橡膠彈簧 的英文怎麼說

中文拼音 [xiàngjiāodànhuáng]
橡膠彈簧 英文
balata ring
  • : 名詞1. (橡樹) oak2. (橡膠樹) rubber tree
  • : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
  • : 彈名詞1. (彈子; 小球形的東西) ball; pellet 2. (內裝爆炸物, 具有破壞和殺傷能力的東西) bullet; bomb
  • : 名詞1. [音樂] (樂器里能發聲的薄片) reed2. (器物上有彈力的機件) spring
  • 橡膠 : rubber; vulcanizate
  1. Air spring for automotive suspension - rubber bellows

    汽車懸架用空氣氣囊
  2. Elastomer mounts - pot bearings and fail safe pot bearings, types a to g

    -元件.帶和不帶保險的罐形軸承. a型至g型
  3. The results showed that : ( 1 ) the models used by author and the analysis are useful and can be practiced. ( 2 ) after using isolation technology, the structure ' s period, earthquake response, base shear force and acceleration are all decreased markedly and the horizontal displacement focuses on isolation layer. ( 3 ) under frequent earthquake action, the shear force ratio between layers is close to 0. 35 ; in according with the provision in aseismic design code that the horizontal seismic reduction coefficient can choose 0. 53 and the upper building can be designed by decreasing one degree

    計算模型分別採用三維空間模型及規范中建議的、質量模型,隔震層採用疊層隔震支座,運用大型結構有限元計算程序sap2000以及自主開發的nba結構程序計算隔震結構在多維地震動輸入下的動力非線性時程反應,同時研究了隔震結構在溫度變化的作用下,結構各桿件的內力變化,通過對變電建築物在傳統抗震作用下及隔震作用下的分析比較,得出一些有益的結論。
  4. The calculation of rectangular type air spring ' s vertical stiffness with finite element method

    有限元法計算長方型空氣隔振器的垂向剛度
  5. Abstract : this article discussed the structural characteri stics, the main property and some applications

    文摘:對滾環式橡膠彈簧的結構特點、主要性能及一些應用情況作了簡明的分析。
  6. This device takes rubber ( plastic cement ) as substitute for metal bumper, inside it an inflated tyre is set, ineffective part joining front of supporting frame and bumper is removed, and replaced by metal connecting bar, bar front is fixed unto bumper, and bar ' s rear connected with spring, spring ' s rear is fixed to a steel bowl firmly hugging closely an inflated rubber ball ( two ), rear ball is closely hugged by another steel bowl at front of another spring, and another rubber ball placed at spring ' s rear

    該裝置由(塑)代替金屬保險杠,內置充氣胎,去掉前端大樑與保險杠連接的無效部分,以金屬連杠代替,連杠前端固定於保險杠上,後端連接的後端固定一鋼碗緊貼充氣皮球(兩個) ,后皮球與另一的前端鋼碗緊貼,另一的後端再放置一充氣皮球。
  7. Rubber spring type

    橡膠彈簧
  8. The main vibrating spring is made of shear rubber spring, resuling in low noise and long life

    採用剪切橡膠彈簧作主振,噪音低,壽命長。
  9. The flybar ( tm ) 1200 can propel you over 6 feet in the air with a innovative, patented, fully - adjustable elastomeric spring system

    產品說明:可調節的橡膠彈簧,高強度的鋁合金材質包括超寬的腳蹬有助於安全保護。
  10. To avoid this discharge, install a spring - loaded, rubber seated check valve ahead of the backflow assembly

    為了避免這種排放,要在防迴流閥總成前面安裝一個驅動、閥座的止回閥。
  11. Torsion spring checks shall have reversible elastomer discs and in operation produce drip tight closure against reverse flow caused by backpressure or backsiphonage

    扭力止回閥應該配置雙向合成閥瓣,並且在工作時對于反壓力和反虹吸所產生的迴流具有防滴漏關閉性能。
  12. If the pipe needs shock absorption or shockproof, shockproof hanger or support should be selected. the load should be equal to the loading capacity and rigidity of the shockproof spring hanger or rubber hanger

    3管道需要減震防震時,應選用防震吊掛或支座,支承的荷載應與防震用的支承能力和剛度相匹配。
  13. This device ' s parts are : rubber bumper, inflated tyre, springs with steel bowls, inflated rubber balls

    本裝置的部件有:保險杠、充氣內胎、帶有鋼碗的、充氣皮球。
  14. Hydro - rubber spring type

    液體
  15. It is of built - in type, single seal face, single spring and rubber - bellows mechanical seal

    內裝式、單端面、單波紋管機械密封。
  16. Load is supplied to rubber or spring and weighted by measurement of displacement ( distance ), which method requires obvious dimensional change and is not a good choice of starting torque compensation

    載荷重量施加在上,通過測量位移(即距離)變化來間接稱重,間接稱重一般需要有比較明顯的尺寸變化,間接稱重方式一般不適合做起動力矩補償
分享友人