氣壓測定法 的英文怎麼說
中文拼音 [qìyācèdìngfǎ]
氣壓測定法
英文
barometry- 氣 : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
- 壓 : 壓構詞成分。
- 測 : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
- 定 : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
- 法 : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
- 氣壓 : [氣象學] pressure; atmospheric pressure; barometric pressure; gas pressure; air pressure
- 測定 : determine; determination; setting-out; admeasurement; assignment; assay; finding
-
The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological
分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象,依據astm標準及國際通用文物保護研究方法與評估準則相結合,通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定,及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響,對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。Hand - held pressurized aerosol dispensers against houseflies - method for determination of insecticidal performance
消滅室內飛蟲用手持式壓力氣溶噴灑器.殺蟲性能的測定方法Plastics - determination of the gas transmission rate of films and thin sheets under atmospheric pressure - manometric method
塑料.在大氣壓力下薄膜和薄板的氣體透過率的測定.測壓法Plastics - determination of the gas transmission rate of films and thin sheets under atmospheric pressure - manometric method iso 2556 : 1974 ; german version en iso 2556 : 2000
塑料.大氣壓力下薄膜和薄板的透氣率的測定.測壓法Methods of testing plastics. other properties. determination of the gas transmission rate of films and thin sheets under atmospheric pressure manometric method
塑料的試驗方法.第8部分:其他性能.試驗方法821a :在大氣壓力條件下薄片和薄膜透氣率的測定Hydraulic fluid power. test code for determination of airborne noise levels. part 3 : pumps. method using a parallelepiped microphone array
液壓.氣載噪聲級測定試驗規程.第3部分:泵.平行六面傳聲器陣列方法Hydraulic fluid power - test code for determination of airborne noise levels - part 3 : pumps - method using a parallelepiped microphone array
液壓流體動力.氣載噪聲級測定的試驗規程.第3部分:泵.採用平行六面體麥克風排列法Standard test method for determining air leakage rate by fan pressurization
用風扇增壓法測定空氣泄漏率的標準試驗方法Petroleum products - determination of vapour pressure - reid method
石油產品蒸氣壓測定法Determination of saturated vapor pressure of engine fuels reid method
發動機燃料飽和蒸氣壓測定法The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper
本文研究了用igc (惰性氣體蒸發凝聚原位溫壓法)制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅(冷軋紫銅、電解銅)在酸性硫酸銅溶液和中性含氯溶液中,在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動電勢極化、電位測定、循環伏安法( cv )和電化學阻抗譜( eis )等方法。 x -射線衍射( xrd )的方法用來估算納米晶銅晶粒尺寸。Methods of test for petroleum and its products - petroleum products - determination of distillation characteristics at atmospheric pressure
石油及其製品的試驗方法.石油產品.大氣壓力下蒸餾特性的測定Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively
本文對大圓環直線感應電機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面電流作用於有限長鐵芯上的模型,引用了氣隙磁場一維解,研究了單層繞組磁場,奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較,簡單介紹了二維解; ( 2 )用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析,並分析了結果; ( 3 )用軟體進行了額定電壓下的瞬態分析,得到了轉矩,位移,轉速隨時間變化曲線圖,利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較,採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證,由實驗測得了三相電流波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。Standard test method for vapor pressure of liquids by ebulliometry
用沸點測定法測定液體蒸氣壓力的標準試驗方法In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data
為探討軸流壓氣機在工作流量、工作轉速及動?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律,並耦合進氣畸變的影響,同時與壓氣機氣動性能和氣動穩定性相關聯,作者利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機( lsc )試驗器,採取在靜子葉片表面埋入動態壓力傳感器的實驗方法,對葉尖、葉中和葉根三個截面的動態壓力進行了測量,獲得了大量的可靠的實驗數據。Standard test method for structural performance of sheet metal roof and siding systems by uniform static air pressure difference
用均勻靜態空氣壓差法測定薄金屬板屋頂和板壁系統結構性能的標準試驗方法Methods for thd measurement of volume flow of gas of water - ring vacuum pump and compressor
水環真空泵和水環壓縮機氣量測定方法Methods for the measurement of volume flow of gas of water - ring vacuum pump and compressor
水環真空泵和水環壓縮機氣量測定方法Analysis of fuel gases - methods for non - manufactured gases - determination of water content at high pressure
燃氣分析.第11部分:天然氣.第6節:含水量高壓測定法Thermal performance of buildings - determination of air permeability of buildings - fan pressurization method
建築物的熱性能.透氣率測定.風扇增壓法分享友人