氣體電離計 的英文怎麼說

中文拼音 [diàn]
氣體電離計 英文
gaseous ionization counter
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 體構詞成分。
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動詞1 (離開) leave; part from; be away from; separate 2 (背離) go against 3 (缺少) dispens...
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • 氣體 : gas; gaseous fluid
  1. This article studies on a novel method about detector calibration and monochromator calibration by using silicon pin photodiode. the detector and the monochromator of one spectrum measurement system had been calibrated using the method, and the spectrum distribution of one laser - produced plasmas ( lpp ) source with jet gas target was measured. the use of a specific combination of the silicon photodiode and multiplayer reflect films is the notable character in monochromator calibration

    本文研究了一種利用光二極傳遞標準探測器標定普通探測器和單色儀系統的方法,實際標定了所用的探測器和單色儀系統,測得了噴靶激光等光源的相對光譜分佈,設出絕對光譜分佈的測量方法,並且利用labview的g語言及相應的數據採集卡等硬設備構造出一套智能化、高效率的測量系統,完成了多層膜反射率測量工作。
  2. In euv and soft x - ray band, the most often used detector is ion chamber with rare gas, from whose collective electrode we can directly calculate intensity of photon flux

    在極紫外和軟x射線波段常用的探測器是稀有室,可以通過室收集極的收集流直接算出光子流強度。
  3. Then these separated interferograms can be recorded by ccd camera the experiments with the multi - frame interferometer was carried out on a small gas - puff z - pinch device with 23 kv working voltage and 210 ka peak current and about 2 risetime, and good results were obtained

    該套干涉儀在小型噴式z箍縮裝置上進行了實驗, z裝置的工作壓23kv 、峰值流210ka 、流上升時間約2 。根據干涉圖條紋的移動數,可以算出等子密度和運動速度。
  4. The design undertaken mainly from the following aspects : 1, mechanism ddesign : included the base and the joints : 2, trasmission mechanism design : adopted a synchronous toothelike transmission bell ; 3, balance system design : adopted springs and a brake and a lay air cylinder ; 4, design parameter and verify alculation ; 5, established motion equation by d - h method ; 6, simulated the motion locus by matlab software ; 7 ^ mapping out the part drawing or asesembly drawing

    本設主要是從以下幾個方面入手: 1 、機構設:包括底座和臂關節的設; 2 、傳動機構設:將驅動機安裝在底座上,利用同步齒型帶、合器傳遞手臂的動力;利用齒輪傳動帶動底座回轉; 3 、平衡系統設:採用了彈簧平衡系統、磁式制動器和單向延時缸; 4 、設參數和校核算; 5 、用d ? h法建立運動學方程; 6 、利用matlab軟對手臂的運動空間進行模擬; 7 、利用autocad2000繪圖:包括零件圖和裝配圖。
  5. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制,以控制沉積過程,減少金剛石膜生長過程中的缺陷,並採用光纖光譜儀檢測分析等的可見光光譜以監測微波等化學相沉積過程;利用微波對材料的選擇加熱特性,通過構造等效方程,並首次將磁場攝動理論引入到mpcvd的基片加熱材料的設中,建立了非均勻等溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型,為mpcvd的基片加熱系統設提供了一條全新的技術路線以指導基片加熱材料的制備,並對基片加熱材料進行了設和優選,以獲取大面積均勻的溫度場區,甚至獲得大於基片臺尺寸的均勻溫度區;作為研究重點之一,開展了微波等化學相沉積金剛石的成核與生長研究,系統地研究了在( 100 )單晶硅基片上mpcvd沉積金剛石膜的實驗過程中,基片預處理、甲烷濃度、沉積壓、基溫度等不同實驗工藝參數對金剛石薄膜質量的影響,分別用raman光譜、 x射線衍射( xrd ) 、掃描鏡( sem ) 、紅外透射光譜( ir ) 、原子力顯微鏡( afm )對薄膜進行了表徵,確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  6. Standard test method for available cyanide with ligand displacement and flow injection analysis utilizing gas diffusion separation and amperometric detection

    擴散分探測法對有效氰化物進行配位位移和流量注入分析的標準試驗方法
  7. Instead of being a problem, electrical breakdown is part of the design because the gas is broken down to begin with

    這時,場崩潰將不再是個問題,而是設的一部份,因為必須先經過子化成為漿,才能開始反應。
  8. According to the complicated electromagnetic transient state process of the passive feedback coils, a method that can be used to calculate the equivalent time constants and the electrical parameters are given in this paper. these parameters are important to the design of the device and the power system, and also provide the evidence for the experiment of controlling the plasma unstability

    針對被動反饋線圈磁暫態過程的復雜性,給出了求解線圈等效時間常數和參數的方法,這些參數不僅對裝置的設源系統的設是重要的,而且為控制等垂直位移不穩定性的實驗提供了依據。
  9. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空冷卻實驗臺,熱管的加熱方式為加熱,工質為蒸餾水.在1 1模型上對分式熱管管內凝結換熱特性、不凝性對凝結換熱的影響及不凝性的擴散規律進行了試驗,得出分式熱管有一最佳充液率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性對分式熱管的凝結換熱僅影響冷凝段下部較小部分,通過排閥排出不凝性可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性對分式熱管冷凝段的影響減少.這些結論可用於分式熱管換熱器的工程設和控制
  10. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空冷卻實驗臺,熱管的加熱方式為加熱,工質為蒸餾水.在1 1模型上對分式熱管管內凝結換熱特性、不凝性對凝結換熱的影響及不凝性的擴散規律進行了試驗,得出分式熱管有一最佳充液率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性對分式熱管的凝結換熱僅影響冷凝段下部較小部分,通過排閥排出不凝性可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性對分式熱管冷凝段的影響減少.這些結論可用於分式熱管換熱器的工程設和控制
分享友人