檢波線 的英文怎麼說

中文拼音 [jiǎnbōxiàn]
檢波線 英文
seisline
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  1. These currents become the source of new electromagnetic waves which can be detected by suitable pickup coils.

    這些電流成為能被合適的拾波線圈檢測的新的電磁波源。
  2. Figure 91 illustrates a string of detectors and figure 92 the string assembled on a hasp for transportation.

    圖91表示檢波器小線，而圖92表明為了運輸方便把小線扣在鐵環上的情形。
  3. The wires and detectors are liable to induction from the power lines.

    導線和檢波器易受高壓線感應。
  4. A uhf sensor is designed and fabricated, which mostly consists of antenna, uhf amplifier, high pass filter, and broadband wave detector

    通過與大華無線電廠合作，研製了超高頻傳感器，其主要由天線、超高頻放大器、高通濾波器、寬帶檢波器等組成。
  5. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現：激勵源電路部分，由分頻電路和頻率合成電路組成，產生頻率穩定的激勵信號以確保檢測任務的正常進行；傳感器變換電路部分，由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成，主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號，易於后續電路處理；由dsp晶元構成的微處理系統，主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  6. In the part of modulation and demodulation, we analyzed the principles of harmonic mixer, detectors, power dividers / combiners and branch - line couplers

    對調制/解調器射頻電路部分，包括亞諧波混頻器、檢波器、功率分配/合成器和分支線耦合器基本原理進行了分析。
  7. In the paper, it is discussed to the winding of hydrophone array, the deviation and depth difference between focus and hydrophone array, and the deviation of time - distance curve, and presents a way to solve the problems

    本文針對排列彎曲、炮點偏移距大小、炮點與檢波器不在同一深度以及時距曲線偏移等問題進行了討論，並提出了校正和解決的方法。
  8. The attenuators and the sensitivity of detectors are calibrated in varied frequencies. the attenuation of the cable is also calibrated

    對晶體檢波器在不同頻率下的礦靈敏度進行了測定；對同軸信號線的衰減量瓣行了標定。
  9. The paper includes four sections followed here : the first section studies the modeling of signals of pulse doppler radar seeker, and establishes a radar signal simulation model, including radar emitting signal model, receiving signal model, receiving echo signal model, clutter model, noise model, sum channel directional pattern of antenna model, difference channel directional pattern of antenna model, sheltering model, rcs model, glint noise model, etc. the second section studies signal processing of pulse doppler radar seeker, and establishes radar signal processing mathematical model and data processing mathematical model for simulation, including windowing, doppler filtering, envelope demodulation, pdi, cfar, centering, velocity tracking, angle tracking, a - b filtering, etc. the third section studies the modeling of modified proportion guiding, and establishes guiding model, then dynamic simulation results is provided

    論文的主要工作包括四部分：第一部分研究了脈沖多普勒雷達導引頭的信號建模問題，建立了雷達信號模型，主要包括：發射信號模型、接收信號模型、目標回波信號模型、雜波模型、噪聲模型、和差通道天線方向圖模型、遮擋因子模型、接收機噪聲模型、目標雷達截面積統計性模型、目標角閃爍模型等。第二部分研究了脈沖多普勒雷達導引頭的信號處理模式，建立了信號和數據處理模型，主要包括：加窗和多普勒濾波、包絡檢波、檢波后積累、頻域cfar處理、速度定心、速度跟蹤、角跟蹤、 ?濾波等，然後給出了信號處理流程。
  10. The research results are controlled source which has linear or nonlinear variabe frequency scan function and the seismic instruments which match with it, and the method of small group intervals, small offset, much more channels, short array length, high - frequency receivers are applied during the link of data acquisition, and that the techniques of the refraction static correction, the noise suppressing, the high - resolution velocity analysis, the wavelet length compression, the wavelet zero - phase, and the prestack migration should be applied emphasizedly during the link of data processing and interpretation

    研究表明，對于城市活斷層的抗干擾高解析度淺層地震勘探，在數據採集環節應採用具有線性或非線性變頻掃描功能的可控震源和與其相匹配的地震儀器，以及小道間距、小偏移距、多接收道、短排列和高頻檢波器接收的工作方法；在數據處理與解釋環節，要重視折射靜校正技術、噪聲壓制技術、高精度速度分析技術、子波壓縮技術、子波零相位化技術和疊前偏移技術等的應用。
  11. The cross - well seismic forward modeling program can be applied to geological model that has different velocities and dips to calculate cross - well seismic synthetics for given sources and receivers by ray tracing the least traveltime or four order differential wave equation

    研製的井間地震正演合成記錄的程序，可用來對不同速度、不同傾角的地質模型，通過最小旅行時的射線追蹤或四階差分聲波波動方程，計算出對于給定震源和給定檢波點的井間地震合成記錄。
  12. The amplitude values at a certain moment in a seismic record received at a shotpoint and a detection point might come from reflections of various points on an underground ellipsoid, which has the shotpoint and the detection point as its focuses, and the connected line of the shotpoint point and the detection point as its major axis

    摘要一個炮點和一個檢波點接收的一道地震記錄上某一時刻振幅值，它可能來自地下一個橢圓面上各個點的反射，該橢圓面以炮點和檢波點為焦點，炮點和檢波點的連線為長軸。
  13. Firstly, the temperature varies in a large range in the place where the gap sensor works, so this paper analyzes the temperature drift of gap sensor, and finds out that the main reasons which result in temperature drift are the resistance of detecting coil and demodulating circuit parameters. to resolve this problem, a practical design of detecting coil is given, and a compensative measure considering the detecting coil and demodulation circuit is proposed to improve the temperature stability of gap sensor

    首先，針對間隙傳感器工作環境溫度變化較大的情況，本文對間隙傳感器溫度漂移現象進行了分析，認為檢測線圈電阻和檢波電路參數變化是造成傳感器溫漂的主要原因，建立了檢測線圈的數學模型，提出了檢測線圈和檢波電路綜合補償方法，解決了間隙傳感器的輸出信號溫度穩定性的問題。
  14. Through observing the influence of different geometry to reflect wave in deep layer, using seismic digital simulation tracing method, analyzing the influence of max - offset, trace interval, fold and geophone planting to reflecting energy, this article, summarizes, in both theory and practice, the application result of " bin stack " acquisition method

    通過不同觀測系統對提高深層反射信號的影響，採用地震數值模擬射線追蹤方法，分析了觀測系統中最大炮檢距、道距、覆蓋次數及檢波器埋置，對提高深層反射信號能量的影響，從理論到實踐總結了「面元疊加」採集技術的應用效果。
  15. Imagine an online seismometer that notifies a student of a seismic event through email or instant messaging

    試想，一個在線用於通過電子郵件或者即時消息通知試驗者地震事件的地震檢波器。
  16. The concept of otn node transmission model is introduced. the requirement of otn node transmission model is discussed. this model uses the frequency domain transmission matrix to express the otn node transport characteristics. the simplified model based on wdm and im - dd systems, the relationship between node characteristics and model parameters and measurement of model parameters are also discussed. at last a briefly discussion on how to develop the otn simulation and cad software based on our model is demonstrated

    在線性時不變的假設下，提出利用頻域傳輸矩陣來表示節點傳輸特性的方法給出了oxc和oadm兩類光傳送網節點的統一的表示根據目前通用的波分復用強度調制直接檢波系統的特點對復雜的頻域傳輸矩陣進行了簡化並對通常所關心的節點主要性能指標與模型參數的關系模型參數的測量和計算模型的設計與計算機模擬輔助設計軟體開發的銜接問題進行了討論。
  17. The purpose of this paper is to resolve some key technologies of the amplitude - modulation inductive displacement transducer signal processing circuit with nanometer resolution, such as the design of high stability signal generating circuit ; the technology of high precision digital phase - sensitive detection circuit ; the technology of digital filter and linearization, etc

    本文主要研究調幅式電感位移傳感器精密測量系統中涉及的高精度載波信號發生技術、高精度數字相敏檢波技術、數字濾波及線性擬和等關鍵技術，目的是進一步改善調幅式電感位移傳感器精密測量系統的測量精度，適應納米級測量的要求。
  18. The method is better than others. firstly, the system sets up several models to assist detection work, such as road model, illumination model, shadow model and relationship model among them ; secondly, it introduces hue. saturation degree information to distinguish vehicles from shadow ; thirdly, it makes use of binary decision tree to analyze pressing line of vehicles to improve the reliability of the system ; fourthly, it puts forward a way of one dimension video tracing to resolve the problem of vehicle velocity detection

    該方法通過設置在每條車道中的兩條相互垂直的虛擬檢測線來檢測交通流信息（如車流量、車速等） ；設計一種彩色分段檢測技術來提取運動車輛的尺寸信息和色彩信息，再利用分類決策樹和濾波演算法確定運動車輛存在與否，增強了車輛、陰影、噪聲和背景之間的區分能力；設計了一種車速視頻檢測方法。
  19. In the blue print of the digital, make sure of the logarithmic amplifier, a / d / a converter and fpga realize the if amplifier, big dynamic range agc, detect and video process same as that in the blue print of the analog

    在數字方案中，筆者結合軟體無線電技術，通過使用對數放大檢波器、 a / d / a轉換器以及fpga軟體實現了同樣的中頻放大、大動態范圍的agc控制、以及檢波、視頻信號處理等功能。
  20. First, this paper introduces the difference of all - power radiometer and dicke radiometer sensitivity, and gives normal calibration equation and periodic calibration equation of antenna temperature, and analyses calibration error due to square - law detector illinearity

    本文在總結前人研究工作的基礎上，首先比較了全功率輻射計和迪克型輻射計的靈敏度，討論了輻射計天線溫度的反演和周期定標技術，分析了檢波器非線性特性對輻射計定標結果的影響。
分享友人
分享到 Line

分享到臉書