檢波器小線 的英文怎麼說

中文拼音 [jiǎnxiǎoxiàn]
檢波器小線 英文
geophone flyer
  • : Ⅰ動詞1 (查) check up; inspect; examine 2 (約束; 檢點) restrain oneself; be careful in one s c...
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : Ⅰ形容詞1 (體積、面積、數量、強度等不大) small; little; petty; minor 2 (年紀小的; 年幼的) youn...
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  1. Figure 91 illustrates a string of detectors and figure 92 the string assembled on a hasp for transportation.

    圖91表示檢波器小線,而圖92表明為了運輸方便把扣在鐵環上的情形。
  2. In the paper, it is discussed to the winding of hydrophone array, the deviation and depth difference between focus and hydrophone array, and the deviation of time - distance curve, and presents a way to solve the problems

    本文針對排列彎曲、炮點偏移距大、炮點與不在同一深度以及時距曲偏移等問題進行了討論,並提出了校正和解決的方法。
  3. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置圈輸入偏置電流和信號測試電流,兩者產生的偏置磁場在控制圈產生感應信號,測電路測控制圈端電壓並提取含有轉子位移信息的電壓信號,該信號經半整流電路和低通濾電路后得到與轉子位移成正比例的直流信號,再由pid控制轉換為轉子位移的控制信號,最後控制信號輸入功放電路產生控制電流,實現閉環控制。
  4. It can acquire the voltage on the test appliance and current in the circuit. and it can see these electrical signals as its input and calculates based on the data and gives the parameters and waveform that user needed. the parameters we can get through calculation include power factor, joule ' s integral, available value, maximal value, minimum value, time constant etc. recently, there are many scholar is studying the algorithm that calculate the parameter using test data, but many of them adopt the heuristic method, not using the test data directly

    本課題研製一套電試驗參數高速採集系統,能夠測試驗迴路中試品上的電壓信號和迴路中的電流信號,並根據這些電信號的數值利用計算機進行在計算,並給出用戶需要的各種電參數值和用戶需要的形圖,通過計算得到的電參數有功率因數、焦耳積分、有效值、最大最值、時間常數等。
  5. The research results are controlled source which has linear or nonlinear variabe frequency scan function and the seismic instruments which match with it, and the method of small group intervals, small offset, much more channels, short array length, high - frequency receivers are applied during the link of data acquisition, and that the techniques of the refraction static correction, the noise suppressing, the high - resolution velocity analysis, the wavelet length compression, the wavelet zero - phase, and the prestack migration should be applied emphasizedly during the link of data processing and interpretation

    研究表明,對于城市活斷層的抗干擾高解析度淺層地震勘探,在數據採集環節應採用具有性或非性變頻掃描功能的可控震源和與其相匹配的地震儀,以及道間距、偏移距、多接收道、短排列和高頻接收的工作方法;在數據處理與解釋環節,要重視折射靜校正技術、噪聲壓制技術、高精度速度分析技術、子壓縮技術、子零相位化技術和疊前偏移技術等的應用。
  6. In order to better detect the image edge information, firstly, non ? linear median filter technology of characteristic direction was applied to filter out the gauss noise ; secondly, ( 3, 1 ) biorthogonal spline wavelet was used as the primitive wavelet filter, adopting lifting scheme to build the most superior biorthogonal wavelet filter, and applying the superior biorthogonal wavelet to the multiresolution wavelet edge detection ; at the same time, floating threshold was defined and applied to the image edge detection, and the image edge position was located accurately

    在激光探測系統中,微弱的回圖像淹沒在強背景噪聲中,為更好地測這類含噪圖像的邊緣信息,首先應用特徵方向非性中值濾技術,濾去高斯噪聲;其次,選擇( 3 , 1 )雙正交樣條作為原始,採用提升方案構造最優雙正交,應用構造的雙正交進行多尺度邊緣測;同時,通過定義浮動閾值,並應用於圖像邊緣測,較準確地定位了邊緣位置。
  7. In order to better detect the image edge information, firstly, non - linear median filter technology of characteristic direction was applied to filter out the gauss noise ; secondly, ( 3, 1 ) biorthogonal spline wavelet was used as the primitive wavelet filter, adopting lifting scheme to build the most superior biorthogonal wavelet filters and applying the superior biorthogonal wavelet to the multiresolution wavelet edge detection ; at the same time, floating threshold was defined and applied to the image edge detection, and the image edge position was located accurately

    在激光探測系統中,微弱的回圖像淹沒在強背景噪聲中,為更好地測這類含噪圖像的邊緣信息,首先應用特徵方向非性中值濾技術,濾去高斯噪聲;其次,選擇( 3 , 1 )雙正交樣條作為原始,採用提升方案構造最優雙正交,應用構造的雙正交進行多尺度邊緣測;同時,通過定義浮動閾值,並應用於圖像邊緣測,較準確地定位了邊緣位置。
  8. In order to ensure the real - time monitor this design choose special dsp chip and high - efficiency a / d transfer chip, the former ensure the time is enough to complete the calculation. tests proved that this equipment can satisfy the requirement of international standards about harmonic detection

    論文提出了基於dsp的電能質量在測最測量系統的設計方案。論證了用於電能質量測系統的a / d轉換的位數應大於等於16位,才有可能使各次諧測精度達到於1 %的相對誤差。
  9. Then, a kind of wnn based on single - scaling multidimensional wavelet frames and its matching pursuit algorithm is introduced. it is applied to approximate the nonlinear terms with lipschitz property of nonlinear systems to establish the adaptive state observer. the robust fault detection is realized by the observer, demonstrating the predominant performance of the wnn

    然後利用一種基於單尺度框架的網路,逼近一類滿足lipschitz條件的非性系統的非性項,構造自適應狀態觀測,實現了系統的魯棒故障測,同時採用徑向基神經網路進行殘差處理,實現了故障預報。
  10. Method of fault detection based on anfis nonlinear observer using continuous wavelet transform

    性觀測的連續變換故障
  11. A llmmse filter is designed to reduce noise based on the noise model to improve snr of images. making use of the shape and lightness characters of feature points to detect the feature p oints from images. because the accuracy of feature imaging point ' s centroid has close relationship with measuring accuracy, an algorithm based on iteration of the center of the track window is used to improve the measurement accuracy

    圍繞著提高測量精度的要求,分析了影響ccd圖像質量的三類隨機噪聲,建立局部統計特性為高斯分佈的簡化圖像噪聲模型,利用性最均方誤差濾對圖像進行預處理,而後根據特徵點的亮度和形狀特徵對特徵像點進行測,進一步在特徵像點的匹配中採用自適應的質心迭代演算法提高跟蹤精度。
  12. In the yield data acquire multi - line geometric in a radial pattern is adopted. before theoretical explanations about the non - uniqueness of inversions and the necessity of constrains are illustrated, the description of linear travel - time interpolation ( lti ) calculations, the derivation of jacobian linear equations, and the deductions of solving large sparse matrix equations, i. e. the lsqr iterations, are involved. in order to cope with the uncertainties in tomography, we reach several categories on constraint methods

    對於野外數據採集採用多測上放射狀布置;圍繞層析成像方法,文章分析了性差值射追蹤lti技術,推導出在矩形網格內速度以雙性關系變化時方程組的解析式,進一步詳細探討方程組的求解方法,即最平方正交分解法,並給出了迭代公式。
  13. The list betterments aimed at the properties of system : through the testing of dc voltage, pulse width and inverting voltage and frequency can be regulated online to fit for different steady load ; reducing speed ripples by compensating with nonzero voltage working proportional time ; adopting the technology of harmonics suppression. as a result, the high precision and wide speed control is realized and the step out is overcome

    針對系統的性能指標,做了如下改進:對直流側電壓的測,在調整逆變導通脈寬、輸出電壓和頻率,可以適應不同大的恆負載;並用非零電壓矢量作用時間進行補償的方法,減電機的低速脈動;加入了諧抑制技術等。
  14. Based on the analysis of autonomous underwater vehicle ( auv ) sensor failure, diagnosis methods corresponding to three kinds of sensor failure are presented, that is, through that no sensor output for a long time to diagnose the fault of sensor signal gathered keeping unchanged, linear smoothing to solve the vibration of sensor signal, wavelet transform to inspect the broken sensor signal

    摘要在分析水下機人傳感故障形式的基礎上,對傳感可能出現的三種故障形式分別給出了相應的診斷方法,即通過傳感長時間採集不到數據來診斷傳感信息保持不變的故障,性平滑濾解決傳感輸出振蕩,變換測傳感信息的突變。
分享友人