氣流分佈 的英文怎麼說

中文拼音 [qìliúfēnbù]
氣流分佈 英文
air flow distrbution
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 氣流 : 1 [氣象學] air current; airflow; wind current; airstream2 [語言學] breath氣流紡紗 open end spinni...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Abstract : the distribution of cooling air which is in the grille - brick of the inner combustion hot air stove has been simulated with three dimension turbulent mathematical model so as to find a method which is used to improve the distribution of cooling air in hot air stove. the influence of differential horizontal plates on the distribution of cooling air is discussed. the results show that original big circle round field of flow in the pillar - cavity is changed into full one - way field of flow and edges gas flow, at the same time, is increased by horizontal plates. there is a different function with horizontal plates and vertical plates. to make the uniform distribution of cooling air in the hot air stove, it is necessary that horizontal plates and vertical plates are used in a combined way

    文摘:應用紊流三維數學模型模擬內燃式熱風爐內冷風在格子磚柱中的分佈，尋求改善其分佈的途徑.討論了加設不同布置的水平導流板對氣流分佈的影響.模擬結果表明，在支柱空腔內加設水平導流板改變了原有大迴旋流場，使迴旋流變成大面積的單向流.通過在支柱空腔內加設水平導流板可以發展邊緣氣流，這恰好與加設豎直導流板的作用相反，水平導流板和豎直導流板的結合使用有望實現冷風在格子磚柱中的均勻分佈
  3. It was well known that the main process of precipitation formation was collecting cloud water in the warm area and ice phase particles melting in the cold area. positive vertical velocity existed between 700hpa and 500hpa in the warm area and near surface in the cold area. wind convergence existed at the height of 700hpa, and divergence existed above and below the height of 700hpa

    通過對降水雲系的綜合研究，建立了河南省春季層狀雲降水概念模型：暖區降水主要通過雲水碰並形成，冷區降水機制以冰粒子融化等冷雲過程為主;暖區700一50ohpa通常有上升氣流，冷區上升氣流分佈在近地面附近: 700沖a存在風場的輻合，其上下則主要是輻散區;水汽主要集中在7o0hpa高度上，暖區水汽來自南、東南方向，冷區水汽以西南輸送為主;暖區位勢不穩定分佈在o 。
  4. Numerical simulation to air distribution in air - conditioned hard sleeper compartment

    鐵路空調硬臥車內氣流分佈的數值模擬
  5. Control system design of punching system with x - type airflow - distribution board

    型氣流分佈板沖孔設備控制系統設計
  6. Numerical simulation of air distribution in air - conditioned train passenger compartment

    空調列車室內氣流分佈的數值模擬
  7. A study on gas distribution pattern in a ring - type horizontal baking furnace s flue

    水平環式焙燒爐火道內氣流分佈規律的研究
  8. Thermal comfort study based on air distribution in air - conditioned train passenger compartment

    基於空調車廂內氣流分佈的人體熱舒適研究
  9. Simulating calculation for electric field strength distributions of electrostatic precipitators

    屋頂電除塵器入口氣流分佈的數值模擬試驗研究
  10. Experimental study on gas flow distribution affected by constructional parameters of pelletizing shaft furnaces

    球團豎爐結構影響爐內氣流分佈的實驗研究
  11. Study and application of numerical calculation method for gas flow distribution of electrostatic precipitation

    大型電除塵器氣流分佈數值計算的研究和應用
  12. Experimental research on the airflow distribution uniformity in material layers of crossflow recirculating drier

    橫流循環式烘乾機氣流分佈均勻性的試驗研究
  13. Fuzzy comprehensive evaluation on thermal comfort based on air flow in the air - conditioning compartment of vehicles

    基於裝甲車空調艙內氣流分佈的熱舒適模糊綜合評判
  14. To control the respiratory infection, some measures are taken such as ward negative pressure control, reasonable air distribution and high efficiency exhaust air filtration, obtaining better effects

    針對控制呼吸道傳染病的要求，採用了房間負壓控制、合理的氣流分佈、高效過濾排風等技術，取得了較好的效果。
  15. Through thorough analysis, we finally drew that on condition of experiment, square diffuser could ensure good air distribution when air supply volumes ranged from 40 to 50 percent or 80 to 100 percent of the maximum air supply volumes. when air supply volumes ranged from 50 to 80 percent of the maximum air supply volumes, square diffuser could not be very ideal with a variable air volume in a cooling mode

    經過全面分析，最後得出主要結論：在實驗條件下，當送風量處于最大送風量的40 50或80 100范圍內時，方形散流器可滿足室內氣流分佈的要求；當送風量處于最大送風量的50 80范圍內時，方形散流器用於變風量系統供冷工況不理想。
  16. A straight inlet baghouse which can effectively reduce energy consumption of equipment in operation and lengthen the service life of fabric bags, as well as gas flow structure in the tank body have been presented, and numerically simulating the gas flow distribution in the tank body being carried out by using calculated flow dynamics ( cfd ) method, providing a method and parameters for adjusting the gas distributing plates structure to realize reasonable flow rate distribution in the tank body

    摘要介紹了能有效降低設備運行能耗、提高濾袋壽命的直通式袋式除塵器及其箱體氣體流通結構，並利用cfd方法對箱體流量分配和氣流分佈進行數值模擬，給出了實現箱體流量合理分配的氣流分佈板結構調整方法和參數。
  17. There is no thoroughly rounded theory about displacement ventilation system in our country at present and our research begins recently. the study work of this paper will be useful for further optimization design of displacement ventilation system. this dissertation includes five parts. the first part introduces the development of the displacement ventilation and the background of research in domestic and oversea. in the second part, it gives working principle of displacement ventilation system and it ’ s advantages to the mixture ventilation. the study also gives a series of indexes to evaluate displacement ventilation system and specifies air supply terminal device and so on. it is needed to simulate and analyse the velocity field, temperature field and distribution of flow field. this is the third part. the forth part specifies the simulative method for thermal stratification of displacement ventilation system. it gives some factors affecting thermal stratification height such as inlet temperature, inlet velocity, heat transfer of wall body, distance of heat source and so on

    本文的研究工作主要包括以下幾個方面的內容: （ 1 ）綜述了國內外相關的研究現狀和研究背景; （ 2 ）簡介了置換通風的工作原理，並分析了它相對于混合通風的優良特性及評價指標、末端裝置等; （ 3 ）對採用置換通風方式房間的溫度場、速度場和氣流分佈進行了模擬計算與分析; （ 4 ）對採用置換通風方式房間的熱力分層高度進行了模擬計算，並分析其影響因素，如:送風溫度、送風速度、圍護結構傳熱和熱源分佈等; （ 5 ）擬合了無量綱熱力分層高度相應于送風溫度t 、送風速度v 、熱源間距離l和圍護結構傳熱q的經驗公式。
  18. Meanwhile, we adopted air distribution performance index, temperature gradients and average velocity to evaluate and compare room air distribution under various air volumes

    同時，用空氣分佈性能指標、溫度梯度以及室內平均速度對不同送風量下的室內氣流分佈進行了評價和比較。
  19. Based on the cfd simulation, analyses and compares four air distribution modes using relevant evaluating indexes, and concludes that the top - supplying and opposite down - exhausting air distribution is an optimal mode for isolation wards

    摘要採用cfd數值模擬的方法，利用相關評價指標對四種不同氣流分佈方式進行了比較分析，認為天花板頂送異側下排是較為理想的氣流分佈方式。
  20. Because the basic principle of variable air volume system is to meet the comfort conditions indoor by varying air flow rates, air distribution is rather important

    由於變風量系統是通過改變送風量來滿足室內舒適要求的系統，所以氣流分佈對于變風量系統是相當重要的。
分享友人
分享到 Line

分享到臉書