氧化劑模型 的英文怎麼說

中文拼音 [yǎnghuàjìmóxíng]
氧化劑模型 英文
oxidant model
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 氧化劑 : oxidant; oxygenant; oxidizer; oxidizing agent
  • 氧化 : [化學] oxidize; oxidate; oxide; burning; rust; oxygenize; oxido-; oxy-
  • 模型 : 1 （仿製實物） model; pattern 2 （制砂型的工具） mould; pattern3 （模子） model set; mould patter...
  1. At first, the bonded magnet has been produced at varied technological conditions. then the influences of varied technological conditions, such as species and quantity of coupling agent, species and quantity of agglomerant, process of compression moulding and solidification process on magnetic property and compression strength of bonded magnet have been analysis by means of apparatus for measuring magnetic property and compression strength

    首先，在不同工藝條件下制備出粘結磁體，然後利用磁性能測試儀、力學性能測試設備等測試手段，分析了偶聯劑的類型及其用量、粘結劑的類型及其用量、模壓工藝和固化工藝等因素對鐵氧體粘結磁體磁性能及力學性能的影響。
  2. Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application

    熱、壓環境下壓阻變換壓力傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型，模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究表明，硼硅堆導致產生一定的非線性，但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器輸出的滯后和漂移誤差.然而，在相對穩定的環境下，軟黏合劑對傳感器的影響可以忽略.此外，詳細的設計和過程信息有助於提高模型的適用性
  3. In order to investigate the influence of characteristics parameters on detonation wave in a two - phase pulse detonation engine model. the peak detonation pressures and average velocities of two - phase pulsed detonation wave produced by pde model using gasoline as fuel and air as oxidizer under various ignition frequencies and various mixture ratios are measured systematically, and the relations influencing them are analyzed

    為了探索氣-液兩相脈沖爆震發動機模型內特徵參數對產生爆震波的影響規律，系統地測試了以汽油為燃料、以空氣為氧化劑的氣-液兩相脈沖爆震發動機模型在不同點火頻率及不同余氣系數下爆震波的峰值壓力以及平均爆震波速，並對其變化進行了分析。
  4. Then the author has constructed the submodel of the time of blowing oxygen and refrigerant, making use of the rbf neural networks. meantime, applying the genetic algorithm, completed the optimizationof parameter of the number of neuron and spread, and get the model with a better generalization ability

    然後分別應用rbf神經網路建立吹氧時間子模型、冷卻劑子模型，並結合遺傳演算法完成rbf神經網路本身其神經元個數、 spread等參數的優化，使模型具有較強的泛化能力。
  5. In this paper the anode porous diffusion layer model of dmfc for mass transfer has been described on the basis that all components are gaseous and well mixed. the purpose of the model is to determine the variation in concentration of species in the diffusion layer and thus the concentration of the reactive species at the edge of the reaction layer

    本文還推導出了氣相進料的dmfc陽極多孔擴散層模型，模型詳細描述了甲醇，水以及二氧化碳在擴散層中的傳遞和反應，使用本模型可以確定各種物質在陽極多孔擴散層中濃度的變化，並可由此確定氣體擴散層催化劑層邊界處反應物質的濃度。
  6. Besides policy factors, five methods of cost - cutting of biodiesel are reviewed, including new raw material with higher oil content, shorter regeneration cycle, which is suitable for infertile soil and different climatic conditions ; heterogeneous catalysts ; new technologies ( e. g. supercritical methanol and ultrasonics ) ; higher added value utilization of by - product glycerin with simple method ( propylene oxide chloride, 1, 3 - propanediol, pyruvic alcohol etc. ) and moderate scale of production

    摘要綜述了除政策因素外，降低生物柴油生產成本的5種方法：選擇含油率高、再生周期短、適應貧瘠土地及不同氣候條件的新型植物原料；研究新型固體催化劑；引入新工藝（超臨界法和超聲波法） ；使用比較簡便的方法將廢棄的甘油轉化為高附加值的產品（環氧氯丙烷、 1 ， 3 -丙二醇、丙酮醇等）以及適度生產規模等。
  7. Special attention is paid to the consequences of methanol crossover in cathode reaction and cathode over - potential. good agreement is found between simulations and experiments in regard to the v - i character of dmfcs. based on the theory of parallel electrode reaction, it becomes possible to obtain quantitatively the value of over - potential caused by methanol crossover, which is either implicit or not included in the overall cathode over - potential in previous models

    該模型涵蓋了dmfc中的主要物理化學過程，包括：甲醇水溶液在膜電極內的擴散、對流和電遷移；質子在陽極催化劑層和陰極催化劑層內的傳遞；氧氣、水蒸汽在陰極的擴散；陽極催化劑層內的甲醇氧化反應動力學；以及陰極催化劑層內的氧還原和甲醇氧化反應動力學。
  8. Effect of chromium - rich chinese drug and chromium - rich well water on the biochemical indices of rats with alloxan diabetes

    富鉻中藥制劑和富鉻井水對四氧嘧啶糖尿病大鼠模型各種生化指標的影響
  9. Firstly, the theories relative to radiation effect are discussed in brief, including some models of interface trap formation and process of producing oxide trap charge in radiated mos devices. besides, the radiation effects at low dose rate and the mechanism of radiation hardening for bf2 implantation are reviewed too

    首先，對有關輻照效應的理論進行了簡要的敘述，介紹了輻照過程中氧化物陷阱電荷的產生過程以及界面態建立的一些模型，另外，還對低劑量率輻照效應以及bf _ 2 ~ +注入加固mos器件的機理做了回顧。
  10. The combustion model of the oxidizing gas and the fuel pyrolytic gas in the motor was also developed. the simulation of combustion flow is performed under various o / f ratios and different motor chamber structures

    建立了發動機內氧化劑氣體和燃料熱解氣體的燃燒模型，並對不同配比條件和不同燃燒室結構的燃燒反應流進行了計算。
  11. Effects of acanthopanax sentocosus and gspe prescription on liver apoptosis and oxidative stress in ageing model mice

    葡萄籽提取物方劑對衰老模型小鼠肝臟細胞凋亡及氧化應激的影響
  12. Well - ordered 3d - cubic, 2d - hexagonal, and disordered mesoporous silica films were synthesized by using non - ionic alkyl polyethylene oxide ( peo ) surfactants as a template, under the existence of different kinds acids respectively

    摘要在不同種類酸的存在下，以非離子型烷基聚氧乙烯表面活性劑為模板分別制備出有序三維立方、二維六方和無序結構的介孔氧化硅薄膜。
分享友人
分享到 Line

分享到臉書