氧化物純化法 的英文怎麼說

中文拼音 [yǎnghuàwùchúnhuàfǎ]
氧化物純化法 英文
oxide passivation
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 物 : 名詞1 （東西） thing; matter; object 2 （指自己以外的人或與己相對的環境） other people; the outsi...
  • 純 : 形容詞1 （純凈; 不含雜質） pure; unmixed 2 （純粹; 單純） simple; pure and simple 3 （純熟） skil...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 氧化物 : oxide; oxyde; oxidizing material; oxidate
  • 氧化 : [化學] oxidize; oxidate; oxide; burning; rust; oxygenize; oxido-; oxy-
  • 純化 : purification; purifying; depuration; edulcoration; purify
  1. Determination of micro - quantity of iron in highly pure titanium oxide with extraction - spectrophotometry of 1, 10 - o - phenanthroline - iron - picrate ternary complex

    苦味酸鹽三元配合物萃取分光光度法測定高純鈦氧化物中微量鐵
  2. Using i - dopa as a specific substrate, phenoloxidase ( po ) from penaeus chinensis hemolymph was purified by gel - filtration and ion - exchange chromatography, and characterized in terms of its molecular weight and enzymatic properties in this study

    本文以中國對蝦（ penaeuschinensis ）的血淋巴為材料，利用凝膠過濾和離子交換等方法，對酚氧化酶（ phenoloxidase ）進行了分離純化和生物化學性質研究。
  3. The paper developed a novel method of preparation of potassium ferrate by hypochlorite oxidation, and determined the optimal parameters. the experimental results demonstrate that fe ( vi ) compounds with high purity and yield can be prepared by raw technical materials. a variety of fe ( vi ) cathode materials, synthesized by potassium ferrate and alkaline - earth metal salts, provide a high - energy electrochemical discharge

    採用改進的次氯酸鹽氧化法（濕法） ，以工業級的原料，在實驗室內，從1到4倍率規模合成高純度、高收率的fe （ ）化合物起始物? ?高鐵酸鉀，純度可達98 、收率在80以上；再以高鐵酸鉀為原料合成堿土金屬fe （ ）化合物或其他fe （ ）復合物，其中堿土金屬fe （ ）化合物純度可達94以上。
  4. Tremendous efforts are underway on the lithium manganese oxides which are considered to attractive alternatives in term of cost, abundance and nontoxicity for lithium ion battery. the spinel li4mn5o12 and cation - doped lithium manganese oxides were synthesized by sol - gel method which is considered as a promising method

    本文以立方晶系尖晶石結構的富鋰鋰錳氧化物為主要研究對象，以檸檬酸為配合劑，用溶膠-凝膠法合成了純凈的單相尖晶石li _ 4mn _ 5o _ （ 12 ）以及摻雜產物。
  5. The pyrolysis products of fiber were analyzed by pgc - ms. it showed that the content of co2 in the pyrolysis products of pet / mmt fiber was relatively higher than that of pure pet fiber, while the content of flammable hydrocarbon was lower, which maybe result in the flame resistance of pet / mmt fiber

    利用裂解氣相色譜一質譜聯用法（ pgc一ms ）對pet / mmt纖維和純pet纖維的阻燃性能進行分析比較，發現蒙脫土的存在使纖維裂解產物中二氧化碳的含量相對較高，這可能是其具有阻燃性的重要原因。
  6. The sample composition was analyzed by means of tg and x - ray diffraction. the following conclusions can be drawn from the experiments : given conditions, the sample powder that has the same xrd data as the standard fetioa can be gotten when use any method mentioned above ; the key in synthesis is to avoid the oxidation of fe2 +, so the whole process should performed under vacuum or neutral atmosphere, samples used by this study were prepared under nitrogen atmosphere ; the heat - treated time and temperature have some influence on the sample powder, results show that the proper time and temperature is 120 minutes and 1100 respectively

    研究結果表明：在合適的反應條件下，用上述三種合成方法都能得到xrd數據與標準fetio _ 3物相基本吻合的粉體；合成反應需要克服的主要問題是防止體系中fe ~ （ 2 + ）的氧化，因此，整個反應必須在真空或者非氧化性氣體保護下進行，本研究需要的樣品是在高純從保護下合成的；煅燒的時間和溫度對最終的產物也有一定的影響，研究發現：合理的煅燒時間和溫度分別為120分鐘和1100 。
  7. In addition, the effective combination technologies of ultrasonic, microwave, alternating current deposition, supercritical fluid drying with traditional liquid methods is the most promising one to prepare high purity, small size and well - proportioned dispersing nano - particles

    而超聲技術、微波輻射技術、交流電沉積技術、超臨界流體乾燥技術、非水溶劑水熱技術等新技術與傳統液相法的有機結合，是制備高純度、小粒徑、均勻分散的金屬氧化物納米粉體的最有前途的方法。
  8. Methods of test for petroleum and its products - determination of oxidation stability of straight mineral oil

    石油和石油產品的試驗方法.純礦物油的氧化穩定性的測定
  9. A new purified method for carbon nanotube was put forward. 2. study of aligned multi - wall carbon nanotube layered multi - wall carbon nanotube arrays were synthesized firstly directly on the surrounding of the reaction quartz tube, in a ar / h2 atmosphere by pyrolysis of ferrocene in xylene into a suitable reaction furnace with cobalt powder in

    與根據碳納米管的物理、化學性質，提出了一種全新的碳納米管純化方法：先對制備的碳納米管於500在空氣中氧化30分鐘，然後用18的鹽酸煮20分鐘，最後將樣品稀釋，過濾，再用去離子水過濾3次，烘乾，便可得到純的碳納米管。
分享友人
分享到 Line

分享到臉書