氧化物粉末 的英文怎麼說

中文拼音 [yǎnghuàfěn]
氧化物粉末 英文
oxide powder
  • : 名詞[化學] (氣體元素) oxygen (o)
  • : 名詞1 (東西) thing; matter; object 2 (指自己以外的人或與己相對的環境) other people; the outsi...
  • : Ⅰ名詞1 (粉末) powder 2 (用澱粉製成的粉條或粉絲) noodles or vermicelli made from bean potato o...
  • : Ⅰ名詞1 (東西的梢;盡頭) tip; terminal; end 2 (非根本、非重要的事物) nonessentials; minor detai...
  • 氧化物 : oxide; oxyde; oxidizing material; oxidate
  • 氧化 : [化學] oxidize; oxidate; oxide; burning; rust; oxygenize; oxido-; oxy-
  • 粉末 : powder; flour; stive; smalls
  1. Preparation and characterization of ultrafine cerium - zirconium oxide powder

    納米鈰鋯氧化物粉末的制備和表徵
  2. Description : jade - green powder, insoluble in water, swoluble in acids uses : raw material for making praseodymium oxide ank other praseodymium compound

    說明:淺綠色,不溶於水,不溶於酸。用途製造鐠和的其他的重要原料。
  3. Lead hydrogen phosphite superfine powder, lead oxide phosphite hydrate superfine powder and tribasic lead sulfate superfine powder were prepared by micro - liquid - phase synthesis method ( mlps method ) in this paper. at room temperature, acetic acid worked as catalyst, lead oxide and phosphite or sulfate were blended thoroughly, then were ground for tens minutes

    本文採用微液相合成法制備了亞磷酸鉛、二鹽基亞磷酸鉛和三鹽基硫酸鉛超細,以鉛和亞磷酸或硫酸為原料,以醋酸為催劑,在室溫下充分混合、研磨幾十分鐘,乾燥后即可得到產
  4. Combining with characters of powder, the mechanic of powder plastic deformation, the strengthen cause of powder extrusion products, the effect of surface oxide and powder strengthen materials property and formability of powder extrusion products were introduced and discussed in this dissertation

    論文結合的特性,對塑性成形的機理、擠壓製品的強機制、表面及顆粒強材料對擠壓製品的性能和成形性的影響進行了述評。
  5. Determination of density for magnetic oxide powders. determination of tap density

    磁性氧化物粉末密度測定.振實密度的測定
  6. The results of sem indicated that the mixture was important for the morphology of the whiskers

    結果表明碳氫和納米2種摻入對晶須形貌的影響很大。
  7. These particles will aggregate into a certain structure when the applied field yields a critical value. the other is fabricated from " half - metallic " oxides, i. e., ferromagnetic oxides which are predicted theoretically to be completely spin - polarized and really found experimentally to have very high spin - polarization. when a magnetic field is applied to half - metallic granular systems, the resistance will drop rapid and dramatically, which is called the extrinsic magnetoresistance effects in half - metallic granular systems

    在磁性材料中,亦有由在理論上具有完全的自旋極率、在實驗中也被證實具有高自旋極率的一系列半金屬材料構成的多晶、等顆粒體系,被發現能在外磁場下發生顯著的電阻下降,即半金屬顆粒體系中的外稟磁電阻效應。
  8. Moreover, the investigation for the ma of cu - cr indicates that : with using of protective atmosphere, active carbon has a good effect on the oxidation control during milling ; the structure refining and increasing of interface and defect result in the formation of non - equilibrium phase

    此外,對cu - cr難互溶體系的ma研究表明:的結構細及界面、缺陷的產生導致了ma過程中亞穩相(非晶、過飽和固溶體)的轉變與形成;與保護性氣氛相比較,活性炭對ma過程中的現象有良好的控製作用。
  9. The preparing process is as follow : mixing the nickel salt, zirconium salt and stabilizer in the solvent ( distilled water ) to prepare mixing solution according to a certain ratio ; commingling the mixing solution and coordination solution of carboxylic ammonia in accordance with a certain rate to form sol, drying the sol and turning it into gel, pre - sintering the gel to get the zro2 - nio powders and the zro2 - ni nanocrystalline composite powders were gained by reducing the zro2 - nio powders

    方法如下:將鎳鹽、鋯鹽、穩定劑和水溶劑按所需成分配成混和溶液,再將混和溶液、外加劑按比例混和形成溶膠,溶膠經乾燥成為凝膠,凝膠經預燒得到ysz - nio納米,將該術還原得到ysz - ni納米復合術。絡合。
  10. In this study, the preparing processes of zro2 - ni nanocrystalline composite powder aremixing the nickel salt, zirconium salt and stabilizer, solvent ( distilled water ) together to prepare the mixing solution according to certain ratio ; commingling the mixing solution, coordination solution of carboxylic ammonia, intrusion aid in accordance with certain rate to form sol, drying the sol and turning it into gel, pre - sintering the gel to get the zro2 - nio powder and gaining zro2 - ni nanocrystalline composite powder by reducing the zro2 - nio powder. xrd, x - ray wide - angle diffractometer, bet, sem, tem, hrtem analyses are used to study the zro2 - ni nanocrystalline composite powder and zro2 - ni cermet. the sintering temperature is determined

    本研究的zro _ 2 - ni納米復合的制備方法如下:將鎳鹽、鋯鹽、穩定劑和溶劑(水)按所需成分配成混合溶液,再將混合溶液、外加劑和氨羧絡合劑按比例混合形成溶膠,溶膠經乾燥成為凝膠,凝膠經預燒得到zro _ 2 - nio納米,將該還原得到zro _ 2 - ni納米復合
  11. Powder flame spray and spray fusig gun, with various powder nozzles attached, can do spray coating with fine metallic powder and ceramic powder

    火焰噴塗噴焊設備,配有各種噴嘴,能噴塗金屬微細塗層。
  12. Powder flame spray or spray fusing gun can be used with inert gas to feed powder with best coating effects, and can also be used for spary of ceramic powder

    火焰噴塗噴焊設備。用惰性氣體送,能得到更佳塗層品質,也可噴塗塗層。
  13. Plastics - epoxy powder moulding compounds ep - pmcs - part 3 : requirements for selected moulding compounds

    塑料.環樹脂模塑.第3部分:對所選模塑的要求
  14. Determination of density for magnetic oxide powders. determination of apparent density : oscillating funnel method

    磁性氧化物粉末密度測定.松裝密度的測定.振動漏鬥法
  15. Under the same experimental conditions, the reaction is more thorough and the durative time of the reaction is also longer when the quantity ratio of cuo to the other oxides is 3 : 1 than when it is 2 : 1

    在相同的實驗工藝條件下, cuo與其它氧化物粉末的質量比為3 : 1時,原位反應比2 : 1時徹底,持續時間較長,所制備鋁基復合材料微觀組織均勻細小。
  16. Advanced technical ceramics. methods of test for ceramic powders. part 3 : determination of the oxygen content of non - oxydes by thermal extraction with a carrier gas

    高級技術陶瓷.陶瓷的試驗方法.第3部分:非含量測定.氣體熱萃取法
  17. Standard test method for surface finger oxide penetration depth and presence of interparticle oxide networks in powder forged steel parts

    鍛鋼部件中表面指狀穿透深度和粒子間網狀組織出現的標準測試方法
  18. Optimum process of preparing ceo2 - zro2 - la2o3 ultrafine powder

    鈰鋯氧化物粉末制備工藝及其優
  19. Pulse electric current sintering is an advanced technology for materials synthesis and one of effective methods for preparation nano - structure ceramic. but the sintering mechanism is different with traditional sintering method. the sintering phenomena of oxide nano - powders have been investigated in this paper

    放電等離子體燒結技術( sps )是材料制備新技術之一,也是制備納米相陶瓷的有效方法之一,但燒結金屬納米過程中的緻密機理與傳統理論有一定的區別,本文對脈沖電流燒結金屬納米進行了系統研究。
  20. It has weak - link free grain boundaries and is a kind of low cost material, . which could be used under 20k ~ 30k. however, mgb2 reveals a poor jc property in high magnetic field. currently in the research of the mgb2 wires and tapes many efforts have been made to improve its grain connection or enhance the jc dependence on the magnetic field using the method of chemical doping

    二硼鎂是迄今為止所發現的超導臨界轉變溫度最高的非銅超導材料,它具有無弱連接、成本低廉、能夠在20k 30k應用等優勢,但是mgb2在外場下的臨界電流特性較差,目前在優套管法制備mgb2線帶材工藝的研究中,通過改善晶間連接和利用學摻雜提高樣品的超導臨界電流密度是mgb2成材研究的一個重要方向。
分享友人