氣壓法 的英文怎麼說

中文拼音 [qìyāfǎ]
氣壓法 英文
pneumatic injection
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 壓 : 壓構詞成分。
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 氣壓 : [氣象學] pressure; atmospheric pressure; barometric pressure; gas pressure; air pressure
  1. In the high-pressure system both oxygen and acetylene are used from high-pressure cylinders.

    在高壓法中，氧氣和乙炔都取用於高壓瓶。
  2. Method for pneumatic test of dissolved acetylene cylinders

    溶解乙炔氣瓶氣壓試驗方法
  3. The best optimum mathematical model is constituted. scalar factor of structural parameter on loop rectangular negative pressure and adsorption slide is calculated. structural parameter, air gas source pressure carrying capacity and thickness of air cell are made sure by hydrodynamics and the theory of gas lubrication

    詳細論述了導軌副的設計過程，運用數學上的拉格朗日條件極值求解法，建立最優化數學模型，求出環矩形負壓吸附導軌的結構參數的比例情況，並運用流體力學和氣體潤滑理論確定了環矩形負壓吸附導軌的結構參數、氣源氣壓、承載能力和氣膜厚度的確定性結論。
  4. Methods of test for petroleum and its products - general introduction - barometric pressure corrections

    石油及其產品的試驗方法.一般說明.氣壓校正值
  5. Besides acting as agent of huzhou zhanwang pharmaceutical co., ltd. for a variety of adjuvant, we are also the agent for many imported adjuvant, such as new zealand wyndales lactose ; germany basfs vitamins and direct compression excipients ; france roquettes polyatomic alcohol ; germany sasols polyglycol ; switzerland givandans powdery flavoring essence ; usa cabots gas silica ; italy randi groups tartaric products ; uk crodas tween and span ; japan asahikaseis microcrystalline cellulose ; usa noveons carbopol resin, etc

    我公司除代理湖州展望化學藥業有限公司各種輔料，同時代理多家進口輔料，諸如：紐西蘭乳糖系列產品、德國巴斯夫公司維生素系列產品及直接壓片輔料；法國羅蓋特多元醇系列產品；德國沙索公司聚乙二醇系列產品；瑞士奇華頓粉末系列香精；美國卡博特公司氣相法二氧化硅；義大利拉第集團天然酒石酸系列產品；英國禾大公司吐溫，司盤系列；日本旭化成公司微晶纖維素系列產品；美國諾譽公司卡伯波樹脂系列等。
  6. He added that the use of pneumatic compression pumps as a potential treatment has fallen into disfavor because of old, poorly substantiated claims that the use of pumps can actually create more problems than they solve

    他補充說，間歇性充氣加壓法作為一個很有潛力的治療方法卻正在逐漸失寵，因為方法古老，又很少有人出來證明使用這個方法確實有效。
  7. In chapter 2, the meteorological knowledge, data and the methods of the data processing, related to the study on the atmospheric loads, are simply presented. the model for the perfect gas constant, describes by the relative moisture, is developed. the influences of the variation in the vapor component in the atmosphere on the perfect gas constant are evaluated by using the changing characteristics of the temperature on the surface, its spatial gradient and the barometric pressure

    第二章：簡要介紹大氣負荷研究所需的氣象科學知識、資料及其數據處理方法；建立相對濕度表示的大氣比氣體常數模型，利用地面溫度和空間垂直溫度梯度、壓力變化的規律估算大氣水汽組分變化對比氣體常數的影響；對中國及鄰區的地面氣壓記錄進行了預處理和網格化
  8. 3 ) aerial compressor reconstruction with inflator labyrinth seal : the aerial compressor formerly adopted simple inflator labyrinth seal and it did n ' t work well due to the vast leakage and frequently abrasion of the labyrinth seal, so the machine could n ' t operate in long term

    3 ）富氣壓縮機充氣式迷宮密封的技術改造，焦化裝置富氣壓縮機原來採用簡單的充氣式迷宮密封，密封效果不好、泄漏大，迷宮密封頻繁損壞，機組無法實現長周期運行。
  9. Using jgp560c magnetron sputtering equipment, cu / ag film are deposited on cd1 - xznxte substrate by dc magnetron sputtering in order to get the influences of the main experiments parameters such as sputtering power, gas flow, vacuum air pressure, magnetoelectricity power and substrate temperature on deposition rate of film, discovered that dc sputtering power is the most key factor influencing the deposition rate

    在jgp560c型超高真空多功能磁控濺射鍍膜機上，採用直流磁控濺射法在cdznte晶體上制備出cu ag合金薄膜，揭示了氣體流量、直流濺射功率、勵磁電源功率、工作氣壓和襯底溫度等工藝參數對沉積速率的影響規律。結果表明濺射功率對沉積速率的影響最大，隨濺射功率的增大沉積速率快速增大。
  10. Plastics - determination of the gas transmission rate of films and thin sheets under atmospheric pressure - manometric method

    塑料.在大氣壓力下薄膜和薄板的氣體透過率的測定.測壓法
  11. Plastics - determination of the gas transmission rate of films and thin sheets under atmospheric pressure - manometric method iso 2556 : 1974 ; german version en iso 2556 : 2000

    塑料.大氣壓力下薄膜和薄板的透氣率的測定.測壓法
  12. Methods of testing plastics. other properties. determination of the gas transmission rate of films and thin sheets under atmospheric pressure manometric method

    塑料的試驗方法.第8部分:其他性能.試驗方法821a :在大氣壓力條件下薄片和薄膜透氣率的測定
  13. Liquified petroleum gases - calculation of vapour pressure and relative density and octane number

    液化石油氣蒸氣壓和相對密度及辛烷值計演算法
  14. Standard test method for vapor pressure of gasoline and gasoline - oxygenate blends dry method

    汽油和汽油元氧混合物蒸氣壓力的標準試驗方法
  15. The paper described the building process of model that can identify the shock - absorber parameter of landing gear and at the same times optimize performance of system. in this paper, there are also some debate, it include identifying parameter which can not be measured, such as the air polytropic exponent and the orifice discharge coefficient of shock - absorber

    本文利用復合形優化演算法建立了起落架緩沖系統參數識別與系統優化模型，對緩沖器空氣壓縮多變指數和油孔流量系數等不可測參數的識別和著陸、滑跑載荷多目標優化問題進行了討論。
  16. On the other hand, through inhibted performances of concrete and mortar, the permeability refutations with different w / c, ages, admixture, and physics chemistry absorb regulation of different viscosity permeable liquid, the liquid - gas method is proved science and accuracy. because adopting with liquid - gas method it case clearer concrete permeability regulation. different concretes relativity is more exact and more efficiency and fixed quantity

    另一方面，我們利用混凝土所固有的性質：不同水灰比混凝土、砂漿、抗滲性能規律；不同齡期混凝土的抗滲規律；不同外加劑、摻合料抗滲性能之間相互對比規律；不同黏度滲透液物理化學吸附對測試結果影響的規律；用規律來映證溶液氣壓法的科學性，準確性。
  17. It is shown that the results of single - calibration - ratio iteration calculating method is better than the single - calibration ratio method and are comparable with kf method and gas - pressure method

    實驗結果表明，經過改進的氣相色譜單點校正因子迭代法明顯優于單點校正因子法，與卡爾費休滴定法、氣壓法測定結果有可比性。
  18. The analysis results of single - calibration - ratio method, single - calibration - ratio iteration calculating method, karl fisher ( kf ) method and gas - pressure method were compared based on a series of waterborne samples

    用改進后的氣相色譜法測定了16個水性塗料樣品的水含量，對單點校正因子法、單點校正因子迭代法、卡爾費休滴定法、氣壓法測定結果進行了比較。
  19. The main technique route of this study is that by the methods of liquid - gas method, gbj82 - 85 and astmc1202, concrete and mortar permeability are tested at one time. the method correlates with gbj82 - 85 very well, and the relative coefficient is 0. 9728 - 0. 9913

    本課題的主要技術路線是：採取溶液法、 gbj82 - 85 、 astmc1202 ，三種方法同時對比混凝土、砂漿的滲透性能實驗，探明了溶液氣壓法與國標的相關性，其相關系數在0 . 9728 - 0 . 9913之間。
  20. The liquid - gas method is improved based on the above methods, overcoming the defects of gbj82 - 85. using the liquid - gas method, permeability condition of concrete can be tested and indicated quickly, efficiently, and the influences on concrete of alkali - aggregate reaction, sulfate attack, carbonization, steel rust, freeze and thaw can be inflected indirectly. it is significant on the research and monitor on the durability of concrete

    溶液氣壓法是在上述方法之上進行改進提高的，克服了國標gbj82 - 85方法中的許多不足之處，能夠多角度、快速、高效、真實、準確地再現現場混凝土的滲透情況，並且能間接反映堿-骨料反應、鋼筋銹蝕、碳化、硫酸鹽侵蝕及凍融破壞的影響，對混凝土耐久性的監測與研究具有重要意義。
分享友人
分享到 Line

分享到臉書