比較測試法 的英文怎麼說

中文拼音 [bǐjiàocèshìfǎ]
比較測試法 英文
comparision testing
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 較 : Ⅰ動詞1 （比較） compare 2 [書面語] （計較） dispute Ⅱ副詞（比較） comparatively; relatively; fair...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 比較 : 1 （對比） compare; compare with; contrast; parallel （with）; comparison; by comparison; in comp...
  • 測試 : test; testing; checkout; measurement
  1. On the demand of application and according to the soluhons menhoned above, a method of displacement waiting auto - sy ' nchronizing is put forward, which is based on match filters. at the end a complete and speeflc set of hardware circuits and software programs which haplements the scheme, is also presented in the ancle. the synchronization system was tested in the pool and in the shallow wate near m port, the result of the test shows that its performance is satisfactory

    論文著重介紹實現了跳頻通信系統同步的一般方法，並詳細分析和對比跳頻同步系統的捕獲方案，在此基礎上，提出了一個基於匹配濾波器的位移等待式自同步方案，設計、完成並給出了詳細硬體連線電路圖、軟體程序流程圖和部分程序清單，該自同步方法在實驗室水池實驗取得良好的效果，並在廈門港海域進行了現場實驗測試，具有較低的誤碼率和一定的檢測概率，結果令人滿意。
  2. Compared with traditional contact flow measurement methods, presents the non - contact flow measurement methods, and emphases the application of laser doppler anemometry ( lda ) and particle image velocimetry ( piv ) to flow field measurement

    摘要與傳統接觸式流量測試方法相比較，介紹了非接觸式流量測試方法，重點介紹了激光多普勒技術（ lda ）和粒子圖像測試技術（ piv ）在流場測試中運用的原理。
  3. The advantage and disadvantage of measurement of propeller - induced pressure by using different equipment is discussed. the method to obtain self - propulsion point for full scale in depressurized towing tank is studied. the measurements of pressure of two propeller models are carried out, the results of the measurement agree with those obtained by cavitation tunnel very well, which proves this measurement is successful, and the theoretical prediction is verified too

    比較了不同測試設備用於螺旋槳脈動壓力測試的優缺點，探討了在減壓拖曳水池中實現實船自航點的方法，並進行了兩只螺旋槳模型的脈動壓力測試，經與空泡水洞中脈動壓力的測試結果進行比較，說明該項測試是成功的，同時也對脈動壓力的理論預報結果做了驗證。
  4. Test method for ca ion chelating power and comparison thereof

    鈣離子螯合力測試方法及比較
  5. By means of bending tests of three - point and four - point, complex fracture experiments were made for cast iron material with crack. the stress intensity factor and breaking direction angle of cast iron material were measured and compared with theoretical values. based on the research some useful conclusions are given for engineering design and application

    通過3點彎曲和4點彎曲實驗方法，對含有裂紋的鑄鐵材料進行復合型斷裂實驗研究，測試鑄鐵材料的應力強度因子、斷裂方向角，將實驗結果與理論值進行分析、比較，找出兩者之間的異同點，得到一些對工程設計及應用具有實際意義的結論。
  6. The structures and characteristics of several graphite samples are measured by means of powder x - ray diffraction ( xrd ), brunauer - emmer - teller ( bet ) surface area measurement, inductively coupled plasma ( icp ) spectroscopy, particle size analysis and electrochemical measurements. the effects of origin, structure, impurity, particle size, specific surface area of carbon materials on the electrochemical characteristics are studied. a synthetic graphite with abundant resources, low cost and favorable performance is determined as the raw material for modification of graphite

    採用xrd 、 bet 、 icp 、激光粒徑分析及電化學性能測試等方法，對國內外多種典型石墨樣品的結構與性能進行比較，研究石墨材料的來源、晶體結構、雜質含量、顆粒大小、比表面積等因素對其充放電性能的影響，確定一種性能較好、價格低廉、來源廣泛的普通人造石墨粉作為熱處理與摻雜改性、以及復合結構炭材料研究的原材料。
  7. 4. we probed into some methods to measure ga - hardness. first of all, we compared three approaches : fdc, correlation length, and epistasis measures

    4 .對常見的幾種遺傳演算法困難度測試方法（ fdc測試、相關長度測試與基因關聯測試法）進行了分析比較。
  8. This paper discusses the characteristic of inductivity coupled plasm atomic excite spectroscope and applies the analysis method to measure the atmosphere corrosion rusty layer samples from qingdao and chengdu. we get the relative content of each element of rusty layer and show the charitable situation that the relative content varied with the change of corroded environment and time

    概述了電感耦合等離子體光譜法的特點，並運用該光譜法對青島和成都兩地的大氣腐蝕銹層樣品進行了比較測試，得出了銹層中各元素的相對含量及其隨腐蝕環境和時間的變化情況
  9. Acoustics - determination of sound power levels of noise sources - engineering methods for small, movable sources in reverberant fields - comparison for hard - walled test rooms

    聲學.噪聲源聲功率級的測定.在混響聲場中小聲源和移動聲源的工程測量方法.第1部分:硬墻試驗室的比較分析法
  10. Acoustics. determination of sound power levels of noise sources. engineering methods for small, movable sources in reverberant fields. part 1 : comparison method for hard - walled test rooms

    聲學.噪聲源聲強級的測定.混響聲場中小聲源和移動聲源的工程測量方法.第1部分:硬墻試驗室的比較分析法
  11. Standard test method for thermal emf test of single thermoelement materials by comparison with a reference thermoelement of similar emf - temperature properties

    與有相同電動勢溫度性能的標準熱電偶相比較測定單個熱電偶材料的熱電動勢的標準試驗方法
  12. Not only the scan route solution, the built - in self - test solution and the boundary scan solution of design for testability are summarized, but also the applications and countermeasures of these 3 solutions are analysed and compared in details

    摘要綜述了超大規模集成電路的幾種主要的可測試性設計技術，如掃描路徑法、內建自測試法和邊界掃描法等，並分析比較了這幾種設計技術各自的特點及其應用方法和策略。
  13. This paper applies the method of infrared spectrum analysis to measure the atmosphere corrosion rusty layer samples from qingdao and chengdu. then, it gets the main component rust phase of rusty layer and shows the changeable situation that the relative content of each rust phase varies with the change of corroded environment and time

    運用紅外光譜分析方法，對青島、成都兩地的大氣腐蝕銹層樣品進行了比較測試，得出了銹層的主要組成物相及各物相的相對含量隨腐蝕環境、時間的變化情況
  14. Methods for calibration of vibration and shock pick - ups. testing of temperature response by comparison

    振動與沖擊傳感器的校準方法溫度響應比較測試法
  15. Main outcome measures the use of 21 classes of prescription medication was compared in the hormone therapy arms and placebo or nontreatment trial arms

    主要結果測量方法：比較該試驗激素替代治療組（ 2個亞組） 、安慰劑組和非治療組21類處方藥的使用情況。
  16. So it is available to reconstruct moderate and large image by using either parallel or divergent projection data, as well as the data collected at series arbitrary sampled angles and sampled radii. and it does not require the storage of projection matrix, compared with the conventional art. the numerical results show that mart reconstructs image with fast speed, high resolution and sligh artifacts

    利用分塊迭代的快速art方法，對x射線工業ct實采投影數據進行圖像重建，並與fbp方法、經典art方法重建的圖像進行了比較，測試結果表明：該方法重建圖像精度高，偽影輕，並有較高的密度解析度和空間解析度，較經典art方法重建速度快。
  17. Thus the intersection test between two bounding volumes need only at most k comparisons, ( k is the size of fixed direction set. )

    通過這種簡單的區間測試法，兩個包圍盒間的相交測試最多只需要k次比較運算（ k為固定方向集合的大小） 。
  18. The mect coordinate measuring machine " s measuring software packet is the object of the study. through comparing dmis with mect software packet, the same and the difference in the coordinate measuring technology are analyzed. understanding of dimensional measurement and the structure of mect software packet are strengthened in the research and development of auto - measuring system for structure characteristic parameter of shell and measuring workpecies

    本文以dmis標準的研究作為切入點，以mect三坐標測量機測量軟體包為研究對象，採用相互比較的方法，來分析dmis標準和mect測量軟體在坐標測量技術上的異同；並通過參與工程項目炮彈結構特徵量自動測量系統研發、調試、工件實測，增強了對幾何量測量技術和mect軟體包內部結構的理解。
  19. The progress of the building energy conservation of our country is rapid now, but it started late in hot summer and warm winter zone. taking the thermal performance and energy consumption as the targets, with the methods such as calculation, analysis, data comparison in the simulation software, the dissertation incarnates that the design can be totally controled. some better thermal design methods are mentioned to decrease the loads of the air - condition, which lend themselves to achieving the local residential building energy conservation standard

    當前我國建築節能工作正在迅速發展，本文以夏熱冬暖地區居住建築熱工性能及其能耗為研究對象，通過模擬軟體進行計算、分析、數據比較等方法，充分體現建築設計過程中的可控性，並對減少空調設計負荷提出一定的熱工設計方法，以有助於達到的該地區居住建築節能指標；為夏熱冬暖地區建築節能工作的開展做部分研究準備工作，同時總結dest - h軟體在測試研究應用方面的一些經驗。
  20. On the basis of comparing present detection techniques, we propose a new optical beam deflection technique with a single fiber. the correspond fiber sensor has been completed

    在比較了已有的各種測試聲表面波手段的基礎上，提出了基於光偏轉技術的單光纖測試法，並設計完成了一套光纖光聲傳感器。
分享友人
分享到 Line

分享到臉書