氧飽和率 的英文怎麼說

中文拼音 [yǎngbǎohélǜ]
氧飽和率 英文
percentage of oxygen saturation
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  1. Alarm method : sound and lighht alarm alarm contents : heart rate blood pressure saturation oxygen pulse animal heat

    報警內容：心率血壓血氧飽和率呼吸體溫心率異常
  2. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採用有機硅單體延遲滴加及添加水解抑制劑等技術，有效防止了-甲基丙烯酰氧基丙基三甲氧基硅烷在乳液聚合過程中的過渡水解及縮合反應，提高了聚合物大分子鏈中有機硅鏈節的含量；利用紅外光譜與差示掃描量熱儀對產物分子結構進行了表徵，並通過對共聚產物力學和吸水率的測試，證實了本研究所制備的有機硅改性丙烯酸酯共聚物具有比純丙烯酸酯聚合物更優良的力學及耐水性能；從分子設計角度出發，利用醇解反應合成出水解、縮合反應速率較慢的兩種新型不飽和有機硅單體： ?甲基丙烯酰氧基丙基三乙氧基硅烷和?甲基丙烯酰氧基丙基三異丙氧基硅烷；利用核磁共振對新型硅烷單體結構進行了證實；研究表明利用新型硅烷單體可以制備出高硅烷含量的有機硅改性丙烯酸酯乳液，且其聚合產物具有較高的力學及耐水性能。
  3. The methods - three dimension fabric - enforced laminates, and sparse fabric - enforced laminates, layer - enforced laminates ? to enhance the interlaminar toughness of fabric - reinforced laminates were discussed in this paper. the stitching method to enhance interlaminar toughness of stitched - laminates was mainly discussed in this paper based on our research and experiment. the middle - alkali glass fabric used as enforced - material with thickness of 0. 2mm, 3 section 600 deniner kevlar yarn is used as stitching thread in this research, which improved lock stitching way and different kinds of stitching mode were adopted

    以提高層合板復合材料的層間斷裂韌性（能量釋放率）為目標，採用中堿玻璃布為增強材料，對疊層后的玻璃布，採用凱芙拉縫合線、改進的鎖型縫合方法、不同的縫合工藝進行了縫合；基體採用的是不飽和樹脂，固化劑為過氧化甲乙酮，促進劑為環烷酸鈷液；在室溫下採用真空輔助rtm （ resigntransfermolding ）成型固化方法，製作了不同縫合工藝的玻璃布增強復合材料層合板。
  4. This project mainly studies the effects of breathing 70 % oxygen on hemorheology after incremental exercise to exhaustion. the blood viscosity ( bv ), plasma viscosity ( pv ), erythrocyte aggregation index ( al and a2 ), erythrocyte deformability index ( tk ), erythrocyte rigid index ( vr ) and hematocrit ( hct ) were obtained and analyzed. the vo2 max, hl, hr and po2 were measured and analyzed quantitatively as well

    本文觀察了一次性遞增負荷至力竭運動以及運動后吸入高濃度氧對血液流變性的影響，通過對運動后血液流變學指標與最大吸氧量、血氧飽和度、血乳酸、心率等指標作多因素相關分析，為運動影響血液流變學的原因和機制的研究提供一定的實驗依據。
  5. The investigation presents a new method of dipping sic kiln furniture into 2 saturable solution or into the saturable solution of ca3 ( po4 ) 2 and a1po4 in order to beneficial to its crystalline structure change and its properties, to make it packed and decrease its porosity. it can also hinder the diffusion of oxygen so as to decrease the oxidation rate and lengthen the useful life. the mechanism of dipping two kinds of phosphate saturable solution were studied and proved by the results of scanning electron microscope

    本研究首次採用sic窯具材料浸漬ca _ 3 （ po _ 4 ） _ 2飽和溶液和浸漬ca _ 3 （ po _ 4 ） _ 2與alpo _ 4混合飽和溶液的方法，目的在於有利於窯具材料晶相結構的轉化和性能的優化；能堵塞材料的氣孔，降低透氣率，阻礙o _ 2擴散，降低氧化速度，延長窯具材料的使用壽命。
  6. The formation process of w - type ferrite underwent from oxide of metal, the m - type transition phase to final w - phase. when the heating rate was 5 / min, at 900 for 3 hrs and 1200 for 4 hrs, pure m - type and w - type ferrites were formed in air respectively. with heat treatment temperature increasing, crystal structure was more intact, the saturation magnetization increased and the coercive force decreased

    熱處理過程表明， m型鐵氧體直接由金屬氧化物反應形成，未經歷尖晶石中間相； w型鐵氧體形成由金屬氧化物到m相過渡相最終向w相的轉變；當升溫速率為5 min ，溫度在900 ，保溫3小時和1200保溫4小時，就分別形成單相m相和w相鐵氧體；隨著熱處理溫度的升高和保溫時間的延長，衍射峰變尖銳，結晶更完整，空心微球的飽和磁化強度增大，矯頑力減小。
  7. This thesis elaborates a self - developed measuring equipment for pulse oximetry. this unit can output the standard oximetry test signal comparatively with difference sensors of the tested pulse oximetry, include pulse rate, peep and oxygen saturation

    所述脈搏血氧儀校準裝置，它能產生一個與被檢脈搏血氧儀傳感器類型相對應的標準血氧測試信號，包括脈率、脈沖幅度和血氧飽和度。
  8. Some important parameters, such as the small signal gain, the saturation gain and the laser output power, are described for a typical sealed - off co2 laser

    然後，對典型的封離型二氧化碳激光系統，討論了小信號增益，飽和增益以及激光的輸出功率
  9. Our factory ' s soft ferrite made from good - quality iron oxide has merits of high permeability, high saturation magnetic flux density and low loss, and id widely used in electric and electronic sets of various kinds

    利用本公司優質氧化鐵生產的軟磁鐵氧體，具有高磁導率，高飽和磁通密度和低損耗的優點，它廣泛的用於各類電子電器整機中。
  10. Plastics. unsaturated polyester and epoxy resins. determination of overall volume shrinkage

    塑料製品.不飽和聚酯樹脂和環氧樹脂.體積總收縮率的測定
  11. Abstract : the saturation behavior of stress current is studied. the three types of precursor sites for trap generation are also introduced by fitting method based on first order rate equation. a further investigation by statistics experiments shows that there are definite relationships among time constant of trap generation, the time - to - breakdown, and stress voltage. it also means that the time constant of trap generation can be used to predict oxide lifetime. this method is faster for tddb study compared with usual breakdown experiments

    文摘:基於一階速率方程，討論了恆定電壓應力下應力電流的飽和行為.通過對應力電流的擬合，發現存在三類缺陷產生的前身.更進一步的統計實驗顯示，在缺陷產生時間常數、擊穿時間以及應力電壓之間存在著明確的關系.這意味著缺陷產生時間常數能夠被用於有效預測氧化層的壽命.與常規的氧化層擊穿實驗相比，基於缺陷產生時間常數的預測更快、更有效
  12. The molecules of soft sections of sbs elastomers are not satuated and is easily to be oxidized. it is highly possible to create degradation by manufacturing in high temperature and high shearing rate

    Sbs軟質段分子段有不飽和鍵，容易被氧化，高溫或高剪切率加工產生材料降解degradation可能性高
  13. We emphatically discussed how the sintering environment affected initial permeability ( ui ), and how different contents of zno varied saturation magnetization ( bs ) and curie temperature ( tc ). the factors of affecting temperature stability of ferrites were analyzed. finally, we compared sol - gel auto - combustion way with conventional ceramic method

    其中重點探究了燒結條件對鐵氧體起始磁導率_ i的影響以及不同原料配方對鐵氧體飽和磁感應強度bs和居里溫度tc的影響，而且探討了溫度穩定性的產生機理及摻雜co ~ （ 2 + ）對鐵氧體溫度穩定性的影響。
分享友人
分享到 Line

分享到臉書