步長值 的英文怎麼說

中文拼音 [bùzhǎngzhí]
步長值 英文
step value
  • 步 : Ⅰ名詞1 （步度; 腳步） pace; step 2 （階段） stage; step 3 （地步; 境地） condition; situation; st...
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  1. In fluid field solving, the numerical flux is estimated using high - accuracy roe scheme with limiter. in time marching, we use dual - time stepping together with implicit lu - sgs scheme and get reasonable results efficiently. the difference of the fluid computation between single grid and overset grids lies in the dispose of the computation boundary

    流場解算時，對流場數值通量的求解採用的是帶限制器的高階精度roe格式，時間推進採用了含雙時間步長的隱式lu - sgs （ lower - uppersymmetricgauss - seidel ）格式，提高了求解的效率。
  2. The viscid flux is discretized by second - order central difference scheme. baldwin - lomax turbulence model is implemented in navier - stokes flow solver. for steady - state calculations, a four - stage runge - kutta scheme with convergence acceleration techniques such as local - time stepping and implicit residual smoothing is used

    其中，定常計算中的時間推進採用四步runge ? kutta方法，並應用了當地時間步長、隱式殘值光順等加速收斂措施；非定常計算中的時間推進採用jameson的隱式雙時間方法。
  3. Comparing numerical character of above two models, it shows that the variance of atmosphere motion must be modified so the time step used in numeric simulation has no effect on numerical character of chaff clouds

    對數值模擬模型的分析表明必須對大氣的運動方差進行時間離散化補償，進行離散化補償后箔條雲團的數字特徵不受模擬時時間步長的影響。
  4. 4. a 2 - d and 3 - d euler equations and n - s equations are solved using the cell - centered finite volume method and four - step runge - kutta scheme on the cartesian grids with standard convergence acceleration techniques such as local time stepping, enthalpy and implicit residual smoothing

    使用jameson中心有限體積法和runge - kutta時間推進方法，求解了關於二維、三維復雜流場的euler 、 navier - stokes方程，採用了當地時間步長、隱式殘值光順等多種加速收斂方法。
  5. In this paper, the upwind scheme and the central scheme are presented for solving 3 - d n - s equations using the cell - center finite volume spatial discretization and four - stage runge - kutta time stepping scheme, with standard convergence acceleration techniques such as local time stepping and implicit residual smoothing

    在n - s方程的數值計算上，採用了中心差分格式和迎風格式，用格心格式的有限體積法進行了空間離散，用四步龍格?庫塔法作顯式時間推進，並採用了當地時間步長和隱式殘差光順等加速收斂措施。
  6. The explicit finite element method ( fem ) based on the varying time - step was selected to analyse the dynamic roll - pass process ; the nodes on the leading face of the steady - state elements set was extracted and projected onto a plane to give the required mesh, also called the origin mesh ; the implicit fem was selected to analyses the inter - pass transient thermal process ; a geometric part from the mesh was generated and meshed by using the quadrilateral elements, a heat transfer analysis was selected to transfer the node temperature data ; a new model was created by using hexahedral elements, mapping the node temperature and the equivalent plastic strain on the integration points

    利用基於變步長中心差分格式的顯式積分方法分析瞬態軋制過程；提取穩態單元集節點形成截面網格；利用隱式積分方法分析軋制道次間隙瞬態溫度場；對型鋼斷面進行平面四邊形網格劃分並映射節點溫度數據；利用六面體單元構建有限元分析模型，映射單元節點的溫度、積分點的等效塑性應變，進行數值分析。
  7. In this dissertation, two kinds of optimization, methods are proposed. firstly, only these linking weights corresponding to the control rules that affect the control performance significantly are updated in order to reduce the compute works and speed up the training progress. secondly, the updating step is adjusted adaptively in accordance with the error and the change of error of the system based on the t - s model to get better performance

    針對模糊神經網路控制器一般存在著在線權值調整計算量大、訓練時間長、過度修正權值可能導致系統劇烈振蕩等缺點，提出了兩種模糊神經網路控制器的優化方法：在線自學習過程中僅對控制性能影響大的控制規則相關的權值進行修正，以減小計算量，加快訓練速度；基於t - s模糊模型，根據偏差及偏差變化率大小動態自適應調節權值修正步長，抑制控制器輸出的劇烈變化，避免系統發生劇烈振蕩。
  8. Successive linear programming is proposed to solve it with the help of lindo6. 1 program. digital tests are carried out and results show that the algorithm is practical and efficient for distribution systems loss minimization and can be used to optimize real distribution system operation

    在求解過程中，結合了線性規劃模型演算法程序lindo6 . 1 ，並引入迭代步長控制系數k ，對控制變量的增量作有效的調整，同時，選取就地無功平衡點作為迭代初值。
  9. Numerical aperture of step - index multimode optical fibers by output far - field radiation pattern measurement

    用輸出遠場輻射圖測量確定步長指數多模光纖的數值孔徑
  10. The thesis also involves some detailed techniques come across in the numerical simulation process of elastic dynamic fem analysis, and remarks the theoretical foundation and applications to them, which covers mass scaling, hourglass deformation mode and dimensional compatibility

    本文還對彈性動力學有限元數值計算過程中遇到的若干技術細節進行了深入分析與探討。這包括質量縮放技術對時間步長的影響、單位制對計算速度的影響以及單元剛度單點數值積分的沙漏模態控制技術等。
  11. The assemblage angle and maximum step are studied, the method to calculate the maximum step of random structure paramers and random walking orientations is proposed and some formulations are deduced. the singularity and singularity workspace are analysed. based in zmp theory, the track programming is finished depending on leg position workspace

    根據zmp理論，在腿位置運動空間內作了軌跡規劃，劃分了步行周期，求出了腳圓心的軌跡，對速度和加速度作了規劃，應用離線軌跡規劃方法，給出了離線求取桿長伸長值及速度值的演算法框圖。
  12. A new numerical algorithm integrating a quasi - analytic numerical algorithm with the gear numerical algorithm is used to solve the ordinary differential equations with stiff problem. to accelerate the solving of ode, the optimum step method is introduced into the composite numerical algorithm

    針對重整反應模型方程的特殊結構和剛性問題，提出了一種形式更簡單方便的近似解析數值演算法和吉爾法相結合的混合數值演算法，並引入了最優步長方法。
  13. Optimal periodic control with the lowest operational cost by limiting total substrate discharge mass was studied. through adding new state variable and using supplement functions, the problem with restriction conditions was converted into nonrestriction problem. in addition, the dynamic searching method of optimal step coefficient was developed to modify the conventional gradient method, consequently the calculation problem of the multivariable optimal periodic control was able to be resolved better. it was found that the operational costs of optimal control under various initial states are distinctly different. a new concept of optimal control under optimal initial state was presented. it is pointed out emphatically that to the treatment system without optimal control condition, the suboptimal control with extensive practical value can be realized according to the results of optima control

    著重研究了在限制有機物排放總量時，使其運行費用最低的最優周期控制問題.通過增加新的狀態變量和用補償函數法，將本課題的有約束條件問題化為無約束條件問題，並提出了最優步長參數的動態搜索法來修改傳統的梯度法，從而較完善地解決了多變量最優周期控制的計算問題.研究中還發現了不同初始條件下最優控制所需要的運行費用也大不相同，進而提出了最優初始狀態下最優周期控制的新概念，這對保證出水質量的同時進一步降低污水處理成本來說具有更重要的意義.本文還強調指出：對于尚不具備實現最優控制條件的處理系統，可根據最優控制的研究結果實現具有廣泛實用價值的準最優控制
  14. The step value can also be negative, for example 5, and the minimum value is 15

    步長值還可以是負數（例如5 ） ，其最小值為15 。
  15. Incrementing identity columns are reset so that the next value allocated will be one step value more than the highest value in the remaining records

    增量標識列被重置，以使分配的下一個值比所保留記錄中的最高值大一個步長值。
  16. If the highest remaining identity value in the database is 50 and the step value is 5, compacting the database sets the value of the next record to 55

    如果數據庫中保留的最高標識值為50 ，步長值為5 ，對數據庫進行壓縮會將下一條記錄的值設為55 。
  17. Architectural support for programming languages and operating systems, cambridge, massachusetts, oct. 1996, pp. 138 - 147. 8 wang k, franklin m. highly accurate data value prediction using hybrid predictors. in proc

    混合值預測器預測時首先訪問二級值預測器，當二級值預測器不能預測時，則利用步長值預測器的預測結果。
  18. To accept the current signal from high negative voltage circuit, the analog ground is raised to a certain positive voltage, which makes it possible for the signal amplitude to be compressed at the same time of its polarity reversion. a pi control program special for laser gyro current control is brought forward according to the conventional pid control method, in which the control signal is figured out corresponding to the difference between the sample and the reference value by turn of proportion - short step integral - long step integral. and at the end of this paper, a comparison of system performance on different conditions is made and the key elements influencing system performance are educed

    利用集成a / d 、 d / a轉換器的新型晶元aduc824 ，實現了電流（電壓）采樣?數據處理?電流控制的閉環控制結構；地電位的抬升解決了a / d轉換器對負高壓迴路電流采樣時的輸入范圍匹配問題；控制信號反相的同時進行幅度壓縮，使得輸出調整電壓的解析度提高；根據常規的比例?積分?微分（ pid ）調節模型，針對陀螺系統的特性，給出了一種可以滿足系統要求、據采樣值偏差大小進行的比例?大步長積分?小步長積分、分層次比例?積分演算法；不同條件下系統穩流性能的對比、分析在論文最後給出，並據此找出了決定該系統穩流精度的關鍵因素，提出了系統的改進意見。
  19. Based upon the forward simulation principle of ground penetrating radar, this article analyzes the realization method of the half grid spacing and the half time increment in difference format, at the same time analyzed the produce of the numerical frequency dispersion, then deduced the ideal frequency dispersion relationship and the super absorbing boundary condition

    摘要本文從地質雷達正演原理著手，分析了差分格式中半空間步長與半時間步長的實現方法，同時通過分析數值頻散的產生，進而推導出了理想頻散關系和超吸收邊界條件。
  20. A variable is sampled in a certain increment, and introduced into the equations. there are two sets of any two equations to be solved. the real solutions of the two sets are protracted in spatial coordinate system to obtain two curves, so that the intersection points of the two curves can be found as the solution of the original equations

    針對所得三元高次多項式方程組，採用數學分析軟體mathematica編製程序，以一定的步長增量，在一定范圍內取一個變量的值，並將其代入方程組中，求解其中一個方程分別與另外兩個方程聯立的方程組的解，將得到的實數解繪製成兩條空間曲線，其交點即為原三元方程組的解。
分享友人
分享到 Line

分享到臉書