氣輪機 的英文怎麼說
中文拼音 [qìlúnjī]
氣輪機
英文
gas turbine-
Lightweight gas turbine acceptance test specification
輕型燃氣輪機驗收試驗規范Review on inlet air cooling technology for gas - turbine
燃氣輪機進氣冷卻技術淺析Selection of inlet air cooling technology for gas - turbine
燃氣輪機進氣冷卻工藝的選擇Brief introduction for gas turbine inlet air cooling system
淺述燃氣輪機的進氣冷卻技術Advanced laser cladding and welding process for gt
先進的燃氣輪機葉片激光修復技術Repairing of single - cylinder combustor of low calorie value gas turbine
低熱值燃氣輪機單筒燃燒室修復Dynamic behavior of marine intercooled regenerated gas turbine engines
艦用中冷回熱燃氣輪機裝置動態性能分析Research on simulating method for the dynamic behaviors of shaft - bearing system
的三軸燃氣輪機動態模擬模型研究Mechanism of gas turbine surge and countermeasures
燃氣輪機喘振產生的機理和對策Coupled vibrations of gas turbine shrouded blades
燃氣輪機帶冠葉片耦合振動分析Gas emissions measurement of light weight gas turbines
輕型燃氣輪機氣態污染物測量The gas turbine feeds on the fuel it pumps
燃氣輪機以它所抽入的燃料為能源。Gas turbines - procurement - part 6 : combined cycles
燃氣輪機.采辦.第6部分:組合循環Kohonen neural network - based gas turbine fault diagnosis
神經網路的燃氣輪機故障診斷Light weight gas turbine exhaust smoke measurement
輕型燃氣輪機排氣冒煙測量Applied specification of fuels for light weight gas turbine
輕型燃氣輪機燃料使用規范The exergy analysis of the power turbine for gt
航改型艦用燃氣輪機的火用分析Operation and maintenance of gt fuel gas system
燃氣輪機燃料氣系統的運行維護Experimental studies on s1a - 02 gas turbine with water injection into compressor interstage / inlet as well as that on turbocharger self - loop test rig with inlet water injection are introduced. test results are in good accordance with simulation results, wet compression can lower compression work and increase engine power output so engine performance is enhanced, if engine power output is not changed, efficiencies of compressor and this engine become higher and turbine inlet temperature and fuel consumption become lower and if keeping t4 the same as that before wet compression is used, efficiencies become furthermore higher and engine power output increases greatly
實驗結果和計算結果同樣表明:濕壓縮減少了壓氣機所消耗的壓縮功,增加了燃氣輪機的輸出功率,提高了燃氣輪機性能,如果保持發動機輸出功率恆定,濕壓縮可以提高壓氣機和整個燃氣輪機機組的效率,與此同時,渦輪進口溫度t _ 3 ~ *和燃油消耗率下降;如果保持渦輪排氣溫度t _ 4 ~ *恆定,壓氣機和燃氣輪機機組效率進一步提高,燃氣輪機輸出功率增加。Retrofitting of power supply for gt lube - oil cooling fan
燃氣輪機滑油冷卻風扇電源改進分享友人