正常損耗 的英文怎麼說

中文拼音 [zhēngchángsǔnhào]
正常損耗 英文
fair wear and tear
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 正常 : normal; regular; average
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. In the course of working, ， the plow will make use of the shuttling method so that it can dig alternately either on the left or on the right. compared to the unilateral plow, it can improve the productivity because it can help leave off the soil 、 take from the consumed energy and reduce the empty journey. to meet the requests above, we will use a remote cylinder with both a small cubage and double functions, approximately designing the plow to be columniform and symmetric. after the experiment for a period in the field, we found that the most frayed areas had happened at the places of both plow shank and share and at the same time the base of the remote cylinder had ruptured suddenly

    與單向犁相比，其優點在於：耕地無開、閉壟，地表平整，降低了耕后整地的能量消耗，減少了地頭的空行程，因而大大提高班次生產率。為了滿足犁體梭式作業的要求，我們採用了一隻小容積雙作用的液壓油缸；同時對犁壁曲面的形狀採用了近似圓柱形的對稱設計。但經過一段時間的田間試驗，我們發現：該犁犁胸部分的犁脛和犁鏵上的犁尖在工作中磨損較為嚴重；主犁梁和油缸缸體的連接部分（即油缸底座）突然發生了斷裂，造成整個犁體無法正常工作。
  2. 6 the objectives of administrative management the administrative service division should further, to the series of questions appeared in company s production and operating activities, be sound further and perfect every rule management system of the company, to set up scientifically, high - efficient and practical management system

    進一步加強設備管理，設備動力系要充分考慮生產所需，制定切實可行的設備大中小修計劃，並確保計劃得以實施，保證設備正常高效運轉，保障水電汽的正常供給，加強易損易耗件的備件管理。
  3. E. g. by a quite practice of attrition we were able to reduce our staff size and cut our annual expenses while not firing anyone and risking a decrease in employee morale

    通過正常的人員自然損耗，我們得以減少員工人數並削減年度費用，同時也避免了因採取解聘行為而導致員工士氣降低的風險
  4. This warranty does not extend to or cover your unit or any part of it which in the reasonable opinion of the company has worn by fair wear and tear, or run outside the technical specifications of the equipment of has been damaged or rendered defective by accident, willful act, negligence ( other than that of the company ), misuse, alteration, or repair carried out by other than the company ( or by permission with its dealers ), usage of the other than the company ' s parts

    此保證並不包含產品或配件由於正常使用而發生的磨損或損耗、未按照技術說明書操作而造成產品損壞、以及因意外事故、故意行為或過失造成的損壞（除非是由我司造成的）以及操作不當、自行改造、自行維修（除非經銷商允許）以及使用非本公司的零件。
  5. If the loss or damage to the goods is caused by the intentional act or fault of the insured, or arising from inherent vice or normal loss of the insured goods or delay in transit, or falling under the liability of the consignor, the insurance company is not liable to pay for the loss

    如果貨物的損失或損壞是由於投保人故意行為或過錯所致，或是由於保險標的物固有的毛病和正常耗損所引起的，或是在運輸途中延誤，屬于承運人的責任范圍，那麼保險公司不負責賠償損失。
  6. It happens to all of us : joint pain from a lifetime of lifting, bending and normal wear and tear

    在我們所有人一生中，都有可能在舉物時、彎曲時及正常損耗時發生關節痛。
  7. Vulcanized rubber - test method for hf dielectric constant and dielectric loss angular tangent

    硫化橡膠高頻介電常數和介質損耗角正切值的測定方法
  8. Vulcanized rubber - determination of dielectric constant and dielectric loss angular tangent value

    硫化橡膠工頻介電常數和介質損耗角正切值的測定方法
  9. Vulcanized rubber - test method for hf dielectric constant and dielectric loss angular tangent value

    硫化橡膠高頻介電常數和介質損耗角正切值的測定方法
  10. Goods purchased or taxable services consumed in the production of work - in - progress or finished goo ds which suffer abnormal losses

    （六）非正常損失的在產品、產成品所耗用的購進貨物或者應稅勞務。
  11. Fair wear, tear and gradual deterioration

    正常耗損及逐漸腐朽變質
  12. Test method for dielectric loss angle tangent and dielectric canstant of organic film for use in capacitors

    電容器用有機薄膜介質損耗角正切值和介電常數試驗方法
  13. Vulcanized rubber - determination for industrial frequency dielectric constant and dielectric loss angular tangent

    硫化橡膠工頻介電常數和介質損耗角正切值的測定方法
  14. This warranty is not transferable and excludes routine maintenance, routine checking or cleaning, consumables, service maintenance kits and damage caused by misuse or negligence

    此保養不能轉讓，保養?圍不包括定期維修、檢查、清潔、消耗品及因錯誤操作、疏忽事故而導致的損壞或不正常運作。
  15. Of a dielectric, the product of dielectric constant and the tangent of its dielectric loss angle ; a measure of the heating effect which occurs in dielectrics

    對于電介質來說，它是介電常數和介質損耗角的正切的乘積，這是對出現在電介質中的熱效應的量度。
  16. It is approved that the deficiency level keeps relatively the lowest and the dielectric constant however shows the highest, if the contents of mn3 + and la3 + are comparatively the same. on the contrary, the dielectric constant decreases with increasing the contents difference of mn3 + and la3 + ions. the effect of overlap appeared when the dielectric loss was aroused due to the activation of positive and negative carries at certain temperature, which brought abnormally high dielectric loss

    證實了材料在mn ~ （ 3 + ）含量與la ~ （ 3 + ）含量相當時體系中產生的缺陷相對最少，其介電常數最大，反之隨兩者含量偏差的增大而下降；材料中由正負兩種局域載流子在一定溫度下激活過程中產生的損耗出現了迭加效應，給出了異常的高損耗值;材料中隨著mn摻量的增大，體系提供的3d電子數增多，電子輸運通道改善，導電性提高。
  17. The dielectric constants of silica - rich, alumina - rich, and stoichiometric mullite ceramics are 5. 5, 6. 0 and 6. 3 respectively. the dielectric constant of mullite - si / c / n composites is related with the sintering parameters. with the increase of the sintering temperature and dwelling time, the " " and tg of mullite - si / c / n composites are decreased, this phenomenon is related with the change of the microstructure and phase composition of nano si / c / n powders

    莫來石- si c n復合材料的介電常數與熱壓燒結工藝有很大的關系，隨熱壓燒結溫度（ 1450 1600之間）的升高，燒結時間（燒結溫度為1550 ）的增長，莫來石- si c n復合材料的介電常數實部、虛部及介電損耗角正切均明顯下降，這與吸收劑的性質隨溫度和時間的變化有關。
  18. Method for determination of loss tangent and permittivity of electrical insulating materials in sheet form lynch method

    薄型電絕緣材料損耗角正切值和介電常數的測定方法
  19. The system had auto startup and stop function by software. the dsp based motor control system had lower current harmonic, more efficient use of supply voltage than spwm, less switch loss. on the other hand, this system make a lower noise for the pwm modulation. frequency is up to 20khz

    本系統實現了電機的軟啟動、軟關斷功能，電機電流的諧波失真較少，電壓利用率比常規的正弦波脈沖寬度調制（ spwm ）有了較大的提高，器件的開關損耗也得到了明顯的減少。
  20. But the power electronic devices in pwm power amplifier are working in the on - off state, easily producing the over - voltage and over - current phenomena. under tht condition the power electronic devices are bearing higher dv / dt, di / dt and more energy losses, influencing itself capability and life - span. at the same time, the dv / dt, di / dt also cause the severe electromagnetism disturbances, such as the disturbances in the photoelectric theodolite will make the other systems working improperly

    然而在pwm功率放大器的主迴路中電力電子器件工作在開關狀態，易產生過壓、過流現象，器件承受較高dv dt 、 di dt並產生較大的損耗，影響器件本身的性能和壽命，同時dv dt 、 di dt還會產生嚴重的電磁干擾，如在光學測量設備中，這種干擾將會影響其它系統正常運行。
分享友人
分享到 Line

分享到臉書