氣孔填充 的英文怎麼說

中文拼音 [qìkǒngtiánchōng]
氣孔填充 英文
vesicular filling
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 填 : 動詞1. （墊平或塞滿） fill; stuff 2. （補足; 充滿） replenish; supplement; complement 3. （填寫） fill in; write
  • 充 : Ⅰ形容詞（滿; 充足） sufficient; full; ample Ⅱ動詞1 （裝滿; 塞住） fill; charge; stuff 2 （擔任; ...
  • 氣孔 : [礦物學] blowhole; [植物學] stoma; [動物學] spiracle; pore; stigma; [冶金學] gas hole; gas pocket; [建築] air hole
  1. We find that the petrology characteristic of all the samples have no characteristic of meteoric water such as geopetal structure, infiltrative sand, ( uniform cement and gravitational cement on base of the research of the dolomite in the regions. on the dot diagram of combination of mgco3 ( mol % ) and sr, the dot are all close to the line of seawater whether they are microlite - crystalline penecontemporaneous dolostone or diagenetic dolostone of various crystals. the 87sr / 86sr value of dolostone or matrix is less than the one of sparry calcite in cave or vein, and close to the value of seawater

    通過本區白雲巖的研究發現：已有的白雲巖樣品的巖石學特徵沒有顯示出如示底構造、滲濾沙、新月型膠結物和重力膠結物等大氣淡水作用的特徵；在白雲石mgco _ 3mol百分數和白雲石sr含量的投點圖中，無論是準同生成因的泥?微晶白雲巖，還是粉?細晶（或中晶，或細晶以上的不等晶）的成巖白雲巖，均投在海水線的附近；白雲巖（或基質）的~ （ 87 ） sr / ~ （ 86 ） sr比值顯著低於與孔洞或脈中充填的亮晶方解石，且與海水值十分接近， ~ （ 13 ） c和~ （ 18 ） o值顯著高於孔洞或脈中充填的亮晶方解石，也偏向于海水值； mn含量則顯著低於孔洞或脈中充填的亮晶方解石。
  2. Through the research on the development character of overthrust fault, we analyzed its sealing mechanism. we also established evaluation standard and method of fault sealing ability through the following two simulation experiment : experiment on the quantitative relationship between property of fracture zone filler and fault sealing ability ; experiment on the deformation character of cream shale. based on these work, we evaluated sealing ability of overthrust faults on several typical structure in kuche depression

    本文通過逆掩斷層發育特徵研究，分析了逆掩斷層封閉機理，在斷裂帶填充物性質與斷層封閉性定量關系模擬實驗和膏泥巖變形特徵模擬實驗基礎上建立了斷層封閉性評價標準及評價方法，以此對庫車坳陷幾個典型構造上逆掩斷層垂向封閉性進行了評價，結果表明現今斷層多是封閉的，這是庫車塌陷天然氣和異常孔隙流體壓力得以保存的主要條件。
  3. A transition of microstrip to waveguide based on siw technique was processed with ltcc to validate the feasibility of siw. then, a siw resonator was analyzed. the equivalent electrical wall of metallized via arrays was obtained

    從對空氣填充siw諧振器的分析，得到在ferroa6m材料中構成諧振器的金屬排孔等效電壁的位置，得到簡化的計算siw諧振器的模型。
  4. Pore parameters ( porosity and distribution of pore diameter ) of porous glass prepared by filler principle were measured and analyzed. they were mainly determined by the volume ratio and the particle diameter of the pore former in the green body. preparation and sintering process of the samples resulted in the difference between the porosity and the volume ratio of the pore former. they were also responsible for the deviation between the distribution of poer diameter and the particle diameter of pore former

    研究表明，利用填充法制備的多孔玻璃的孔參數（氣孔率、孔徑分佈）可進行設計與控制，多孔玻璃的氣孔率和孔徑分佈主要取決于成孔劑的體積比及其顆粒分佈，前者與後者之間的偏差取決于生坯制備及燒結過程。
  5. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  6. Thaw settlement cause negative friction. this paper base on the thought of " initiative cooling ", aim at three problems existing in common concrete pile used in frozen soil, a new type of pile is proposed to overcome the disadvantages of the classical pile used in frozen soil. pile body within active layer is fluted and refilled with porous materials such as gravels and ballasts, convection will be occur and then thermal exchange inside porous material in winter while only heat conduction exists in summer, as a result the soil around flutings will be cooled, so the top line of permafrost will be drive up

    本文基於「主動冷卻」地基的思想，以及針對凍土地區普通混凝土樁存在的三大問題，提出了一種新型樁的設計思路，運用數值模擬試驗手段對其冷卻機理與加固機理進行了系統研究，即在凍融活動層的深度范圍內，在混凝土樁身的表面刻槽，修築完時槽內填充碎石、塊石等多孔介質，通過外界大氣溫度的自然波動下多孔介質在冬季時存在的對流換熱機制，而在夏季只存在熱傳導，來達到主動冷卻樁周凍土和抬升凍土上限的目的。
  7. Abstract : a new type of rotating packed bed （ rpb ） filled with holed disk packing, has high mass transference character by means of the centrifugal field it is used for simulating flue gas desulfurization and achieved of good effect the desulfurization efficiency of rpb by boot water is above 75 % accompanied with small gas resistance

    文摘:一種利用離心力場強化傳質的新型旋轉填充床反應器以孔型碟片為填料用清水吸收模擬煙氣中的二氧化硫時的脫硫率達75 %以上，用於模擬煙氣脫硫也取得了很好的效果，而且氣阻也很低
  8. Based on the requirement and target of the projects, firstly, pcf bragg grating are investigated theoretically and experimentally. moreover, the effects of filling high refractive index material ( nematic liquid crystal, nlc ) in pcfs on the transmission mechanism and propagation properties are studied by using plane - wave method and finite - element method ( fem ), farther, several novel pcfs are proposed and designed. lastly, we propose and demonstrate a clad - pumped er3 + / yb3 + - codoped fiber laser, which integrate all performances of broad - band tunable wavelength, uniform output power spectrum, high repeat frequency and high average power to together

    本論文選題于國家973 、 863以及國家自然科學基金等項目，結合課題的要求和主要目標，在對光子晶體光纖（ pcfs ）傳輸特性研究的基礎上，首先對光子晶體光纖光柵進行了理論和實驗研究;然後，採用平面波展開法和有限單元法分析了在光纖的空氣孔中填充高折射率液晶對光纖傳導機制和傳輸特性的影響，提出並設計了幾種新型光子晶體光纖;最後，提出並研製成功連續可調諧、輸出功率譜均衡的全光纖化、高功率包層泵浦鉺鐿共摻光纖激光器實驗樣機。
  9. Heat supply heating and hot water supply is provided with : hybrid solar system on the base of solar collectors water - air, area - 12 square meter in the southern wall of a greenhouse ; passive solar system combined with the northern wall made of hollow blocks 0, 2 m wide and filled in with hae of porous material

    該溫室通過以下方式提供熱水和供暖：南墻使用面積為12平方米的綜合太陽能系統，該系統使用太陽能收集器制給空氣和水體加熱北墻使用被動太陽能系統，即墻體由每塊0 . 2米寬的空心磚砌成，磚內填充多孔蓄熱材料。
分享友人
分享到 Line

分享到臉書