氧激光器 的英文怎麼說

中文拼音 [yǎngjīguāngqì]
氧激光器 英文
oxygen laser
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 激光器 : [光學] （光激射器） laser （縮自 light amplification by stimulated emission of radiation）; optic...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. Lanthanum oxysulfide laser los laser

    氧化硫化鑭激光器
  2. Due to the large exciton binding energy of 60mev, which ensures the high efficient excitonic emission at room temperature, it is regarded as one of the most promising materials for fabricating efficient ultraviolet ( uv ) and blue light emitting devices

    由於氧化鋅具有較高的激子束縛能（ 60mev ） ，保證了其在室溫下較強的激子發光，因而被認為是製作紫外半導體激光器的合適材料。
  3. With the development of science and technology, more and more oxide crystals are synthesized by more and more advanced technique, the new oxide crystals are incessantly synthesized and the new characters of oxide crystals are incessantly founded. corundum dopped with impurity not only is cherished because of it ' s beautiful appearance, but also is used in the fields such as electrotechnics, mechanism, laser, the optic apparatus and the underlay of semiconductor. sapphire dopped with ti3 + is the best material of the tunable solid laser. zno crystal is material of the direct gap semiconductor ( the width of forbidden band : 3. 37ev ). the excited emission in zno crystal at room temperature has been found, so the ultraviolet luminescence in zno semiconductor can be acquired at room temperature

    含有少量雜質的剛玉晶體（ - al _ 2o _ 3 ）不僅由於其色澤艷麗成為人們珍愛的名貴寶石，而且由於它具有的優異性能，被廣泛應用於電工、機械、激光器，光學器件和半導體襯底材料。鈦藍寶石是目前最優異的固體寬帶調諧激光材料，用於製作飛秒脈沖可調諧激光器。氧化鋅晶體是直接帶隙寬禁帶半導體材料（禁帶寬度3 . 37ev ） ，現已發現具有室溫下受激發射特性，有可能實現室溫下半導體紫外發光。
  4. On describing a genetic algorithm ( ga ), we present a method for applying ga to optimize the lasers. a programming is presented for obtaining the maximum laser power. by using the method we optimize the cvl and the co2 laser, including lc circuit parameters of the cvl, the cvl system, the lasing resonator and the gas components mixtured in the co2 laser tube

    在這個部分中，首先簡述了遺傳演算法，討論了應用遺傳演算法來優化激光器的思想和方法，給出了優化大功率激光器的計算機程序設計；然後，對銅蒸汽激光器lc放電電路、大口徑激光器和激光器系統分別進行了優化；對二氧化碳激光器諧振腔和氣壓參量分別進行了優化，介紹了優化二氧化碳激光器諧振腔的實驗以及實驗所獲得的結果
  5. Fast - transverse - flow co2 laser

    快速橫流二氧化碳激光器
  6. Calcium containing silicate oxyapatite laser

    含硅酸氧化磷灰石的蓋激光器
  7. In this paper, micro - cavity semiconductor laser ( mcsl ) with pillar vertical - cavity surface - emitting structure ( vcsel ) which has potential applications in optical communication and optical interconnect is theoretically analyzed, the calculation model that used to discuss the modal performance of rectangular columnar and cylinder vcsel with oxidized aperture is established by using vector field model. the numerical simulations in the case of cylinder structure show oscillating wavelength and threshold gain against inside and outside radius of laser, the layer refractive index and pair number of bragg mirror, thickness, position and oxidized material ' s refractive index of oxidized aperture, in detail. more practically, considering dos shell of laser as non - perfect one, or supposing that dos shell is separated from the laser, we can obtain more significative results

    本工作以矢量場模型出發，對具有誘人應用前景的柱形垂直腔面發射結構（ vcsel ）的微腔半導體激光器（ mcsl ）進行了理論分析，建立了用於分析方柱形和圓柱形結構具有氧化孔徑層的激光器的模式特性的理論模型；對圓柱形結構情況進行了數值模擬，得到了振蕩波長、閾值增益隨激光器內外半徑、 bragg反射鏡層折射率、周期數以及氧化孔徑層厚度、位置和氧化物折射率的詳細變化規律；為使理論計算更接近實際，將外加金屬包殼視為非理想導體，或將金屬包殼與激光器結構隔開，分別對這兩種情況下的結果進行了討論。
  8. Polarization characteristics of laser beam, which is one of the important characteristics of high power laser, have a direct effect on output power, damage threshold of optical elements and beam quality etc. the polarization characteristics in the high power coil resonator is analyzed by jones calculus, and draw a conclusion that, in general the eigen - polarization state is elliptical polarization

    激光光束的偏振特性是高功率激光器的一個重要特性之一，直接影響著高功率激光器的輸出功率、腔內光學元件的損傷以及光束質量等。本文首先利用瓊斯矩陣演算法對高功率氧碘激光器腔內的偏振特性進行了分析，並得出結論，諧振腔內的本徵振蕩一般為橢圓偏振。
  9. The main work can be summed up as follows : firstly, we studied the thermal - field properties of vcsels, and analyzed the influences of current spreading, material parameters and operating conditions on the temperature distributions. secondly, we began with the electrode voltage and calculated the equipotential s distributions, compared the distributions of voltages and current densities in different depths of vcsels, and then studied the influences of the oxide - confining region with different position or thickness, and the different sizes of the gain - guided aperture and emitting window on the distributions of the injected current density, carrier concentration and temperature in the active region. thirdly, we realized the coupling of electricity, optical and thermal - fields, worked out the threshold voltage, calculated the distributions of the injected current density, carrier concentration and temperature under different offset voltages, and analyzed the impacts of temperature profile and carrier density on the refractive index, fermi levels and optical - field

    具體工作可以概括如下：首先，研究了vcsel的熱場特性，分析了電流擴展，材料參數和工作條件對于溫度分佈的影響；其次，從電極電壓入手，計算出激光器中的等勢線分佈，並對不同深度處的電壓和電流分佈進行比較，研究了高阻區的不同位置和不同厚度、限制層和出射窗口半徑的大小對電流密度、載流子濃度和溫度分佈的影響；再次，實現了電、光、熱耦合，求出了閾值電壓，計算了不同偏置電壓下的電流密度分佈、載流子濃度分佈和熱場分佈，分析了溫度和載流子濃度變化對折射率、費米能級和光場的影響；最後，給出了考慮n - dbr和雙氧化限制層時激光器中的等勢線分佈，分析了n - dbr和雙氧化限制層對vcsel電流密度、載流子濃度、溫度和光場分佈的影響。
  10. The research on surface work - hardening in high speed lapping

    選擇氧化工藝在垂直腔面發射激光器中的應用
  11. We use the laser output ( 320 nm, 200 fs ) of optical parametric amplifier ( opa ) in < wp = 5 > an active passive mode - locked femtosecond ti - sapphire laser operating at a repetition rate of 1khz as a exciting resource to develop optically pumped stimulated emission of zno thin films. when rectangular stripe laser irradiates thin films, optical resonant cavity is naturally formed between two nanocrystallites along with the rectangular laser stripe and planar weveguide confines the light scattering

    利用飛秒激光器作為光泵浦激發光源，研究了氧化鋅薄膜的光泵浦受激發射，當條形光斑輻照薄膜樣品時，將沿著光斑條由氧化鋅納米晶面自然地形成光學諧振腔，由於平面介質波導結構限制光散射，所以成功地觀測到二氧化硅襯底上的納米氧化鋅（ zno ）薄膜的紫外受激發射。
  12. With the development of infrared tunable opo, its application is more and more wide. lt is possible for us to estimate the quality of resonant mirrors in laser with high energy and to improve the output energy of laser, by measuring the reflectivity of resonant mirrors of coil and df laser by cavity - ring - down which use output wave of opo as the laser source, instead of coil and df laser with high price and huge space

    用opo紅外輸出激光作為光腔衰蕩的光源代替價格昂貴、體積龐大的氧碘和氟化氖激光器，對其諧振腔鏡的高反射率進行測量，以達到對高功率激光器腔鏡高反膜質量的評價，為改進膜系設計、鍍膜工藝優化和提高激光器的輸出能量提供理論依據。
  13. Flowing gas co2 laser

    流動式二氧化碳激光器
  14. In this paper dyes doped silica gels were prepared by sol - gel method in order to find the relationship between the character and the structure of the composite. techniques and theories will be attributed to the fabricating the excellent solid tunable dye lasers material

    本文是利用溶膠-凝膠工藝將有機染料均勻摻入到二氧化硅凝膠基質，以研究復合材料的組成、結構和性能間的相關規律，為制備性能優異的固體可調諧染料激光器提供理論依據和工藝條件。
  15. Applying the genetic algorithm, the cvls and the co2 lasers are optimized for obtaining the maximum output power

    應用遺傳演算法和數值計算，優化設計大功率銅蒸汽激光器和二氧化碳激光器
  16. By testing, the total thermal of the microchannel heatsink for cooling high power semiconductor diode laser arrays is 0. 645 / w, which is consistent with the result of theory counting

    通過測試，所制得的無氧銅微通道熱沉冷卻半導體激光器的總熱阻為0 . 645 ~ 0c w ，與理論分析基本吻合，滿足散熱要求。
  17. Co2 laser - based differential absorption lidar ( dial ) systems have been used extensively for the remote sensing measurement of molecular species in the atmosphere and trace gases, therefore, have important value in military and civilian fields

    基於二氧化碳激光器的差分吸收激光雷達（ co2dial ）系統被廣泛地應用於對大氣分子種類以及微量氣體進行遙感的測量之中，具有非常重要的軍事和民用價值。
  18. Considering the practical manufacturing condition, an oxygen - free copper microchannel heatsink consisting of five copper sheets is designed and fabricated utilizing the technology of deep photolithography, mechanical machining, and bonding with medium

    根據實際製作條件，設計了五層結構微通道熱沉，採用深層光刻分離曝光化學腐蝕技術、機械加工技術和銅直接粘接技術（ dbc ）制備出冷卻大功率半導體激光器迭陣的無氧銅微通道熱沉。
  19. All of these are utilized to develop a high sensitivity photoacoustic spectrometer based on a coa laser, which could reach a detection limit of 10 ' 11 for ethylene

    在基於常規的二氧化碳光聲系統的基礎上，研製成功了結構緊湊的基於波導二氧化碳激光器的光聲光譜儀。
  20. Meauring mathod of major parameter for co2 lasers

    二氧化碳激光器主要參數測試方法
分享友人
分享到 Line

分享到臉書