水力深降值 的英文怎麼說

中文拼音 [shuǐlìshēnjiàngzhí]
水力深降值 英文
hydraulic subsiding value
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 深 : Ⅰ形容詞1 （從上到下或從外到里的距離大） deep 2 （深奧） difficult; profound 3 （深刻; 深入） thor...
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  • 水力 : waterpower; hydraulic power水力剝離 [采礦工程] hydraulic stripping; strip with water; 水力采礦 hy...
  1. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  2. According to the documentation collected from domestic and abroad wang wei dong who works in huadong architect and structure institute utilizes the similar work property between the underground continuous wall and pile subjected the vertical loads, and introduces poulos method of elasticity and plastic which applies to pile foundation into the calculation for subsidence of underground continuous wall. pujialiu and yu yuzhou from water and electronic engineering of qinghua university, according to the result of three axes, define the concrete parameter utilize the model of non - linear e - b combined with the design cross section of dam in xiaolangdi, yellow river accept the total stress programme of thepd dam, and we analyze the stress and displacement of plastic concrete diaphragm wall by finite element method in comparison with the result of common concrete one. at same time, we consider the effect of the character of plastic concrete diaphragm wall which is composed of different gradients and adopting the level of stress and pulling stress infers whether the plastic concrete diaphragm wall is safe or not

    地下連續墻是一種歷史較短的施工方法，目前，砼防滲墻的設計還是以傳統的設計方法為主，根據查找國內外文獻資料，華東建築設計院王衛東利用地下連續墻與樁在豎向荷載作用下的工作性能有相似性，將適用於樁基的poulos彈性理論引入對地下連續墻的沉降計算中；清華大學水利水電工程系濮家騮、于玉貞根據三軸試驗結果確定混凝土的參數，利用非線性e - b模型，結合黃河小浪底土石壩設計剖面，採用thepd土石壩總應力程序，對深覆蓋層塑性混凝土防滲墻的應力、位移進行有限元分析，並與普通混凝土防滲墻計算結果加以對比，同時分析了不同配比塑性混凝土特性的影響，並採用應力水平和拉應力數值來判斷塑性混凝土防滲墻的安全程度。
  3. ( 2 ) the method of finite element discrete and optimal parameter back analysis is adopted. ( 3 ) concentrated on the question of high external water pressure of the deep - lying tunnel, the basic theory and method calculating external water pressure are systematically studied. ( 4 ) based on jinping cascade 2 hydropower station, numerical simulation rain infiltration of seepage field under different drainage pattern and grouting pattern are studied, also, the high external water pressure is analyzed and studied and some seepage control measures are put forward

    （ 2 ）採用有限元離散?優化法進行參數的反演分析； （ 3 ）針對深埋隧洞的高外水壓力問題，進一步分析和研究了襯砌水荷載及外水壓力的作用機理和計算方法； （ 4 ）以錦屏二級水電站深埋長引水隧洞作為本文的主要研究對象，採用考慮降雨入滲滲流場分析的方法對排水方案和灌漿封堵方案不同情況下的滲流場的水頭分佈進行了數值模擬，並對其外水壓力進行了分析和研究，提出了滲流控制的具體措施。
  4. Considering that the load was added in steps, dynamic design based on in - sile test parameter is an effective and practical method. based on the author ' s experience of djm composite ground engineering, and two projects of highway djm composite ground, it systemically analyzed and summarized the in - site test result as well as the settlement deformation, pore water pressure dissipation, deep horizontal displacement, stress ratio, stress of pile. etc. it also compares the in - site test results of djm composite ground with or without rigid bearing stratum, and draws many practical conclusions

    根據筆者多年粉噴樁加固路基工程的經驗，結合兩個高等級道路粉噴樁加固路基工程實例，全面系統地分析和總結了現場試驗路段試驗結果，對攪拌樁復合地基沉降特性、孔壓消散特性、深層水平位移特性、樁土應力比、樁身應變等作了深入細致地分析，對有硬持力層和無硬持力層（浮樁）的粉噴樁復合地基現場試驗結果作了對比，得到了許多有應用價值的結論。
  5. Based on the reality of zhangye oasis water resources utilization, and supported by the environmental economics theory, this paper is to research and analyze the agriculture water utilization in the oasis, including sunan, minle, shandan, zhangye, linze, gaotai sincel970s. to analyze the economic benefit of the unit provision output effected by the labor - flooding water volumes based on both the real collected data and the statistical data provided by the stat. dept in the past years ; the checking standard for output benefit is the unit provision out put the input parameters are water, fertilizer, power - supply and the cone - erned factors occurred during the agriculture production

    經過大量的實地考察，對甘肅的武威、張掖和酒泉三大綠洲的自然、經濟情況，尤其是農業生產情況和用水情況進行了深入的調查和研究，在獲取實際資料的基礎上，結合統計部門提供的歷年統計數據，以糧食單產為產出效益衡量標準，以農業生產涉及的灌溉水量、天然降水量、化肥農藥施用量、農業生產用電量、農業機械總動力以及自然災害情況等各相關因子為投入參數，利用sas 、 spss等統計分析軟體對數據進行處理和分析，分別採用實物量指標和價值量指標，分析人工灌溉水量這一投入要素，對糧食單產這一產出的總效益、邊際效益和平均效益。
分享友人
分享到 Line

分享到臉書