每小時輸出率 的英文怎麼說

中文拼音 [měixiǎoshíshūchūlǜ]
每小時輸出率 英文
output rate per hour
  • 每 : Ⅰ代詞（指全體中的任何一個或一組） every; each; per Ⅱ副詞（表示反復的動作中的任何一次或一組） often; every Ⅲ名詞（姓氏） a surname
  • 小 : Ⅰ形容詞1 （體積、面積、數量、強度等不大） small; little; petty; minor 2 （年紀小的; 年幼的） youn...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行特性進行詳細分析，變頻器輸出的電壓波形諧波大，沖擊大，電壓上升率高達6600v / s ，是普通正弦交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低，額定頻率在8 - 20hz ;調速范圍寬，最低運行頻率低到0 . 5hz ，起動次數相當頻繁，每小時高達600 - 800次，沖擊負荷大，過載能力要求較高。
  2. From the perspective of minimum transmission losses, an instantaneous reactive power theory for systems with any number of phases and with or without neutral line is developed. under the new definition, each quantity has its own physical meaning, and the zero sequence current can be decomposed into active and reactive components. furthermore, a generalized compensation method for zero sequence current is developed

    從輸電損耗最小的角度出發，提出了任意相無中性線或有中性線系統的瞬時無功功率理論，在新的理論下，每個量都有清晰的物理意義，且能分解出零序電流的有功分量和無功分量，並給出了通用的零序電流補償方法，揭示了瞬時無功功率理論與傳統平均意義下的無功功率理論的聯系及本質區別，從而為研究hvdc - vsc及各種facts裝置的無功功率控制奠定了理論基礎。
分享友人
分享到 Line

分享到臉書