems of waterproof and drainage of tunnels based on controlling drainage, model tests, numerical simulations and site investigations were performed by use of two cases longtan tunnel and baiyun tunnel

    摘要針對控制排放的隧道防排水技術中一些關鍵問題,以龍潭隧道和白雲隧道為依託,採用型試驗、數值、現調查等方法行了系統研究。
  7. An efficient wind field simulation technique for wind - induced vibration analysis of long - span bridges is first introduced in this paper , and the statistic characteristics of the simulated wind field are then discussed on this basis , the time - domain expressions for the buffeting and self - excited forces acting on long - span bridges are further given a simple and practical method is presented for the non - linear parameter identification involved in the calculation of self - excited forces by using the above theory , the wind field and aerodynamic forces acting on the hong kong ting kau bridge are obtained the time - domain buffeting response analysis of the bridge shows that the analytic results agree quite well with the experimental ones this indicates that the theory presented in this paper has reached a practical level

    介紹了一種快速高效的用於大跨度橋梁風致振動分析的風方法,並對的統計性質行了討論和驗證在此基礎上一步給出了大跨度橋梁抖振力和自激力的時域表達方式,其中針對自激力計算中涉及的參數識別問題,提出了一種簡單實用的非線性參數識別方法本文採用上述理論,獲得了作用於香港汀九大橋上的風和氣動力,據此對大橋行的抖振響應時域分析表明,計算結果與風洞試驗結果吻合良好,說明文中述及的這套理論已達到實用的階段
  8. The test of negative skin friction along the single pile or wharf bent piles, which is modeled after piles of zanjiang harbor, is studied

    結合湛江港某碼頭工程基樁,用型試驗地質情況,對港口單樁、排架樁基負摩擦力型試驗。
  9. Advances of phase - field model simulation on solidification structure

    型凝固組織
  10. In the case of dipole model, it gets the precision distribution of the electric field of the inside and outside of the particle by solving the laplace equation. the influences of the separation distance of the particles on the shear yield stress are investigated. and the result of the laplace is also contrasted with the result of the finite element by ansys software

    在極化的狀況下,利用求解laplace方程,求解出多粒子下粒子內部的和周圍的局部電的表達式,求解出粒子表面的極化電荷、粒子內部的和外部的局部電,考慮了粒子間距對局部電的影響,還分析了,在不同外加電下對局部電的影響,並且與ansys有限元的數值結果行了對比。
  11. Further, analyse the characteristic of the seismic wavefield of fractural reservoir and the influence caused by fracture density, property of the filled material and the strike of fracture. fifthly, in term of research of zhangshulun et al., concisely discuss the arithmetic of the plane wave forward modeling and migration with phase shift method, in prestack common offset gathers and check the arithmetic by numerical simulation

    第四,用基於彈性?聲學近似的反射系數計算公式和本文提出的付氏變換子波生成法得到縫洞型的反射系數型和子波型並用vrselrf波延拓運算元對其行地震波數值一步分析了縫洞儲層的地震波特徵及縫洞密度、充填物性質和裂縫走向對其波特徵的影響。
  12. Optical field intensity has been simulated by beam transmission method ( bpm ), bend loss has been calculated by used of the method of conformal transformations, gain has been accounted by the method of lines, and different curved optical waveguides have been compared in the last

    採用bpm軟體在彎曲波導中的分佈,用保角變換和射線法計算其彎曲損耗及增益,最後對不同結構的彎曲波導行比較。
  13. This simulator uses the latest imaging technology to simulate the airport environment, during day or night, and under good or bad weather conditions

    機採用最先的影像科技,內不同的環境,如日間、晚上,甚至在惡劣天氣下,機地面的交通狀況。
  14. This dissertation furthers investigate a regional lmmcs formed of scene and middle level emphatically. on the basis of enhanced m - bus and zero power technological, the paper developed corresponding software and hardware products, and took a series of non - electromagnetism interfere ways and the dependability design. put up the platform to simulate spot environment, and carry on the overall experiment to verify : every technical indicator and performance index of long distance multi - point monitoring and controlling system can be satisfied, and the system has very high theory value and practical value

    本文重點介紹了長距離多點監控系統在地下管網中的應用實例,對由設備層利控制層構成的地下管網監控系統行了深入研究和分析設計,基於自主研發的增強型m - bus總線和零功耗設計技術開發了相應的軟硬體產品,採取了一系列抗電磁干擾措施及可靠性設計,並環境搭建了平臺,行了全面的實驗驗證。
  15. Employing the software, all showing and operating functions of the flow charts drawn and configured using the flow chart configuration software can be realized. operators can control and operate producing processes through these flow charts

    利用這款軟體,之前組態軟體為流程畫面組態的所有顯示和操作功能都得到了實現,操作員可以調用已經組態的流程畫面來行對現過程的監控管理。
  16. After a comparison of the practices to handan iron and steel corp., combining its own requirements the author put forward some problems existing in the accounting system in jinan steel city mining co., a simulated market thought to be. then the author set forth to analyze the system in several parts, costs breaking - down, costs control and costs examining, as well as his ideas of for or against with reasons, and how to improve

    本論文以濟南鋼城礦業公司成本核算的改革為先導,通過與邯鋼經驗的比較,結合礦山生產實際和需要,提出了公司核算存在的許多問題,並而對成本分解、成本控制、成本考核的做法行揚棄,肯定優點和成績,指出了不足,並予以改
  17. Chapter 4 discusses an optimal product line selection model which is based on choice data and then develops a modified model considering the possible violation on the basic assumption for discrete choice model and some applicable properties for practices. the last chapter focuses on the candy case with an effort of using these inferential results developed in this paper

    最後以糖果產品為例,行了糖果產品離散選擇試驗和離散選擇型的合,並通過改型的產品線優化選擇型為各細分市選出了可以推出的最佳產品。
  18. In the future, some issues need to be investigated further, which include : enforcement of the stability, raising reynolds number of the flow field being simulated, treatment of curve boundaries as well as further development of application

    以後有待深入研究的問題是增強方法的穩定性、提高的雷諾數、曲線邊界的處理和實用化的一步發展。
  19. The initial solutions of two - dimensional harmonic waves are given by landau expansion and the mean - flow - distortion is calculated by the approximation equation. furthermore, we employ iteration method and “ predictor - corrector approach ” to solve the nonlinear equations in order to implement the marching procedure, and the result of nonlinear two - dimensional stability is obtained precisely. the effect of pressure gradient is also studied here

    文中所發展的數值方法,包括採用landau展開給出二維諧波的初始解、的均流變形以及採用迭代和預估校正方法實現非線性方程的求解和推,得到了二維擾動的非平行非線性穩定性的精確結果。
  20. Through using abaqus software, a numerical simulation of equivalent stress field of flanging deformation process with cone - shaped punch was carried out, and compared with simulation of flanging deformation with column - shaped punch

    摘要利用abaqus商用軟體,對錐形沖頭翻邊變形過程的等效應力行了數值,並與柱形沖頭的翻邊變形行了對比。
分享友人